參數資料
型號: ADM1070
廠商: Analog Devices, Inc.
元件分類: 基準電壓源/電流源
英文描述: -48 V Hot Swap Controller
中文描述: -48 V熱風熱插拔控制器
文件頁數: 4/16頁
文件大?。?/td> 367K
代理商: ADM1070
REV. 0
–4–
ADM1070
PIN CONFIGURATION
(Not to Scale)
6
5
4
SENSE
V
IN
GATE
UV/OV
TIMER
ADM1070ART
1
2
3
V
EE
PIN FUNCTION DESCRIPTION
Pin No.
Mnemonic
Function
1
SENSE
Connection to External FET Source Voltage. A sense resistor is connected in the supply path
between the SENSE Pin and V
EE
, and the voltage across this resistor is monitored to detect current
faults. This voltage is fed as an input to the linear current regulator. When it reaches 100 mV for
a specified period, t
ON
, the regulator reduces the gate voltage and drives the FET as a linear pass
device. If current monitoring is not required, this feature can be turned off by shorting the
SENSE Pin and V
EE
together.
Device Negative Supply Voltage. This pin should be connected to the lower potential of the
power supply.
Shunt Regulated On-Chip Supply, Nominally V
EE
+ 12.3 V. This pin should be current fed
through a dropper resistor that is connected to the higher potential of the power supply inputs.
Allows User Control over Timing Functions by Determining Frequency of Oscillator. Fre-
quency set by connecting external capacitor to V
EE
. Tying pin directly to V
EE
causes oscillator to
default to internally set value.
Input Pin for Overvoltage and Undervoltage Detection Circuitry. The voltage appearing on the
UV/OV Pin is proportional to board supply and is determined by external resistors. When the
voltage on UV/OV falls below the undervoltage threshold of 0.86 V, the GATE Pin is driven low.
When the voltage appearing at the UV/OV Pin rises above the overvoltage threshold of 1.97 V,
the GATE Pin is also driven low. If the external resistor ratio of R1/R2 = 40 is used, then this
gives an operating range of –36 V to –77 V.
Output to External FET Gate Drive. Controlled by linear current regulator. The gate is driven
low if an overvoltage or undervoltage fault occurs or if a current fault lasts for longer than the
time, t
ON
. When in linear regulation, the GATE Pin voltage is controlled as part of the servo loop.
No external compensation is required. When the FET is fully enhanced and the load capacitance
has been charged, the GATE Pin reaches a high level of typically 12 V.
2
V
EE
3
V
IN
4
TIMER
5
UV/OV
6
GATE
相關PDF資料
PDF描述
ADM1070ART -48 V Hot Swap Controller
ADM1072ARQ Dual, USB 2.0 Full/Standby Power Controller with Supply Steering
ADM1085 Simple Sequencers in 6-Lead SC70
ADM1085AKS-REEL7 Simple Sequencers in 6-Lead SC70
ADM1086 Simple Sequencers in 6-Lead SC70
相關代理商/技術參數
參數描述
ADM1070ART 制造商:AD 制造商全稱:Analog Devices 功能描述:-48 V Hot Swap Controller
ADM1070ART-REEL 制造商:Analog Devices 功能描述:Hot Swap Controller 1-CH -80V 6-Pin SOT-23 T/R 制造商:Analog Devices 功能描述:6-PIN -48V HOT SWAP CONTROLLER I.C. - Tape and Reel 制造商:Rochester Electronics LLC 功能描述:6-PIN -48V HOT SWAP CONTROLLER I.C. - Tape and Reel
ADM1070ART-REEL7 功能描述:IC CTRL HOTSWAP -48 SOT23-6 RoHS:否 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統,AdvancedTCA ? 系統,高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬) 供應商設備封裝:10-MSOP 包裝:管件
ADM1070ARTZ-REEL 功能描述:IC CTRLR HOTSWAP -48V SOT23-6 RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統,AdvancedTCA ? 系統,高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬) 供應商設備封裝:10-MSOP 包裝:管件
ADM1070ARTZ-REEL7 功能描述:IC CTRLR HOTSWAP -48V SOT23-6 RoHS:是 類別:集成電路 (IC) >> PMIC - 熱交換 系列:- 標準包裝:50 系列:- 類型:熱交換控制器 應用:-48V 遠程電力系統,AdvancedTCA ? 系統,高可用性 內部開關:無 電流限制:可調 電源電壓:11.5 V ~ 14.5 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬) 供應商設備封裝:10-MSOP 包裝:管件