- 您現在的位置：買賣IC網 > PDF目錄16933 > ADA4817-1ACP-EBZ (Analog Devices Inc)BOARD EVAL FOR ADA4817-1ACP PDF資料下載
參數資料
| 型號： | ADA4817-1ACP-EBZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 11/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | BOARD EVAL FOR ADA4817-1ACP |
| 標準包裝： | 1 |
| 每 IC 通道數： | 1 - 單 |
| 放大器類型： | 電壓反饋 |
| 板類型： | 裸（未填充） |
| 已供物品： | 板 |
| 已用 IC / 零件： | 8-LFCSP 封裝 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
Data Sheet
ADA4817-1/ADA4817-2
Rev. B | Page 19 of 28
APPLICATIONS INFORMATION
LOW DISTORTION PINOUT
The ADA4817-1/ADA4817-2 feature a new low distortion
pinout from Analog Devices. The new pinout provides two
advantages over the traditional pinout. The first advantage is
improved second harmonic distortion performance, which is
accomplished by the physical separation of the noninverting
input pin and the negative power supply pin. The second
advantage is the simplification of the layout due to the dedicated
feedback pin and easy routing of the gain set resistor back to
the inverting input pin. This allows a compact layout, which
helps to minimize parasitics and increase stability.
The designer does not need to use the dedicated feedback pin to
provide feedback for the ADA4817-1/ADA4817-2. The output
pin of the ADA4817-1/ADA4817-2 can still be used to provide
feedback to the inverting input of the ADA4817-1/ADA4817-2.
WIDEBAND PHOTODIODE PREAMP
The wide bandwidth and low noise of the ADA4817-1/
ADA4817-2 make it an ideal choice for transimpedance
amplifiers, such as those used for signal conditioning with
high speed photodiodes. Figure 50 shows an I/V converter
with an electrical model of a photodiode. The basic transfer
function is
F
PHOTO
OUT
R
sC
R
I
V
1
(13)
where:
IPHOTO
is the output current of the photodiode.
The parallel combination of RF and CF sets the signal bandwidth.
RSH = 1011
RF
CF
CM
CD
CS
VB
IPHOTO
07
75
6-
04
8
VOUT
Figure 50. Wideband Photodiode Preamp
The stable bandwidth attainable with this preamp is a function
of RF, the gain bandwidth product of the amplifier, and the total
capacitance at the summing junction of the amplifier, including the
photodiode capacitance (CS) and the amplifier input capacitance.
RF and the total capacitance produce a pole in the amplifier’s
loop transmission that can result in peaking and instability.
Adding CF creates a zero in the loop transmission that compen-
sates for the effect of the pole and reduces the signal bandwidth.
It can be shown that the signal bandwidth obtained with a 45°
phase margin (f(45)) is defined by
)
(
2
)
45
(
D
M
S
F
CR
C
R
f
(14)
where:
fCR
is the amplifier crossover frequency.
RF
is the feedback resistor.
CS
is the source capacitance including the photodiode and the
board parasitic.
CM
is the common-mode capacitance of the amplifier.
CD
is the differential capacitance of the amplifier.
The value of CF that produces f(45) can be shown to be
CR
F
D
M
S
F
f
R
C
2
(15)
The frequency response shows less peaking if bigger CF values
are used.
The preamplifier output noise over frequency is shown in
VEN (CF + CS + CM + CD)/CF
VO
L
T
A
G
E
N
O
IS
E
(n
V/
Hz
)
FREQUENCY (Hz)
NOISE DUE TO AMPLIFIER
VEN
f2
f3
f1
RF NOISE
f1 =
1
2 RF (CF + CS + CM + CD)
f2 =
1
2 RFCF
f3 =
fCR
(CF + CS + CM + CD)/CF
07
75
6-
0
43
Figure 51. Photodiode Voltage Noise Contributions
相關PDF資料 |
PDF描述 |
|---|---|
| 20-101-0879 | CARD KEYPAD/DISPL INTERFC RN1600 |
| RCC18DREN-S13 | CONN EDGECARD 36POS .100 EXTEND |
| 1-555858-5 | CABLE ASSY PWR ENTRY 5 WIRE 182" |
| OP42GS-EBZ | BOARD EVAL FOR OP42GS |
| AD8092ARM-EBZ | BOARD EVAL FOR AD8092ARM |
相關代理商/技術參數 |
參數描述 |
|---|---|
| ADA4817-1ACPZ-R2 | 制造商:Analog Devices 功能描述:OP Amp Single Volt Fdbk ±5V/10V 8-Pin LFCSP EP T/R 制造商:Analog Devices 功能描述:OP AMP SGL VOLT FDBK 5V/10V 8LFCSP EP - Tape and Reel 制造商:Analog Devices 功能描述:IC OP AMP FET 1GHZ 8LFCSP 制造商:Analog Devices 功能描述:IC, OP AMP, FET, 1GHZ, 8LFCSP 制造商:Analog Devices 功能描述:IC, OP AMP, FET, 1GHZ, 8LFCSP; Op Amp Type:Low Noise; No. of Amplifiers:1; Slew Rate:870V/s; Supply Voltage Range:5V to 10V; Amplifier Case Style:LFCSP; No. of Pins:8; Bandwidth:1.05GHz; Operating Temperature Min:-40C; Operating ;RoHS Compliant: Yes |
| ADA4817-1ACPZ-R2 | 制造商:Analog Devices 功能描述:OP AMPLN1.05GHZFASTFET8LFCSP |
| ADA4817-1ACPZ-R2 | 制造商:Analog Devices 功能描述:Operational Amplifier IC |
| ADA4817-1ACPZ-R7 | 功能描述:IC OPAMP VF 410MHZ LN 8LFCSP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:FastFET™ 產品培訓模塊:Differential Circuit Design Techniques for Communication Applications 標準包裝:1 系列:- 放大器類型:RF/IF 差分 電路數:1 輸出類型:差分 轉換速率:9800 V/µs 增益帶寬積:- -3db帶寬:2.9GHz 電流 - 輸入偏壓:3µA 電壓 - 輸入偏移:- 電流 - 電源:40mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:16-VQFN 裸露焊盤，CSP 供應商設備封裝:16-LFCSP-VQ 包裝:剪切帶 (CT) 產品目錄頁面:551 (CN2011-ZH PDF) 其它名稱:ADL5561ACPZ-R7CT |
| ADA4817-1ACPZ-RL | 功能描述:IC OPAMP VF 410MHZ LN 8LFCSP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:FastFET™ 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:3.5 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:30pA 電壓 - 輸入偏移:2000µV 電流 - 電源:200µA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。