- 您現在的位置：買賣IC網 > PDF目錄375252 > ADAU1328 (Analog Devices, Inc.) 2 ADC/8 DAC with PLL, 192 kHz, 24-Bit Codec PDF資料下載
參數資料
| 型號： | ADAU1328 |
| 廠商： | Analog Devices, Inc. |
| 元件分類： | Codec |
| 英文描述： | 2 ADC/8 DAC with PLL, 192 kHz, 24-Bit Codec |
| 中文描述： | 2藝發局/ 8鎖相環，192千赫，24位編解碼器數模轉換器 |
| 文件頁數： | 15/32頁 |
| 文件大小： | 316K |
| 代理商： | ADAU1328 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁當前第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
ADAU1328
POWER SUPPLY AND VOLTAGE REFERENCE
The ADAU1328 is designed for 3.3 V supplies. Separate power
supply pins are provided for the analog and digital sections.
These pins should be bypassed with 100 nF ceramic chip
capacitors, as close to the pins as possible, to minimize noise
pickup. A bulk aluminum electrolytic capacitor of at least 22 μF
should also be provided on the same PC board as the codec. For
critical applications, improved performance is obtained with
separate supplies for the analog and digital sections. If this is
not possible, it is recommended that the analog and digital
supplies be isolated by means of a ferrite bead in series with each
supply. It is important that the analog supply be as clean as possible.
Rev. 0 | Page 15 of 32
All digital inputs are compatible with TTL and CMOS levels.
All outputs are driven from the 3.3 V DVDD supply and are
compatible with TTL and 3.3 V CMOS levels.
The ADC and DAC internal voltage reference (VREF) is brought
out on FILTR and should be bypassed as close as possible to the
chip, with a parallel combination of 10 μF and 100 nF. Any
external current drawn should be limited to less than 50 μA.
The internal reference can be disabled in PLL and Clock
Control 1 Register, and FILTR can be driven from an external
source. This can be used to scale the DAC output to the clipping
level of a power amplifier based on its power supply voltage.
The ADC input gain varies by the inverse ratio. The total gain
from ADC input to DAC output remains constant.
The CM pin is the internal common-mode reference. It should
be bypassed as close as possible to the chip, with a parallel
combination of 47 μF and 100 nF. This voltage can be used to
bias external op amps to the common-mode voltage of the input
and output signal pins. The output current should be limited to
less than 0.5 mA source and 2 mA sink.
SERIAL DATA PORTS—DATA FORMAT
The eight DAC channels use a common serial bit clock (DBCLK)
and a common left-right framing clock (DLRCLK) in the serial
data port. The four ADC channels use a common serial bit clock
(ABCLK) and left-right framing clock (ALRCLK) in the serial
data port. The clock signals are all synchronous with the sample
rate. The normal stereo serial modes are shown in Figure 23.
The ADC and DAC serial data modes default to I
2
S. The ports
can also be programmed for left justified, right justified, and
TDM modes. The word width is 24 bits by default and can be
programmed for 16 or 20 bits. The DAC serial formats are
programmable according to DAC Control 0 Register. The
polarity of the DBCLK and DLRCLK is programmable according
to DAC Control 1 Register. The ADC serial formats and serial
clock polarity are programmable according to ADC Control 1
Register. Both DAC and ADC serial ports are programmable to
become the bus masters according to DAC Control 1 Register
and Control 2 Register. By default, both ADC and DAC serial
ports are in the slave mode.
TIME-DIVISION MULTIPLEXED (TDM) MODES
The ADAU1328 serial ports also have several different TDM
serial data modes. The first and most commonly used
configurations are shown in Figure 12 and Figure 13. In Figure 12,
the ADC serial port outputs one data stream consisting of four
on-chip ADCs followed by four unused slots. In Figure 13, the
eight on-chip DAC data slots are packed into one TDM stream.
In this mode, both DBCLK and ABCLK are 256 f
S
.
The I/O pins of the serial ports are defined according to the
serial mode selected. For a detailed description of the function
of each pin in TDM and AUX modes, see Table 11.
The ADAU1328 allows systems with more than eight DAC
channels to be easily configured by the use of an auxiliary serial
data port. The DAC TDM-AUX mode is shown in Figure 14. In
this mode, the AUX channels are the last four slots of the TDM
data stream. These slots are extracted and output to the AUX serial
port. It should be noted that due to the high DBCLK frequency, this
mode is available only in the 48 kHz/44.1 kHz/32 kHz sample rate.
