參數資料
型號： ADF4154BCP-REEL
廠商： ANALOG DEVICES INC
元件分類： XO, clock
英文描述： Fractional-N Frequency Synthesizer
中文描述： PLL FREQUENCY SYNTHESIZER, 4000 MHz, QCC20
封裝： 4 X 4 MM, MO-220VGGD-1, LFCSP-20
文件頁數： 16/20頁
文件大?。?/td> 470K
代理商： ADF4154BCP-REEL
ADF4154
RF Charge Pump Three-State
This bit puts the charge pump into three-state mode when
programmed to 1. It should be set to 0 for normal operation.
RF Power-Down
DB4 on the ADF4154 provides the programmable power-down
mode. Setting Bit DB4 to 1 powers down the device. Setting
Bit DB4 to 0 returns the synthesizer to normal operation. While
in software power-down mode, the part retains all information
in its registers. Only when supplies are removed are the register
contents lost.
When a power-down is activated, the following events occur:
1.
All active dc current paths are removed.
Rev. 0 | Page 16 of 20
2.
The synthesizer counters are forced to their load
state conditions.
3.
The charge pump is forced into three-state mode.
4.
The digital lock detect circuitry is reset.
5.
The RF
IN
input is de-biased.
6.
The input register remains active and capable of loading
and latching data.
Lock Detect Precision (LDP)
When the LDP bit is programmed to 0, 24 consecutive reference
cycles of 15 ns must occur before the digital lock detect is set.
When this bit is programmed to 1, 40 consecutive reference
cycles of 15 ns must occur before digital lock detect is set.
Phase Detector Polarity
DB6 in the ADF4154 sets the phase detector polarity. When the
VCO characteristics are positive, this should be set to 1. When
they are negative, it should be set to 0.
Charge Pump Current Setting
DB7, DB8, DB9, and DB10 set the charge pump current, which
should be set according to the loop filter design (see Table 10).
REF
IN
Doubler
Setting the REF
IN
bit to 0 feeds the REF
IN
signal directly to the
4-bit RF R counter, which disables the doubler. Setting the REF
IN
bit to 1 multiplies the REF
IN
frequency by a factor of 2 before
feeding into the 4-bit R counter. When the doubler is disabled,
the REF
IN
falling edge is the active edge at the PFD input to the
fractional synthesizer. When the doubler is enabled, both the
rising and falling edges of REF
IN
become active edges at the
PFD input.
When the doubler is enabled and the lowest spur mode is
chosen, the in-band phase noise performance is sensitive to the
REF
IN
duty cycle. The phase noise degradation can be as much
as 5 dB for the REF
IN
duty cycles outside a 45% to 55% range.
The phase noise is insensitive to the REF
IN
duty cycle in the
lowest noise mode and in the lowest noise and spur mode. The
phase noise is insensitive to the REF
IN
duty cycle when the
doubler is disabled.
NOISE AND SPUR REGISTER, R3
The on-chip noise and spur register is programmed by setting
R3[1, 0] to [1, 1]. Table 7 shows the input data format for
programming this register.
Noise and Spur Mode
Noise and spur mode allows the user to optimize a design either
for improved spurious performance or for improved phase
noise performance. When the lowest spur setting is chosen,
dither is enabled. This randomizes the fractional quantization
noise so that it looks more like white noise rather than spurious
noise. This means that the part is optimized for improved
spurious performance. This operation would normally be used
when the PLL closed-loop bandwidth is wide for fast-locking
applications. A wide-loop bandwidth is seen as a loop
bandwidth greater than 1/10 of the RF
OUT
channel step
resolution (f
RES
). A wide-loop filter does not attenuate the spurs
to a level that a narrow-loop bandwidth would. When the low
noise and spur setting is enabled, dither is disabled. This
optimizes the synthesizer to operate with improved noise
performance. However, the spurious performance is degraded
in this mode compared to the lowest spurs setting. To further
improve noise performance, the lowest noise setting option can
be used, which reduces the phase noise. As well as disabling the
dither, it ensures that the charge pump operates in an optimum
region for noise performance. This setting is extremely useful
where a narrow-loop filter bandwidth is available. The
synthesizer ensures extremely low noise and the filter attenuates
the spurs. The typical performance characteristics give the user
an idea of the trade-off in a typical WCDMA setup for the
different noise and spur settings.
RESERVED BITS
These bits should be set to 0 for normal operation.
RF SYNTHESIZER: A WORKED EXAMPLE
This equation governs how the synthesizer should be
programmed.
RF
OUT
= [
INT
+ (
FRAC/MOD
)] × [
F
PFD
]
where:
RF
OUT
is the RF frequency output.
INT
is the integer division factor.
FRAC
is the fractionality.
MOD
is the modulus.
F
PFD
= [
REF
IN
× (1 =
D)/R
]
where:
REF
IN
is the reference frequency input.
D
is the RF REF
IN
doubler bit.
R
is the RF reference division factor.
(3)
(4)
相關PDF資料
PDF描述
ADF4154BCP-REEL7 Fractional-N Frequency Synthesizer
ADF4154BRU Fractional-N Frequency Synthesizer
ADF4154BRU-REEL Fractional-N Frequency Synthesizer
ADF4154BRU-REEL7 Fractional-N Frequency Synthesizer
ADF4193 Low Phase Noise, Fast Settling PLL Frequency Synthesizer
相關代理商/技術參數
參數描述
ADF4154BCP-REEL7 制造商:Analog Devices 功能描述:PLL Frequency Synthesizer Single 20-Pin LFCSP EP T/R
ADF4154BCPZ 功能描述:IC FRACTION-N FREQ SYNTH 20LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML，PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤，16-MLF? 供應商設備封裝:16-MLF?（3x3） 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND
ADF4154BCPZ-RL 功能描述:IC FRACTION-N FREQ SYNTH 20LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML，PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤，16-MLF? 供應商設備封裝:16-MLF?（3x3） 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND
ADF4154BCPZ-RL7 功能描述:IC FRACTION-N FREQ SYNTH 20LFCSP RoHS:是 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML，PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤，16-MLF? 供應商設備封裝:16-MLF?（3x3） 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND
ADF4154BRU 功能描述:IC FRAC-N FREQ SYNTH 16-TSSOP RoHS:否 類別:集成電路 (IC) >> 時鐘/計時 - 時鐘發生器，PLL，頻率合成器 系列:- 標準包裝:1,000 系列:Precision Edge® 類型:時鐘/頻率合成器 PLL:無 輸入:CML，PECL 輸出:CML 電路數:1 比率 - 輸入:輸出:2:1 差分 - 輸入:輸出:是/是 頻率 - 最大:10.7GHz 除法器/乘法器:無/無 電源電壓:2.375 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VFQFN 裸露焊盤，16-MLF? 供應商設備封裝:16-MLF?（3x3） 包裝:帶卷 (TR) 其它名稱:SY58052UMGTRSY58052UMGTR-ND
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*