- 您現在的位置：買賣IC網 > PDF目錄2064 > ADCMP566BCPZ (Analog Devices Inc)IC COMP DUAL ULTRA-FAST 32LFCSP PDF資料下載
參數資料
| 型號： | ADCMP566BCPZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 2/16頁 |
| 文件大小： | 0K |
| 描述： | IC COMP DUAL ULTRA-FAST 32LFCSP |
| 標準包裝： | 1 |
| 類型： | 帶鎖銷 |
| 元件數： | 2 |
| 輸出類型： | 補充型，差分，ECL，開路發射極 |
| 電壓 - 電源，單路/雙路(±)： | ±4.75 V ~ 5.25 V |
| 電壓 - 輸入偏移（最小值）： | 5mV @ -5.2V，5V |
| 電流 - 輸入偏壓（最小值）： | 42µA @ -5.2V，5V |
| 電流 - 輸出（標準）： | 30mA |
| 電流 - 靜態（最大值）： | 18mA，85mA |
| CMRR, PSRR（標準）： | 69dB CMRR |
| 傳輸延遲（最大）： | 0.29ns |
| 磁滯： | ±1mV |
| 工作溫度： | -40°C ~ 85°C |
| 封裝/外殼： | 32-VFQFN 裸露焊盤，CSP |
| 安裝類型： | 表面貼裝 |
| 包裝： | 托盤 |
| 產品目錄頁面： | 764 (CN2011-ZH PDF) |
| 配用： | EVAL-ADCMP566BCPZ-ND - BOARD EVALUATION ADCMP566BPZ |
ADCMP566
Rev. 0 | Page 10 of 16
as the variation in propagation delay as the input overdrive
conditions are changed (Figure 4). For the ADCMP566,
overdrive dispersion is typically 35 ps as the overdrive is
changed from 100 mV to 1 V. This specification applies for
both positive and negative overdrive since the ADCMP566 has
equal delays for positive and negative going inputs.
The 35 ps propagation delay overdrive dispersion of the
ADCMP566 offers considerable improvement of the 100 ps
dispersion of other similar series comparators.
Q OUTPUT
INPUT VOLTAGE
1.5V OVERDRIVE
20mV OVERDRIVE
DISPERSION
VREF ± VOS
03633-0-004
Figure 4. Propagation Delay Dispersion
COMPARATOR HYSTERESIS
The addition of hysteresis to a comparator is often useful in a
noisy environment or where it is not desirable for the compara-
tor to toggle between states when the input signal is at the
switching threshold. The transfer function for a comparator
with hysteresis is shown in Figure 5. If the input voltage
approaches the threshold from the negative direction, the
comparator will switch from a 0 to a 1 when the input crosses
+VH/2. The new switching threshold becomes VH/2. The
comparator will remain in a 1 state until the threshold VH/2 is
crossed coming from the positive direction. In this manner,
noise centered on 0 V input will not cause the comparator to
switch states unless it exceeds the region bounded by ±VH/2.
Positive feedback from the output to the input is often used to
produce hysteresis in a comparator (Figure 9). The major
problem with this approach is that the amount of hysteresis
varies with the output logic levels, resulting in a hysteresis that
is not symmetrical around zero.
Another method to implement hysteresis is generated by
introducing a differential voltage between LATCH ENABLE
and LATCH ENABLE. inputs (Figure 10). Hysteresis generated
in this manner is independent of output swing and is symmetri-
cal around zero. The variation of hysteresis with input voltage is
shown in Figure 6.
OUTPUT
INPUT
0
1
0V
–VH
2
+VH
2
03633-0-005
Figure 5. Comparator Hysteresis Transfer Function
LATCH = LE – LEB (mV)
H
YSTER
ESIS
(
m
V)
–20
0
10
20
30
40
50
60
–10
–15
–5
0
10
515
03633-0-006
Figure 6. Comparator Hysteresis Transfer Function
Using Latch Enable Input
MINIMUM INPUT SLEW RATE REQUIREMENT
As for all high speed comparators, a minimum slew rate must
be met to ensure that the device does not oscillate when the
input crosses the threshold. This oscillation is due in part to the
high input bandwidth of the comparator and the parasitics of
the package. Analog Devices recommends a slew rate of 5 V/s
or faster to ensure a clean output transition. If slew rates less
than 5 V/s are used, then hysteresis should be added to reduce
the oscillation.
相關PDF資料 |
PDF描述 |
|---|---|
| ADCMP567BCPZ | IC COMP DUAL ULTRA-FAST 32LFCSP |
| ADCMP573BCPZ-WP | IC COMPARATOR PECL 3.3-5 16LFCSP |
| ADCMP580BCPZ-R2 | IC COMPARATOR CML UFAST 16-LFCSP |
| ADCMP601BKSZ-R2 | IC COMP TTL/CMOS 1CHAN SC70-6 |
| ADCMP603BCPZ-WP | IC COMP TTL/CMOS 1CHAN 12-LFCSP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADCMP567 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Dual Ultrafast Voltage Comparator |
| ADCMP567BCP | 制造商:Analog Devices 功能描述:Comparator Dual -5.45V/5.25V 32-Pin LFCSP EP 制造商:Analog Devices 功能描述:IC COMPARATOR HIGH SPEED |
| ADCMP567BCPZ | 功能描述:IC COMP DUAL ULTRA-FAST 32LFCSP RoHS:是 類別:集成電路 (IC) >> 線性 - 比較器 系列:- 標準包裝:1 系列:- 類型:通用 元件數:1 輸出類型:CMOS，開路集電極，TTL 電壓 - 電源，單路/雙路(±):2.7 V ~ 5.5 V 電壓 - 輸入偏移（最小值）:7mV @ 5V 電流 - 輸入偏壓（最小值）:0.25µA @ 5V 電流 - 輸出（標準）:84mA @ 5V 電流 - 靜態（最大值）:120µA CMRR, PSRR（標準）:- 傳輸延遲（最大）:600ns 磁滯:- 工作溫度:-40°C ~ 85°C 封裝/外殼:SC-74A，SOT-753 安裝類型:表面貼裝 包裝:剪切帶 (CT) 產品目錄頁面:1268 (CN2011-ZH PDF) 其它名稱:*LMV331M5*LMV331M5/NOPBLMV331M5CT |
| ADCMP572 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Ultrafast 3.3 V Single-Supply Comparators |
| ADCMP572_05 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Ultrafast 3.3 V/5 V Single-Supply SiGe Comparators |
發布緊急采購，3分鐘左右您將得到回復。