參數資料
型號: ADA4841-1YRJ-EBZ
廠商: Analog Devices Inc
文件頁數: 7/21頁
文件大小: 0K
描述: BOARD EVAL FOR ADA4841-1YRJ
標準包裝: 1
每 IC 通道數: 1 - 單
放大器類型: 電壓反饋
板類型: 裸(未填充)
已供物品:
已用 IC / 零件: SOT-23-6 封裝
ADA4841-1/ADA4841-2
Rev. E | Page 14 of 20
The output noise spectral density can be calculated by
[]
2
4
1
4
F
G
F
S
G
F
R
ien
kTRg
R
ven
R
ien
kTRs
R
kTRf
en
vout
+
+
+
=
_
(6)
where:
k is Boltzmann’s Constant.
T is the absolute temperature, degrees Kelvin.
ien is the amplifier input current noise spectral density, pA/√Hz.
ven is the amplifier input voltage spectral density, nV/√Hz.
RS is the source resistance as shown in Figure 40.
RF and RG are the feedback network resistances, as shown in
Source resistance noise, amplifier voltage noise (ven), and the
voltage noise from the amplifier current noise (ien × RS) are
all subject to the noise gain term (1 + RF/RG). Note that with a
2.1 nV/√Hz input voltage noise and 1.4 pA/√Hz input current,
the noise contributions of the amplifier are relatively small for
source resistances between approximately 200 Ω and 30 kΩ.
shows the total RTI noise due to the amplifier vs. the
source resistance. In addition, the value of the feedback resistors
used impacts the noise. It is recommended to keep the value of
feedback resistors between 250 Ω and 1 kΩ to keep the total
noise low.
1000
0.1
10
100k
05614-007
SOURCE RESISTANCE (
Ω)
NOISE
(
n
V/
Hz)
100
10
1
100
1k
10k
TOTAL AMPLIFIER NOISE
SOURCE RESISTANCE NOISE
AMPLIFIER + RESISTOR NOISE
Figure 41. RTI Noise vs. Source Resistance
HEADROOM CONSIDERATIONS
The ADA4841-1/ADA4841-2 are designed to provide maximum
input and output signal ranges with 16-bit to 18-bit dc linearity.
As the input or output headroom limits are reached, the signal
linearity degrades.
The input stage positive limit is almost exactly a volt below the
positive supply at room temperature. Input voltages above that
start to show clipping behavior. The positive input voltage limit
increases with temperature with a coefficient of about 2 mV/°C.
The lower supply limit is nominally below the minus supply;
therefore, in a standard gain configuration, the output stage
limits the signal headroom on the negative supply side. Figure 42
and Figure 43 show the nominal CMRR behavior at the limits of
the input headroom for three temperatures—this is generated
using the subtractor topology shown in Figure 44, which avoids
the output stage limitation.
300
–300
3.00
5.00
05614
-055
COMMON-MODE VOLTAGE (V)
C
O
M
O
N-
M
O
DE
E
RRO
R
(
μV)
260
220
180
140
100
60
20
–20
–60
–100
–140
–180
–220
–260
3.20 3.40 3.60 3.80 4.00 4.20 4.40 4.60 4.80
–40°C
+25°C
+125°C
Figure 42. +CMV vs. Common-Mode Error vs. VOS
0
–800
–6.00
–4.00
05614-054
COMMON-MODE VOLTAGE (V)
COMMON-
MODE
ERROR
(
μV)
–50
–100
–150
–200
–250
–300
–350
–400
–450
–500
–550
–600
–650
–700
–750
–5.80 –5.60 –5.40 –5.20 –5.00 –4.80 –4.60 –4.40 –4.20
–40°C
+25°C
+125°C
Figure 43. CMV vs. Common-Mode Error vs. VOS
+ VOUT
– VCM +
05614-
051
Figure 44. Common-Range Subtractor
相關PDF資料
PDF描述
ADA4891-3AR-EBZ BOARD EVAL FOR ADA4891-3AR
ADA4891-2AR-EBZ BOARD EVAL FOR ADA4891-2AR
SDS850R-563M INDUCTOR PWR SHIELDED 56UH SMD
811033-000 BOOT MOLDED STR SIZE 11 EXPANDED
0210490354 CABLE JUMPER 1.25MM .152M 28POS
相關代理商/技術參數
參數描述
ADA4841-1YRJZ 制造商:Analog Devices 功能描述:OP AMP VF R-R LP LN SOT23-6 制造商:Analog Devices 功能描述:OP AMP, VF, R-R, LP, LN, SOT23-6 制造商:Analog Devices 功能描述:OP AMP, VF, R-R, LP, LN, SOT23-6, Op Amp Type:Rail to Rail, No. of Amplifiers:1, 制造商:Analog Devices 功能描述:OP AMP, VF, R-R, LP, LN, SOT23-6, Op Amp Type:Rail to Rail, No. of Amplifiers:1, Slew Rate:13V/s, Supply Voltage Range:2.7V to 12V, Amplifier Case Style:SOT-23, No. of Pins:6, Bandwidth:80MHz, Operating Temperature Min:-40C, , RoHS Compliant: Yes
ADA4841-1YRJZ-R2 制造商:Analog Devices 功能描述:OP Amp Single Volt Fdbk R-R O/P ±6V/12V 6-Pin SOT-23 T/R 制造商:Analog Devices 功能描述:OP AMP SGL VOLT FDBK R-R O/P 6V/12V 6PIN SOT-23 - Tape and Reel 制造商:Rochester Electronics LLC 功能描述: 制造商:Analog Devices 功能描述:IC OP AMPVFR-RLPLNSOT23-6 制造商:Analog Devices 功能描述:IC, OP-AMP, 80MHZ, 13V/ us, SOT-23-6, Op Amp Type:Low Power, No. of Amplifiers:1
ADA4841-1YRJZ-R2 制造商:Analog Devices 功能描述:IC OP-AMP 80MHZ 13V/S SOT-23-6
ADA4841-1YRJZ-R7 功能描述:IC OPAMP VF R-R LP LN SOT23-6 RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源,單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤,CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT
ADA4841-1YRJZ-RL 功能描述:IC OPAMP VF R-R LP LN SOT23-6 RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:- 放大器類型:通用 電路數:2 輸出類型:滿擺幅 轉換速率:1.8 V/µs 增益帶寬積:6.5MHz -3db帶寬:4.5MHz 電流 - 輸入偏壓:5nA 電壓 - 輸入偏移:100µV 電流 - 電源:65µA 電流 - 輸出 / 通道:35mA 電壓 - 電源,單路/雙路(±):1.8 V ~ 5.25 V,±0.9 V ~ 2.625 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:10-TFSOP,10-MSOP(0.118",3.00mm 寬) 供應商設備封裝:10-MSOP 包裝:管件