
[AK4254] 
MS0586-E-01 
2007/08 
- 4 - 
No. 
Pin Name 
I/O 
Function 
Power-Down Mode Pin 
When at “L”, the AK4254 is in the power-down mode and held in reset, the AK4254 
must always be reset upon power-up in Serial Control Mode (P/S pin= “L”). 
Video Output #2 Pin. 
Negative Voltage Output Pin for Video Amplifier 2  
Connect to CVSS2 with a 1.0
μ
F capacitor that has the low ESR (
Equivalent Series 
Resistance
) over all temperature range. When this capacitor has the polarity, the 
positive polarity pin should be connected to the CVSS2 pin. Non-polarity capacitors can 
also be used.   
Charge Pump Ground Pin, 0V  
Connect to CVEE2 with a 1.0
μ
F capacitor that has the low ESR (
Equivalent Series 
Resistance
) over all temperature range. When this capacitor has the polarity, the 
positive polarity pin should be connected to the CVSS2 pin. Non-polarity capacitors can 
also be used.   
Negative Charge Pump Capacitor Terminal 2 Pin  
Connect to CP2 with a 1.0
μ
F capacitor that has the low ESR (
Equivalent Series 
Resistance
) over all temperature range. When this capacitor has the polarity, the 
positive polarity pin should be connected to the CP2 pin. Non polarity capacitors can 
also be used.   
Positive Charge Pump Capacitor Terminal 2 Pin  
Connect to CN2 with a 1.0
μ
F capacitor that has the low ESR (
Equivalent Series 
Resistance
) over all temperature range. When this capacitor has the polarity, the 
positive polarity pin should be connected to the CP2 pin. Non polarity capacitors can 
also be used.   
Charge Pump Power Supply Pin, 2.7V
~
3.6V 
Note: All digital input pins (CADO/SEL10, CADT/SEL11, CSN/SEL12, CCLK/SCL/SEL20, CDTI/SDA/SEL21, 
I2C/SEL22) must not be left floating. 
■
 Handling of Unused Pin 
The unused I/O pins should be processed appropriately as below. 
Classification 
Pin Name 
Analog  
VIN1-7 
Digital 
CSN/SEL12 
24 
PDN 
I 
25 
VOUT2 
O 
26 
CVEE2 
O 
27 
CVSS2 
- 
28 
CN2 
I 
29 
CP2 
O 
30 
CVDD2 
- 
Setting 
These pins should be open. 
These pins should be connected to AVDD or AVSS.