- 您現在的位置：買賣IC網 > PDF目錄375254 > ADF7012BRU-REEL7 (ANALOG DEVICES INC) Multichannel ISM Band FSK/GFSK/OOK/GOOK/ASK Transmitter PDF資料下載
參數資料
| 型號： | ADF7012BRU-REEL7 |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 通信及網絡 |
| 英文描述： | Multichannel ISM Band FSK/GFSK/OOK/GOOK/ASK Transmitter |
| 中文描述： | SPECIALTY TELECOM CIRCUIT, PDSO24 |
| 封裝： | MO-153AD, TSSOP-24 |
| 文件頁數： | 7/28頁 |
| 文件大小： | 772K |
| 代理商： | ADF7012BRU-REEL7 |
第1頁第2頁第3頁第4頁第5頁第6頁當前第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
ADF7012
PIN CONFIGURATION AND FUNCTION DESCRIPTIONS
Rev. 0 | Page 7 of 28
ADF7012
TOP VIEW
(Not to Scale)
DV
DD
C
REG1
CP
OUT
TxDATA
1
2
3
4
TxCLK
5
C
REG2
R
SET
AGND
DV
DD
RF
OUT
RF
GND
VCO
IN
C
VCO
L2
24
23
22
21
20
MUXOUT
6
DGND
7
OSC1
8
OSC2
9
19
18
17
16
CLK
OUT
CLK
11
10
L1
CE
15
14
DATA
12
LE
TSSOP
13
0
Figure 3.
Table 4. Pin Functional Descriptions
Pin No.
Mnemonic
1
DV
DD
Description
Positive Supply for the Digital Circuitry. This must be between 2.3 V and 3.6 V. Decoupling capacitors to the analog
ground plane should be placed as close as possible to this pin.
A 2.2 μF capacitor should be added at C
REG
to reduce regulator noise and improve stability. A reduced capacitor
improves regulator power-on time, but may cause higher spurious noise.
Charge Pump Output. This output generates current pulses that are integrated in the loop filter. The integrated
current changes the control voltage on the input to the VCO.
Digital Data to Be Transmitted is inputted on this pin.
GFSK and GOOK only. This clock output is used to synchronize microcontroller data to the TxDATA pin of the
ADF7012. The clock is provided at the same frequency as the data rate. The microcontroller updates TxDATA on
the falling edge of TxCLK. The rising edge of TxCLK is used to sample TxDATA at the midpoint of each bit.
Provides the Lock_Detect Signal. This determines if the PLL is locked to the correct frequency and also monitors
battery voltage. Other signals include Regulator_Ready, which indicates the status of the serial interface regulator.
Ground for Digital Section.
The reference crystal should be connected between this pin and OSC2.
The reference crystal should be connected between this pin and OSC1. A TCXO reference may be used, by driving
this pin with CMOS levels, and powering down the crystal oscillator bit in software.
A divided-down version of the crystal reference with output driver. The digital clock output may be used to drive
several other CMOS inputs, such as a microcontroller clock. The output has a 50:50 mark-space ratio.
Serial Clock Input. This serial clock is used to clock in the serial data to the registers. The data is latched into the
32-bit shift register on the CLK rising edge. This input is a high impedance CMOS input.
Serial Data Input. The serial data is loaded MSB first with the two LSBs being the control bits. This is a high
impedance CMOS input.
Load Enable, CMOS Input. When LE goes high, the data stored in the shift registers is loaded into one of the four
latches, the latch being selected using the control bits.
Chip Enable. Bringing CE low puts the ADF7012 into complete power-down, drawing < 1uA. Register values are
lost when CE is low and the part must be reprogrammed once CE is brought high.
Connected to external printed or discrete inductor. See Choosing the External Inductor Value for advice on the
value of the inductor to be connected between L1 and L2.
Connected to external printed or discrete inductor.
A 220 nF capacitor should be tied between the C
VCO
and C
REG2
pins. This line should run underneath the ADF7012.
This capacitor is necessary to ensure stable VCO operation.
The tuning voltage on this pin determines the output frequency of the voltage controlled oscillator (VCO). The
higher the tuning voltage, the higher the output frequency.
Ground for Output Stage of Transmitter.
The modulated signal is available at this pin. Output power levels are from –16 dBm to +12 dBm. The output
should be impedance matched using suitable components to the desired load. See the PA Matching section.
