• 參數資料
    型號: ADM1485JRZ-REEL
    廠商: Analog Devices Inc
    文件頁數: 1/11頁
    文件大?。?/td> 0K
    描述: IC TXRX RS-485 5V HS 8SOIC
    產品培訓模塊: Power Line Monitoring
    標準包裝: 2,500
    類型: 收發器
    驅動器/接收器數: 1/1
    規程: RS485
    電源電壓: 4.75 V ~ 5.25 V
    安裝類型: 表面貼裝
    封裝/外殼: 8-SOIC(0.154",3.90mm 寬)
    供應商設備封裝: 8-SO
    包裝: 帶卷 (TR)
    REV.
    ADM1485
    5 V Low Power
    EIA RS-485 Transceiver
    One Technology Way, P.O. Box 9106, Norwood, MA 02062-9106, U.S.A.
    Tel: 781/329-4700
    www.analog.com
    Fax:
    Analog Devices, Inc. All rights reserved.
    Information furnished by Analog Devices is believed to be accurate and
    reliable. However, no responsibility is assumed by Analog Devices for its
    use, nor for any infringements of patents or other rights of third parties that
    may result from its use. No license is granted by implication or otherwise
    under any patent or patent rights of Analog Devices. Trademarks and
    registered trademarks are the property of their respective owners.
    FUNCTIONAL BLOCK DIAGRAM
    8-Lead
    ADM1485
    R
    D
    RO
    RE
    DI
    VCC
    B
    A
    GND
    DE
    FEATURES
    Meets EIA RS-485 Standard
    30 Mbps Data Rate
    Single 5 V Supply
    –7 V to +12 V Bus Common-Mode Range
    High Speed, Low Power BiCMOS
    Thermal Shutdown Protection
    Short-Circuit Protection
    Driver Propagation Delay: 10 ns
    Receiver Propagation Delay: 15 ns
    High-Z Outputs with Power Off
    Superior Upgrade for LTC1485
    APPLICATIONS
    Low Power RS-485 Systems
    DTE-DCE Interface
    Packet Switching
    Local Area Networks
    Data Concentration
    Data Multiplexers
    Integrated Services Digital Network (ISDN)
    GENERAL DESCRIPTION
    The ADM1485 is a differential line transceiver suitable for high
    speed bidirectional data communication on multipoint bus trans-
    mission lines. It is designed for balanced data transmission and
    complies with both RS-485 and RS-422 EIA Standards. The part
    contains a differential line driver and a differential line receiver.
    Both the driver and the receiver may be enabled independently.
    When disabled, the outputs are three-stated.
    The ADM1485 operates from a single 5 V power supply. Excessive
    power dissipation caused by bus contention or by output shorting
    is prevented by a thermal shutdown circuit. This feature forces
    the driver output into a high impedance state if, during fault condi-
    tions, a significant temperature increase is detected in the internal
    driver circuitry.
    Up to 32 transceivers may be connected simultaneously on a bus,
    but only one driver should be enabled at any time. It is important,
    therefore, that the remaining disabled drivers do not load the bus.
    To ensure this, the ADM1485 driver features high output
    impedance when disabled and also when powered down.
    This minimizes the loading effect when the transceiver is not being
    used. The high impedance driver output is maintained over the
    entire common-mode voltage range from –7 V to +12 V.
    The receiver contains a fail-safe feature that results in a logic
    high output state if the inputs are unconnected (floating).
    The ADM1485 is fabricated on BiCMOS, an advanced mixed
    technology process combining low power CMOS with fast
    switching bipolar technology. All inputs and outputs contain
    protection against ESD; all driver outputs feature high source
    and sink current capability. An epitaxial layer is used to guard
    against latch-up.
    The part is fully specified over the commercial and industrial
    temperature range and is available in PDIP, SOIC, and small
    MSOP packages.
    2012
    781/461-3113
    The ADM1485 features extremely fast switching speeds. Minimal
    driver propagation delays permit transmission at typical data rates
    of 30 Mbps while low skew minimizes EMI interference.
    相關PDF資料
    PDF描述
    VE-214-MY CONVERTER MOD DC/DC 48V 50W
    MS27499E18B32PD CONN RCPT 32POS BOX MNT W/PINS
    MS27499E18B32PB CONN RCPT 32POS BOX MNT W/PINS
    MS3106F18-11P CONN PLUG 5POS STRAIGHT W/PINS
    VI-2N1-CU-F4 CONVERTER MOD DC/DC 12V 200W
    相關代理商/技術參數
    參數描述
    ADM1485JRZ-REEL7 制造商:Analog Devices 功能描述:
    ADM1486 制造商:AD 制造商全稱:Analog Devices 功能描述:+5 V Low Power RS-485 PROFIBUS Transceiver
    ADM1486_05 制造商:AD 制造商全稱:Analog Devices 功能描述:5 V, 0.8 mA PROFIBUS RS-485 Transceiver
    ADM1486AN 制造商:AD 制造商全稱:Analog Devices 功能描述:+5 V Low Power RS-485 PROFIBUS Transceiver
    ADM1486AQ 制造商:AD 制造商全稱:Analog Devices 功能描述:+5 V Low Power RS-485 PROFIBUS Transceiver