- 您現在的位置：買賣IC網 > PDF目錄375251 > ADA4853-3YRUZ (ANALOG DEVICES INC) Low Power, Rail-to-Rail Output, Video Op Amp with Ultralow Power Disable PDF資料下載
參數資料
| 型號： | ADA4853-3YRUZ |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 音頻／視頻放大 |
| 英文描述： | Low Power, Rail-to-Rail Output, Video Op Amp with Ultralow Power Disable |
| 中文描述： | 1 CHANNEL, VIDEO AMPLIFIER, PDSO14 |
| 封裝： | ROHS COMPLIANT, MO-153AB-1, TSSOP-14 |
| 文件頁數： | 15/16頁 |
| 文件大小： | 436K |
| 代理商： | ADA4853-3YRUZ |
ADA4853-1/ADA4853-2/ADA4853-3
APPLICATIONS
SINGLE-SUPPLY VIDEO AMPLIFIER
With low differential gain and phase errors and wide 0.5 dB
flatness, the ADA4853-1/ADA4853-2/ADA4853-3 are ideal
solutions for portable video applications. Figure 51 shows a
typical video driver set for a noninverting gain of +2, where
R
F
= R
G
= 1 kΩ. The video amplifier input is terminated into a
shunt 75 Ω resistor. At the output, the amplifier has a series
75 Ω resistor for impedance matching to the video load.
When operating in low voltage, single-supply applications, the
input signal is only limited by the input stage headroom.
Rev. B | Page 15 of 16
75
CABLE
V
OUT
75
75
V
IN
R
G
R
F
+V
S
P
D
U1
C1
2.2μF
C2
0.01μF
0
+
V
Figure 51. Video Amplifier
POWER SUPPLY BYPASSING
Attention must be paid to bypassing the power supply pins of
the ADA4853-1/ADA4853-2/ADA4853-3. High quality capacitors
with low equivalent series resistance (ESR), such as multilayer
ceramic capacitors (MLCCs), should be used to minimize
supply voltage ripple and power dissipation. A large, usually
tantalum, 2.2 μF to 47 μF capacitor located in proximity to the
ADA4853-1/ADA4853-2/ADA4853-3 is required to provide
good decoupling for lower frequency signals. The actual value is
determined by the circuit transient and frequency requirements.
In addition, 0.1 μF MLCC decoupling capacitors should be
located as close to each of the power supply pins as is physically
possible, no more than inch away. The ground returns should
terminate immediately into the ground plane. Locating the bypass
capacitor return close to the load return minimizes ground loops
and improves performance.
LAYOUT
As is the case with all high speed applications, careful attention
to printed circuit board (PCB) layout details prevents associated
board parasitics from becoming problematic. The ADA4853-1/
ADA4853-2/ADA4853-3 can operate up to 100 MHz; therefore,
proper RF design techniques must be employed. The PCB
should have a ground plane covering all unused portions of
the component side of the board to provide a low impedance
return path. Removing the ground plane on all layers from the
area near and under the input and output pins reduces stray
capacitance. Signal lines connecting the feedback and gain
resistors should be kept as short as possible to minimize the
inductance and stray capacitance associated with these traces.
Termination resistors and loads should be located as close as
possible to their respective inputs and outputs. Input and output
traces should be kept as far apart as possible to minimize
coupling (crosstalk) through the board. Adherence to microstrip or
stripline design techniques for long signal traces (greater than 1
inch) is recommended. For more information on high speed
board layout, go to: www.analog.com to view
A Practical Guide
to High-Speed Printed-Circuit-Board Layout
.
相關PDF資料 |
PDF描述 |
|---|---|
| ADA4853-3YRUZ-R7 | Low Power, Rail-to-Rail Output, Video Op Amp with Ultralow Power Disable |
| ADA4853-3YRUZ-RL | Low Power, Rail-to-Rail Output, Video Op Amp with Ultralow Power Disable |
| ADA4860-1 | High Speed, Low Cost, Op Amp |
| ADA4860-1YRJZ-R2 | High Speed, Low Cost, Op Amp |
| ADA4860-1YRJZ-RL | High Speed, Low Cost, Op Amp |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADA4853-3YRUZ-R7 | 功能描述:IC OPAMP VIDEO TRIPLE 14-TSSOP RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 標準包裝:1,000 系列:- 應用:驅動器 輸出類型:差分 電路數:3 -3db帶寬:350MHz 轉換速率:1000 V/µs 電流 - 電源:14.5mA 電流 - 輸出 / 通道:60mA 電壓 - 電源，單路/雙路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 供應商設備封裝:20-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR) |
| ADA4853-3YRUZ-RL | 功能描述:IC OPAMP VIDEO TRIPLE 14-TSSOP RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 標準包裝:1,000 系列:- 應用:驅動器 輸出類型:差分 電路數:3 -3db帶寬:350MHz 轉換速率:1000 V/µs 電流 - 電源:14.5mA 電流 - 輸出 / 通道:60mA 電壓 - 電源，單路/雙路(±):5 V ~ 12 V，±2.5 V ~ 6 V 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 供應商設備封裝:20-QFN 裸露焊盤（4x4） 包裝:帶卷 (TR) |
| ADA4855-3 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Single Supply, High Speed, Rail-to-Rail Output, Triple Op Amp |
| ADA4855-3YCP-EBZ | 功能描述:BOARD EVAL FOR ADA4855-3YCP RoHS:是 類別:編程器，開發系統 >> 評估板 - 運算放大器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- |
| ADA4855-3YCPZ-R2 | 制造商:Analog Devices 功能描述:OP Amp Triple Volt Fdbk R-R O/P 5.5V 16-Pin LFCSP EP T/R 制造商:Analog Devices 功能描述:OP AMP TRIPLE VOLT FDBK R-R O/P 5.5V 16LFCSP EP - Tape and Reel 制造商:Analog Devices 功能描述:IC OP-AMP 410MHZ 870V/ us LFCSP-16 制造商:Analog Devices 功能描述:IC, OP-AMP, 410MHZ, 870V/ us, LFCSP-16; Op Amp Type:High Speed; No. of Amplifiers:3; Slew Rate:870V/s; Supply Voltage Range:3V to 5.5V; Amplifier Case Style:LFCSP; No. of Pins:16; Bandwidth:410MHz; Operating Temperature Min:-40C ;RoHS Compliant: Yes |
發布緊急采購，3分鐘左右您將得到回復。