Voltage supply for VCO and PA section. This should have the same supply as DV
DD
Pin 1, and should be between
2.3 V and 3.6 V. Place decoupling capacitors to the analog ground plane as close as possible to this pin.
Ground Pin for the RF Analog Circuitry.
External Resistor to set charge pump current and some internal bias currents. Use 3.6 kV as default.
Add a 470 nF capacitor at C
REG
to reduce regulator noise and improve stability. A reduced capacitor improves
regulator power-on time and phase noise, but may have stability issues over the supply and temperature.
2
C
REG1
3
CP
OUT
4
5
TxDATA
TxCLK
6
MUXOUT
7
8
9
DGND
OSC1
OSC2
10
CLK
OUT
11
CLK
12
DATA
13
LE
14
CE
15
L1
16
17
L2
C
VCO
18
VCO
IN
RF
GND
RF
OUT
19
20
21
DV
DD
22
23
24
AGND
R
SET
C
REG2
相關PDF資料 |
PDF描述 |
|---|---|
| ADF7901 | High Performance ISM Band ASK/FSK Transmitter IC |
| ADF7901BRU | High Performance ISM Band ASK/FSK Transmitter IC |
| ADG1408 | 5з ヌax Ron, 4-/8-Channel 【15V/12V/【5V Multiplexers |
| ADG1409 | 5з ヌax Ron, 4-/8-Channel 【15V/12V/【5V Multiplexers |
| ADG201ABQ | Circular Connector; MIL SPEC:MIL-DTL-38999 Series I; Body Material:Metal; Series:LJT; No. of Contacts:6; Connector Shell Size:17; Connecting Termination:Crimp; Circular Shell Style:Straight Plug; Body Style:Straight RoHS Compliant: No |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADF7012BRUZ | 功能描述:IC XMITTER ASK/FSK/GFSK 24TSSOP RoHS:是 類別:RF/IF 和 RFID >> RF 發射器 系列:- 標準包裝:4,000 系列:- 頻率:310MHz ~ 440MHz 應用:- 調制或協議:UHF，ASK 數據傳輸率 - 最大:20 kBaud 功率 - 輸出:1dBm ~ 5dBm 電流 - 傳輸:10mA 數據接口:PCB，表面貼裝 天線連接器:PCB，表面貼裝 存儲容量:- 特點:- 電源電壓:2.2 V ~ 4 V 工作溫度:-40°C ~ 85°C 封裝/外殼:16-LSSOP（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
| ADF7012BRUZ-RL | 功能描述:IC XMITTER ASK/FSK/GFSK 24TSSOP RoHS:是 類別:RF/IF 和 RFID >> RF 發射器 系列:- 標準包裝:4,000 系列:- 頻率:310MHz ~ 440MHz 應用:- 調制或協議:UHF，ASK 數據傳輸率 - 最大:20 kBaud 功率 - 輸出:1dBm ~ 5dBm 電流 - 傳輸:10mA 數據接口:PCB，表面貼裝 天線連接器:PCB，表面貼裝 存儲容量:- 特點:- 電源電壓:2.2 V ~ 4 V 工作溫度:-40°C ~ 85°C 封裝/外殼:16-LSSOP（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
| ADF7012BRUZ-RL7 | 功能描述:IC XMITTER ASK/FSK/GFSK 24TSSOP RoHS:是 類別:RF/IF 和 RFID >> RF 發射器 系列:- 標準包裝:4,000 系列:- 頻率:310MHz ~ 440MHz 應用:- 調制或協議:UHF，ASK 數據傳輸率 - 最大:20 kBaud 功率 - 輸出:1dBm ~ 5dBm 電流 - 傳輸:10mA 數據接口:PCB，表面貼裝 天線連接器:PCB，表面貼裝 存儲容量:- 特點:- 電源電壓:2.2 V ~ 4 V 工作溫度:-40°C ~ 85°C 封裝/外殼:16-LSSOP（0.154"，3.90mm 寬） 包裝:帶卷 (TR) |
| ADF7020 | 制造商:AD 制造商全稱:Analog Devices 功能描述:High Performance ISM Band FSK/ASK Transceiver IC |
| ADF7020-1 | 制造商:AD 制造商全稱:Analog Devices 功能描述:High Performance FSK/ASK Transceiver IC |
發布緊急采購，3分鐘左右您將得到回復。