參數資料
型號： ADS7864M-EVM
廠商： Texas Instruments
文件頁數： 3/27頁
文件大?。?/td> 0K
描述： EVAL MODULE FOR ADS7864M
產品培訓模塊： Data Converter Basics
標準包裝： 1
ADC 的數量： 2
位數： 12
采樣率（每秒）： 500k
數據接口： 并聯
輸入范圍： 0 ~ 5 V
在以下條件下的電源（標準）： 50mW @ 500kSPS
工作溫度： -40°C ~ 85°C
已用 IC / 零件： ADS7864
已供物品： 板
相關產品： ADS7864YB/2KG4-ND - IC 12BIT 500KHZ 6CH ADC 48-TQFP
ADS7864YB/250G4-ND - IC 12BIT 500KHZ 6CH ADC 48-TQFP
ADS7864Y/2KG4-ND - IC 12BIT 500KHZ 6CH ADC 48-TQFP
ADS7864Y/250G4-ND - IC 12BIT 500KHZ 6CH ADC 48-TQFP
ADS7864YDKR-ND - IC 12BIT 500KHZ 6CH A/D 48-TQFP
ADS7864YBDKR-ND - IC 12BIT 500KHZ 6CH A/D 48-TQFP
ADS7864YBCT-ND - IC 12BIT 500KHZ 6CH A/D 48-TQFP
ADS7864YBTR-ND - IC 12BIT 500KHZ 6CH A/D 48-TQFP
ADS7864YCT-ND - IC 12BIT 500KHZ 6CH A/D 48-TQFP
ADS7864YTR-ND - IC 12BIT 500KHZ 6CH A/D 48-TQFP
更多...
其它名稱： 296-30697
ADS7864M-EVM-ND
www.ti.com
APPLICATIONS INFORMATION
INTRODUCTION
REFERENCE
ANALOG INPUT
SAMPLE-AND-HOLD SECTION
ADS7864
SingleEnded Input
Common
Voltage
V
REF to +VREF
peaktopeak
Differential Input
Common
Voltage
V
REF
peaktopeak
V
REF
peaktopeak
ADS7864
SBAS141A – SEPTEMBER 2000 – REVISED MARCH 2005
signal, is 5ns. The average delta of repeated aperture
delay values is typically 50ps (also known as aperture
jitter). These specifications reflect the ability of the
ADS7864 to capture AC input signals accurately at
The ADS7864 is a high speed, low power, dual 12-bit
the exact same moment in time.
analog-to-digital converter (ADC) that operates from a
single +5V supply. The input channels are fully
differential with a typical common-mode rejection of
80dB. The part contains dual 2s successive approxi-
Under normal operation, the REFOUT pin (pin 2)
mation ADCs, six differential sample-and-hold ampli-
should be directly connected to the REFIN pin (pin 1)
fiers, an internal +2.5V reference with REFIN and
to provide an internal +2.5V reference to the
REFOUT pins and a high speed parallel interface.
ADS7864. The ADS7864 can operate, however, with
There are six analog inputs that are grouped into
an external reference in the range of 1.2V to 2.6V for
three channels (A, B and C). Each A/D converter has
a corresponding full-scale range of 2.4V to 5.2V.
three inputs (A0/A1, B0/B1 and C0/C1) that can be
The
internal
reference
of
the
ADS7864
is
sampled and converted simultaneously, thus pre-
double-buffered. If the internal reference is used to
serving the relative phase information of the signals
drive an external load, a buffer is provided between
on both analog inputs. Each pair of channels has a
the reference and the load applied to pin 33 (the
hold signal (HOLDA, HOLDB, HOLDC) to allow
internal reference can typically source 2mA of cur-
simultaneous sampling on all six channels. The part
rent—load capacitance should not exceed 100pF). If
accepts an analog input voltage in the range of –VREF
an external reference is used, the second buffer
to +VREF, centered around the internal +2.5V refer-
provides isolation between the external reference and
ence. The part will also accept bipolar input ranges
the CDAC. This buffer is also used to recharge all of
when a level shift circuit is used at the front end (see
the capacitors of both CDACs during conversion.
A conversion is initiated on the ADS7864 by bringing
the HOLDX pin low for a minimum of 15ns. HOLDX
The analog input is bipolar and fully differential. There
low places both sample-and-hold amplifiers of the X
are two general methods of driving the analog input
channels in the hold state simultaneously and the
of the ADS7864: single-ended or differential (see
conversion process is started on both channels. The
Figure 19 and Figure 20). When the input is
BUSY output will then go low and remain low for the
single-ended, the –IN input is held at the com-
duration of the conversion cycle. The data can be
mon-mode voltage. The +IN input swings around the
read from the parallel output bus following the con-
same common voltage and the peak-to-peak ampli-
version by bringing both RD and CS low.
tude
is
the
(common-mode
+VREF)
and
the
Conversion time for the ADS7864 is 1.75s when an
(common-mode –VREF). The value of VREF determines
8MHz external clock is used. The corresponding
the range over which the common-mode voltage may
acquisition time is 0.25s. To achieve maximum
vary (see Figure 21).
output rate (500kHz), the read function can be
performed during at the start of the next conversion.
NOTE: This mode of operation is described in more
detail in the Timing and Control section of this data
sheet.
The sample-and-hold amplifiers on the ADS7864
allow the ADCs to accurately convert an input sine
wave of full-scale amplitude to 12-bit accuracy. The
input bandwidth of the sample-and-hold is greater
than the Nyquist rate of the ADC (Nyquist equals
one-half of the sampling rate) even when the ADC is
operated at its maximum throughput rate of 500kHz.
The
typical
small-signal
bandwidth
of
the
sample-and-hold amplifiers is 40MHz.
Typical aperture delay time, or the time it takes for
Figure 19. Methods of Driving the ADS7864
the ADS7864 to switch from the sample to the hold
Single-Ended or Differential
mode following the negative edge of the HOLDX
11
相關PDF資料
PDF描述
GMM08DRTI-S13 CONN EDGECARD 16POS .156 EXTEND
DAC5674EVM EVAL MODULE FOR DAC5674
ELJ-PE5N6KF INDUCTOR 5.6NH 10% 0603 SMD
ECM15DSEN-S13 CONN EDGECARD 30POS .156 EXTEND
AP2280-1FMG-7 IC LOAD SW CTRL 1CH 6-DFN
相關代理商/技術參數
參數描述
ADS7864Y 制造商:Texas Instruments 功能描述:IC 12BITADC SMD 7864 TQFP48 制造商:Texas Instruments 功能描述:IC, 12BITADC, SMD, 7864, TQFP48 制造商:Texas Instruments 功能描述:IC, 12BITADC, SMD, 7864, TQFP48; Resolution (Bits):12bit; Sampling Rate:1MSPS; Supply Voltage Type:Single; Supply Voltage Min:4.75V; Supply Voltage Max:5.25V; Supply Current:10mA; Digital IC Case Style:TQFP; No. of Pins:48; Input ;RoHS Compliant: Yes
ADS7864Y 制造商:Texas Instruments 功能描述:IC 12BITADC SMD 7864 TQFP48
ADS7864Y/250 功能描述:模數轉換器 - ADC 500kHz 12-Bit 6-Ch Simltns Smplng ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
ADS7864Y/250G4 功能描述:模數轉換器 - ADC 500kHz 12-Bit 6-Ch Simltns Smplng ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
ADS7864Y/2K 功能描述:模數轉換器 - ADC 500kHz 12-Bit 6-Ch Simltns Smplng ADC RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*