參數資料
型號: ADVHC32
廠商: Analog Devices, Inc.
英文描述: Voltage-to-Frequency and Frequency-to-Voltage Converter(電壓-頻率和頻率-電壓轉換器)
中文描述: 電壓的頻率和頻率至電壓轉換器(電壓-頻率和頻率-電壓轉換器)
文件頁數: 6/6頁
文件大?。?/td> 138K
代理商: ADVHC32
ADVFC32
–6–
REV. A
C
P
Figure 6. High Noise Immunity Data Link
fiber link, and the optocoupler provides common-mode isolation
up to 3000 V dc.
T he data link input voltage is changed in a frequency modulated
signal by the first ADVFC32. A 42.2 k
input resistor and a
100 k
offset resistor set the scaling so that a 0 V input signal
corresponds to 50 kHz, and a 10 V input results in the maxi-
mum output frequency of 500 kHz. A high frequency opto-
coupler is then used to transmit the signal across any common-
mode voltage potentials to the receiving ADVFC32. T he opto-
coupler is not necessary in systems where common-mode noise
is either very small or a constant low level dc voltage. In systems
where common-mode voltage may present a problem, the con-
nection between the two locations should be through the opto-
coupler; no power or ground connections need to be made.
T he output of the optocoupler drives an ADVFC32 hooked up
in the F/V configuration. Since the reconstructed signal at Pin
10 has a considerable amount of carrier feedthrough, it is desir-
able to filter out any frequencies in the carrier range of 50 kHz
to 500 kHz. T he frequency response of the F/V converter is only
3 kHz due to the pole made by the integrator, so a second 3 kHz
filter will not significantly limit the bandwidth. With the simple
one pole filter shown in Figure 6, the input to output 3 dB point
is approximately 2 kHz, and the output noise is less than
15 mV. If a lower output impedance drive is needed, a two pole
active filter is recommended as an output stage.
Although the F/V conversion technique used in this circuit is
quite simple, it is also very limited in terms of its frequency re-
sponse and output ripple. T he frequency response is limited by
the integrator time constant and while it is possible to decrease
that time constant, either signal range or output ripple must be
sacrificed. T he performance of the circuit of Figure 6 is shown
in the photograph below. T he top trace is the input signal, the
middle trace is the frequency-modulated signal at the
optocoupler’s output, and the bottom trace is the recovered
signal at the output of the F/V converter.
OUT LINE DIME NSIONS
Dimensions shown in inches and (mm).
14-Pin Plastic DIP Package
T O-100 Package
相關PDF資料
PDF描述
ADXL05AH Circular Connector; No. of Contacts:11; Series:LJTP02R; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:21; Circular Contact Gender:Socket; Circular Shell Style:Box Mount Receptacle
ADXL05JH Circular Connector; No. of Contacts:79; Series:LJTP02R; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:21; Circular Contact Gender:Pin; Circular Shell Style:Box Mount Receptacle; Insert Arrangement:21-35
ADXL05 Single Chip Accelerometer with Signal Conditioning(帶信號調節的單片加速計)
ADXL105* High Accuracy +1 g to +5 g Single Axis iMEMS Accelerometer with Analog Input
ADXL105AQC Circular Connector; No. of Contacts:128; Series:LJTP02R; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:25; Circular Contact Gender:Socket; Circular Shell Style:Box Mount Receptacle
相關代理商/技術參數
參數描述
A-DVI-1001-01-R 制造商:Assmann Electronics Inc 功能描述:CONN DVI-D MALE SLDR
A-DVI-1001-02-R 制造商:Assmann Electronics Inc 功能描述:CONN DVI MALE SLDR
A-DVI-1002-01-R 制造商:Assmann Electronics Inc 功能描述:CONN DVI MALE SLDR
A-DVI-1002-02-R 制造商:Assmann Electronics Inc 功能描述:CONN DVI MALE SLDR
A-DVI-1003-01-R 制造商:Assmann Electronics Inc 功能描述:DVI CONNECTOR 24+1 MALE, PIN TYPE, G/F, WHITE