- 您現在的位置：買賣IC網 > PDF目錄1989 > ADF4193BCPZ-RL7 (Analog Devices Inc)IC PLL FREQ SYNTHESIZER 32LFCSP PDF資料下載
參數資料
| 型號： | ADF4193BCPZ-RL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 5/32頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC PLL FREQ SYNTHESIZER 32LFCSP |
| 標準包裝： | 1,500 |
| 類型： | 時鐘/頻率合成器，RF |
| PLL： | 是 |
| 輸入： | CMOS，TTL |
| 輸出： | 時鐘 |
| 電路數： | 1 |
| 比率 - 輸入:輸出： | 2:1 |
| 差分 - 輸入:輸出： | 是/無 |
| 頻率 - 最大： | 3.5GHz |
| 除法器/乘法器： | 是/是 |
| 電源電壓： | 2.7 V ~ 3.3 V |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-VFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 32-LFCSP-VQ（5x5） |
| 包裝： | 帶卷 (TR) |
| 配用： | EVAL-ADF4193EBZ2-ND - BOARD EVALUATION EB2 FOR ADF4193 EVAL-ADF4193EBZ1-ND - BOARD EVALUATION EB1 FOR ADF4193 |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
Data Sheet
ADF4193
Rev. F | Page 13 of 32
Differential Amplifier
The internal, low noise, differential-to-single-ended amplifier is
used to convert the differential charge pump output to a single-
ended control voltage for the tuning port of the VCO. Figure 26
shows a simplified schematic of the differential amplifier. The
output voltage is equal to the differential voltage, offset by the
voltage on the CMR pin, according to
VAOUT = (VAIN+ VAIN) + VCMR
The CMR offset voltage is internally biased to three-fifths of
VP3, the differential amplifier power supply voltage, as shown in
Figure 26. Connect a 0.1 F capacitor to ground to the CMR pin
to roll off the thermal noise of the biasing resistors.
As can be seen in Figure 15, the differential amplifier output
voltage behaves according to the previous equation over a 4 V
range from approximately 1.2 V minimum up to VP3 0.3 V.
However, fast settling is guaranteed only over a tuning voltage
range from 1.8 V up to VP3 0.8 V. This is to allow sufficient
room for overshoot in the PLL frequency settling transient.
Noise from the differential amplifier is suppressed inside the
PLL bandwidth. For loop bandwidths >20 kHz, the 1/f noise has
a negligible effect on the PLL output phase noise. Outside the
loop bandwidth, the differential amplifier’s noise FM modulates
the VCO. The passive filter network following the differential
amplifier, shown in Figure 36, suppresses this noise contribution
to below the VCO noise from offsets of 400 kHz and above.
This network has a negligible effect on lock time because it is
bypassed when SW3 is closed while the loop is locking.
05328-
020
AIN–
AOUT
AIN+
CMR
VP3
C EXT =
0.1F
20k
30k
500
Figure 26. Differential Amplifier Block Diagram
MUXOUT and Lock Detect
The output multiplexer on the ADF4193 allows the user to
access various internal points on the chip. The state of MUXOUT
is controlled by M4 to M1 in the MUX register. Figure 35 shows
block diagram form.
05328-
021
R DIVIDER OUTPUT
N DIVIDER OUTPUT
SERIAL DATA OUTPUT
DGND
DVDD
CONTROL
MUX
MUXOUT
LOGIC LOW
THREE-STATE OUTPUT
TIMER OUTPUTS
DIGITAL LOCK DETECT
LOGIC HIGH
NOTE:
NOT ALL MUXOUT MODES SHOWN REFER TO MUX REGISTER
Figure 27. MUXOUT Circuit
Lock Detect
MUXOUT can be programmed to provide a digital lock detect
signal. Digital lock detect is active high. Its output goes high if
there are 40 successive PFD cycles with an input error of less
than 3 ns. For reliable lock detect operation with RF frequencies
<2 GHz, it is recommended that this threshold be increased to
10 ns by programming Register R6. The digital lock detect goes
low again when a new channel is programmed or when the
error at the PFD input exceeds 30 ns for one or more cycles.
Input Shift Register
The ADF4193 serial interface section includes a 24-bit input
shift register. Data is clocked in MSB first on each rising edge
of CLK. Data from the shift register is latched into one of eight
control registers, R0 to R7, on the rising edge of latch enable
(LE). The destination register is determined by the state of
the three control bits (Control Bit C3, Control Bit C2, and
Control Bit C1) in the shift register. The three LSBs are Bit DB2,
Bit DB1, and Bit DB0, as shown in the timing diagram of Figure 2.
The truth table for these bits is shown in Table 5. Figure 28
shows a summary of how the registers are programmed.
Table 5. C3, C2, and C1 Truth Table
Control Bits
C3
C2
C1
Name
Register
0
FRAC/INT
R0
0
1
MOD/R
R1
0
1
0
Phase
R2
0
1
Function
R3
1
0
Charge Pump
R4
1
0
1
Power-Down
R5
1
0
Mux
R6
1
Test Mode
R7
相關PDF資料 |
PDF描述 |
|---|---|
| ADF4206BRUZ-RL | IC PLL FREQ SYNTHESIZER 16TSSOP |
| ADF4212LBRUZ | IC PLL FREQ SYNTHESIZER 20TSSOP |
| ADF4213BCPZ-RL | IC PLL FREQ SYNTHESIZER 20LFCSP |
| ADF4216BRUZ-RL | IC PLL FREQ SYNTHESIZER 20TSSOP |
| ADF4218LBRUZ | IC PLL FREQ SYNTHESIZER 20TSSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADF4193SP1BCPZ | 制造商:Analog Devices 功能描述: |
| ADF4193SP1BCPZ-RL7 | 制造商:Analog Devices 功能描述: |
| ADF4193SP2BCPZ-RL7 | 制造商:Analog Devices 功能描述: |
| ADF4193WCCPZ-RL7 | 功能描述:IC PLL FREQ SYNTHESIZER 32LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:2,000 系列:- 類型:PLL 時鐘發生器 PLL:帶旁路 輸入:LVCMOS，LVPECL 輸出:LVCMOS 電路數:1 比率 - 輸入:輸出:2:11 差分 - 輸入:輸出:是/無 頻率 - 最大:240MHz 除法器/乘法器:是/無 電源電壓:3.135 V ~ 3.465 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:32-LQFP 供應商設備封裝:32-TQFP（7x7） 包裝:帶卷 (TR) |
| ADF4196 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Low Phase Noise, Fast Settling, 6 GHz |
發布緊急采購，3分鐘左右您將得到回復。