- 您現在的位置：買賣IC網 > PDF目錄375263 > ADS1245IDGSR Low-Power, 24-Bit Analog-to-Digital Converter PDF資料下載
參數資料
| 型號： | ADS1245IDGSR |
| 英文描述： | Low-Power, 24-Bit Analog-to-Digital Converter |
| 中文描述： | 低功耗，24位模擬數字轉換器 |
| 文件頁數： | 14/19頁 |
| 文件大?。?/td> | 254K |
| 代理商： | ADS1245IDGSR |
"#$%&
SBAS287A JUNE 2003 REVISED SEPTEMBER 2003
www.ti.com
14
SINGLE CONVERSIONS
When only single conversions are needed, Sleep mode
can be used to start and stop the ADS1245. To make a
single conversion, first enter the Sleep Mode holding
SCLK high. Now, when ready to start the conversion, take
SCLK low. The ADS1245 will wake up and begin the
conversion. Wait for DRDY/DOUT to go low, and then
retrieve the data. Afterwards, take SCLK high to stop the
ADS1245 from converting and reenter Sleep mode.
Continue to hold SCLK high until ready to start the next
conversion. Operating in this fashion greatly reduces
power consumption since the ADS1245 is shut down while
idle between conversions. Selfcalibrations can be
performed prior to the start of the single conversions by
using the waveform shown in Figure 28.
SINGLE-SUPPLY OPERATION
It is possible to operate the ADS1245 with a single supply.
For a 3V supply, simply connect AVDD and DVDD
together. Figure 29 shows an example of the ADS1245
running on a single 5V supply. An external resistor, R
1
, is
used to drop 5V supply down to a desired voltage level of
DVDD. For example, if the desired DVDD supply voltage
is 3V and AVDD is 5V, the value of R
1
should be:
R
1
(5V
3V) 5 A
400k
where 5mA is a typical digital current consumption when
DVDD = 3V (refer to the typical characteristic
Digital
Current vs Digital Supply
). A buffer on DRDY/DOUT can
provide levelshifting if required.
DVDD can be set to a desired voltage by choosing a proper
value of R
1
, but keep in mind that DVDD must be set
between 1.8V and 3.6V. Note that the maximum logic high
output of DRDY/DOUT is equal to DVDD, but both CLK
and SCLK inputs can be driven with 5V logic regardless of
the DVDD or AVDD voltage. Use 0.1mF capacitors to
bypass both AVDD and DVDD.
10
9
8
7
6
1
2
3
4
5
CLK
SCLK
DRDY/DOUT
DVDD
AVDD
GND
VREFP
VREFN
AINN
AINP
ADS1245
R1
0.1
μ
F
+
+5V
to +5V logic
from
+5V logic
from
+5V logic
0.1
μ
F
+
SN74LVCC3245A
Figure 29. Example of the ADS1244 Running on a
Single 5V Supply
MULTI-CHANNEL SYSTEMS
Multiple ADS1245s can be operated in parallel to measure
multiple input signals. Figure 30 shows an example of a
two-channel system. For simplicity, the supplies and
reference circuitry were not included. The same CLK
signal should be applied to all devices. To be able to
synchronize the ADS1245s, connect the same SCLK
signal to all devices as well. When ready to synchronize,
place all the devices in Sleep mode. Afterwards, a wakeup
command will synchronize all the ADS1245s; that is, they
will sample the input signals simultaneously
The DRDY/DOUT outputs will go low at approximately the
same time after synchronization. The falling edges,
indicating that new data is ready, will vary with respect to
each other no more than timing specification t
14
. This
variation is due to possible differences in the ADS1245
internal calibration settings. To account for this when using
multiple devices, either wait for t
14
to pass after seeing one
device DRDY/DOUT go low, or wait until all DRDY/DOUTs
have gone low before retrieving data.
(1)
相關PDF資料 |
PDF描述 |
|---|---|
| ADS1245IDGST | Low-Power, 24-Bit Analog-to-Digital Converter |
| ADS1250 | 20-Bit Data Acquisition System ANALOG-TO-DIGITAL CONVERTER |
| ADS1250U | 20-Bit Data Acquisition System ANALOG-TO-DIGITAL CONVERTER |
| ADS1252 | 24-Bit, 40kHz ANALOG-TO-DIGITAL CONVERTER |
| ADS1252U | 24-Bit, 40kHz ANALOG-TO-DIGITAL CONVERTER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADS1245IDGSRG4 | 功能描述:模數轉換器 - ADC 24-bit Low-Power w/Hi-Z Input Buffer RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| ADS1245IDGST | 功能描述:模數轉換器 - ADC 24-bit Low-Power w/Hi-Z Input Buffer RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| ADS1245IDGST | 制造商:Texas Instruments 功能描述:IC 24-BIT ADC HIGH-Z I/P BUFFER |
| ADS1245IDGSTG4 | 功能描述:模數轉換器 - ADC 24-bit Low-Power w/Hi-Z Input Buffer RoHS:否 制造商:Texas Instruments 通道數量:2 結構:Sigma-Delta 轉換速率:125 SPs to 8 KSPs 分辨率:24 bit 輸入類型:Differential 信噪比:107 dB 接口類型:SPI 工作電源電壓:1.7 V to 3.6 V, 2.7 V to 5.25 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:VQFN-32 |
| ADS1246 | 制造商:TI 制造商全稱:Texas Instruments 功能描述:24-Bit Analog-to-Digital Converters for Temperature Sensors |
發布緊急采購，3分鐘左右您將得到回復。