參數資料
型號: AK5370VF
廠商: Asahi Kasei Microsystems Co.,Ltd
英文描述: JT 6C 6#12 SKT GRND PLUG
中文描述: 我的USB /英格蘭/ D轉換器
文件頁數: 10/27頁
文件大?。?/td> 203K
代理商: AK5370VF
ASAHI KASEI
[AK5370]
MS0027-E-00
10
2000/05
n
Synchronization
The AK5370 operates as Asynchronous Device. A/D converter in the AK5370 operates asynchronously with USB SOF timing. The
data from A/D converter are sent continuously to a buffer memory while the data are burstly transferred at the interval of SOF on the
USB. In order to control the difference of timing, AK5370 has a FIFO memory with a capacity of 2-frame depth .The average sampling
rate calculating from USB frame should be in accordance with A/D sampling rate (fs).
The following figure shows an example. When sampling frequency is set to 44.1kHz, the number of data is almost 44 samples in one
frame. But the AK5370 must send 45 samples in once per ten times. Please see
Figure 7
.
44 samples
44 samples
45 samples
N Frame
(N+1) Frame
(N+9) Frame
44 samples
(N+10) Frame
Figure 7. Synchronization
The data sampled by A/D converter in N Frame are output to the USB bus on somewhere the (N+1) frame by issuing IN transfer.
n
Power Management Control
In the normal operation, MICBIAS outputs the voltage to supply the microphone’s bias voltage.
When idle state continues for 3ms, the AK5370 goes to suspend state and forces ADC block and other unnecessary block to power-down
mode. MICBIAS pin does not supply the bias voltage to save power consumption and is open state under suspend state.
The device resumes the normal operation within 30ms after the device receives resume signal
n
Feature Unit Control & Frequency Control
The AK5370 has three feature unit function; mute, volume, and AGC.
The host issues “SET_FEATURE_UNIT_CONTROL” request to change the volume, the status of mute or AGC. The AK5370 responds
to the request for CUR value only, not respond for MIN, MAX, RES value. Note that the AK5370 doesn’t have AGC circuit itself and
that it decodes AGC request only.
The host can get the CUR/MAX/MIN/RES value of the volume by requesting “GET_FEATURE_CONTROL”. However, only CUR
value is supported for mute and AGC.
Volume Control Format of USB Audio Class is a) 16-bit integer, b) upper-bye is integer (-127 to 127), and lower-bye is fraction.
The AK5370 follows the conversion table described in
Table 1
in page 22 for the volume control request
When the AK5370 receives “SET_ENDPOINT_CONTROL” request, it changes sampling frequency(fs). If fs is not supported, the
device forces to set the appropriate fs which it supports. The host can get fs by issuing “GET_ENDPOINT_CONTROL” request.
相關PDF資料
PDF描述
AK5371A 2ch A/D Converter with USB I/F
AK5371AVQ 2ch A/D Converter with USB I/F
AK5371 2CH A/D CONVERTER WITH USB I/F
AK5371VQ AB 5C 2#8 3#12 SKT WALL MT REC
AK5380 96kHz 24Bit ADC with Single - ended Input
相關代理商/技術參數
參數描述
AK5371 制造商:AKM 制造商全稱:AKM 功能描述:2CH A/D CONVERTER WITH USB I/F
AK5371A 制造商:AKM 制造商全稱:AKM 功能描述:2ch A/D Converter with USB I/F
AK5371AVQ 制造商:AKM 制造商全稱:AKM 功能描述:2ch A/D Converter with USB I/F
AK5371AVQP 功能描述:IC ADC STER W/USB 16BIT 48LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統(DAS) 分辨率(位):16 b 采樣率(每秒):21.94k 數據接口:MICROWIRE?,QSPI?,串行,SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP(6x6) 包裝:托盤
AK5371VQ 制造商:AKM 制造商全稱:AKM 功能描述:2CH A/D CONVERTER WITH USB I/F