The ADAU1328 also allows system configurations with more
than four ADC channels, as shown in Figure 15 and Figure 16,
which show using 8 ADCs and 16 ADCs, respectively. Again,
due to the high ABCLK frequency, this mode is available only
in the 48 kHz/44.1 kHz/32 kHz sample rate.
Combining the AUX DAC and ADC modes results in a system
configuration of 8 ADCs and 12 DACs. The system, then, con-
sists of two external stereo ADCs, two external stereo DACs,
and one ADAU1328. This mode is shown in Figure 17
(combined AUX DAC and ADC modes).
LEFT 1
SLOT 2
LEFT 2
SLOT 4
MSB
MSB–1
MSB–2
DATA
BCLK
LRCLK
SLOT 5
SLOT 6
SLOT 7
SLOT 8
LRCLK
BCLK
DATA
256 BCLKs
32 BCLKs
0
Figure 12. ADC TDM (8-Channel I
2
S Mode)
LEFT 1
SLOT 2
LEFT 2
SLOT 4
MSB
MSB–1
MSB–2
DATA
BCLK
LRCLK
SLOT 5
SLOT 6
LEFT 4
SLOT 8
LRCLK
BCLK
DATA
256 BCLKs
32 BCLK
0
Figure 13. DAC TDM (8-Channel I
2
S Mode)
相關PDF資料 |
PDF描述 |
|---|---|
| ADAU1328BSTZ | 2 ADC/8 DAC with PLL, 192 kHz, 24-Bit Codec |
| ADAU1328BSTZ-RL | 2 ADC/8 DAC with PLL, 192 kHz, 24-Bit Codec |
| ADAU1701 | SigmaDSP 28/56-Bit Audio Processor with 2ADC/4DAC |
| ADAU1701JSTZ | SigmaDSP 28/56-Bit Audio Processor with 2ADC/4DAC |
| ADAU1701JSTZ-RL | SigmaDSP 28/56-Bit Audio Processor with 2ADC/4DAC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADAU1328BSTZ | 功能描述:IC CODEC 24BIT 2ADC/8DAC 48LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 編解碼器 系列:- 標準包裝:2,500 系列:- 類型:立體聲音頻 數據接口:串行 分辨率（位）:18 b ADC / DAC 數量:2 / 2 三角積分調變:是 S/N 比，標準 ADC / DAC (db):81.5 / 88 動態范圍，標準 ADC / DAC (db):82 / 87.5 電壓 - 電源，模擬:2.6 V ~ 3.3 V 電壓 - 電源，數字:1.7 V ~ 3.3 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-WFQFN 裸露焊盤 供應商設備封裝:48-TQFN-EP（7x7） 包裝:帶卷 (TR) |
| ADAU1328BSTZKL1 | 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述: |
| ADAU1328BSTZ-RL | 功能描述:IC CODEC 24BIT 2ADC/8DAC 48LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 編解碼器 系列:- 標準包裝:2,500 系列:- 類型:立體聲音頻 數據接口:串行 分辨率（位）:18 b ADC / DAC 數量:2 / 2 三角積分調變:是 S/N 比，標準 ADC / DAC (db):81.5 / 88 動態范圍，標準 ADC / DAC (db):82 / 87.5 電壓 - 電源，模擬:2.6 V ~ 3.3 V 電壓 - 電源，數字:1.7 V ~ 3.3 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-WFQFN 裸露焊盤 供應商設備封裝:48-TQFN-EP（7x7） 包裝:帶卷 (TR) |
| ADAU1361BCPZ | 功能描述:IC CODEC 24B PLL 32LFCSP RoHS:是 類別:集成電路 (IC) >> 接口 - 編解碼器 系列:- 標準包裝:2,500 系列:- 類型:PCM 數據接口:PCM 音頻接口 分辨率（位）:15 b ADC / DAC 數量:1 / 1 三角積分調變:是 S/N 比，標準 ADC / DAC (db):- 動態范圍，標準 ADC / DAC (db):- 電壓 - 電源，模擬:2.7 V ~ 3.3 V 電壓 - 電源，數字:2.7 V ~ 3.3 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:80-VFBGA 供應商設備封裝:80-BGA MICROSTAR JUNIOR（5x5） 包裝:帶卷 (TR) 其它名稱:296-21257-2 |
| ADAU1361BCPZ | 制造商:Analog Devices 功能描述:IC, AUDIO CODEC, 24BIT, 96KHZ, LFCSP-32 |
發布緊急采購，3分鐘左右您將得到回復。