- 您現在的位置：買賣IC網 > PDF目錄5305 > ADA4858-3ACPZ-RL (Analog Devices Inc)IC OPAMP CF TRPL LP 21MA 16LFCSP PDF資料下載
參數資料
| 型號： | ADA4858-3ACPZ-RL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 8/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP CF TRPL LP 21MA 16LFCSP |
| 標準包裝： | 5,000 |
| 放大器類型： | 電流反饋 |
| 電路數： | 3 |
| 轉換速率： | 600 V/µs |
| -3db帶寬： | 600MHz |
| 電流 - 輸入偏壓： | 8µA |
| 電壓 - 輸入偏移： | 500µV |
| 電流 - 電源： | 19mA |
| 電流 - 輸出 / 通道： | 21mA |
| 電壓 - 電源，單路/雙路(±)： | 3 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-VQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 16-LFCSP-VQ EP（4x4） |
| 包裝： | 帶卷 (TR) |
ADA4858-3
Data Sheet
Rev. B | Page 16 of 20
PD (POWER-DOWN) PIN
The ADA4858-3 is equipped with a PD (power-down) pin for
all three amplifiers. This allows the user to reduce the quiescent
supply current when an amplifier is not active. The power-down
threshold levels are derived from ground level. The amplifiers are
powered down when the voltage applied to the PD pin is greater
than a certain voltage from ground. In a 5 V supply application, the
voltage is greater than 2 V, and in a 3.3 V supply application, the
voltage is greater than 1.5 V. The amplifier is enabled whenever the
PD pin is connected to ground. If the PD pin is not used, it is
best to connect it to ground. Note that the power-down feature
does not control the charge pump output voltage and current.
Table 6. Power-Down Voltage Control
PD Pin
5 V
3.3 V
Not active
<1.5 V
<1 V
Active
>2 V
>1.5 V
POWER SUPPLY BYPASSING
Careful attention must be paid to bypassing the power supply
pins of the ADA4858-3. High quality capacitors with low
equivalent series resistance (ESR), such as multilayer ceramic
capacitors (MLCCs), should be used to minimize supply
voltage ripple and power dissipation. A large, usually tantalum,
capacitor between 2.2 F to 47 F located in proximity to the
ADA4858-3 is required to provide good decoupling for lower
frequency signals. The actual value is determined by the circuit
transient and frequency requirements. In addition, place 0.1 F
MLCC decoupling capacitors as close to each of the power
supply pins and across from both supplies as is physically
possible, no more than 1/8 inch away. The ground returns
should terminate immediately into the ground plane. Placing
the bypass capacitor return close to the load return minimizes
ground loops and improves performance.
LAYOUT
As is the case with all high speed applications, careful attention
to printed circuit board (PCB) layout details prevents associated
board parasitics from becoming problematic. The ADA4858-3 can
operate at up to 600 MHz; therefore, proper RF design techniques
must be employed. The PCB should have a ground plane covering
all unused portions of the component side of the board to provide a
low impedance return path. Removing the ground plane on all
layers from the area near and under the input and output pins
reduces stray capacitance. Keep signal lines connecting the
feedback and gain resistors as short as possible to minimize the
inductance and stray capacitance associated with these traces.
Place termination resistors and loads as close as possible to their
respective inputs and outputs. Keep input and output traces as
far apart as possible to minimize coupling (crosstalk) through the
board. Adherence to microstrip or stripline design techniques for
long signal traces (greater than 1 inch) is recommended. For
more information on high speed board layout, see “A Practical
Dialogue, Volume 39, Number 3, September 2005.
相關PDF資料 |
PDF描述 |
|---|---|
| 3404.2421.22 | FUSE&HOLDER 3.15A 125V FAST SMD |
| MC3423P1G | IC SENSOR UNDERVOLTAGE 8DIP |
| AD8223BR-RL | IC AMP INST R-R LP 8SOIC |
| MC3423DG | IC SENSOR UNDERVOLTAGE 8SOIC |
| R11-2-30.0A-34972-1 | CIRCUIT BREAKER ROCKER SP 30A 32 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADA4859-3 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Single-Supply, Fixed G = 2, High Speed, Video Amplifier with Charge Pump |
| ADA4859-3ACP-EBZ | 功能描述:BOARD EVAL FOR ADA4859-3ACP RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:* 標準包裝:1 系列:- 主要目的:電信，線路接口單元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要屬性:T1/J1/E1 LIU 次要屬性:- 已供物品:板，電源，線纜，CD 其它名稱:82EBV2081 |
| ADA4859-3ACPZ-R2 | 制造商:Analog Devices 功能描述:VID AMP TRIPLE 5.5V 16LFCSP EP - Tape and Reel 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述:IC VIDEO AMPLIFIER TRI 195MHZ LFCSP16 制造商:Analog Devices 功能描述:Sngl Sup HghSpd GN+2 Amp Chrg Pump 制造商:Analog Devices 功能描述:IC, VIDEO AMPLIFIER, TRI, 195MHZ LFCSP16, Gain Bandwidth:195MHz, Supply Voltage Range:3V to 5.5V, Slew Rate:740V/s, No. of Amplifiers:3, Output Current:19mA, Amplifier Output:Single Ended, Operating Temperature Range:-40C to +105C, RoHS Compliant: Yes |
| ADA4859-3ACPZ-R7 | 功能描述:IC AMP 3CH CFB G=2 W/CP 16LFCSP RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 應用:TFT-LCD 面板：VCOM 驅動器 輸出類型:滿擺幅 電路數:1 -3db帶寬:35MHz 轉換速率:40 V/µs 電流 - 電源:3.7mA 電流 - 輸出 / 通道:1.3A 電壓 - 電源，單路/雙路(±):9 V ~ 20 V，±4.5 V ~ 10 V 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬）裸露焊盤 供應商設備封裝:8-uMax-EP 包裝:管件 |
| ADA4859-3ACPZ-RL | 功能描述:IC AMP 3CH CFB G=2 W/CP 16LFCSP RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 標準包裝:1,000 系列:- 應用:驅動器 輸出類型:差分 電路數:3 -3db帶寬:350MHz 轉換速率:1000 V/µs 電流 - 電源:14.5mA 電流 - 輸出 / 通道:60mA 電壓 - 電源，單路/雙路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 供應商設備封裝:20-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。