參數資料
型號: ADA4432-1BCPZ-R7
廠商: Analog Devices Inc
文件頁數: 11/29頁
文件大?。?/td> 0K
描述: IC SD VIDEO FILTER AMP 8LFCSP
標準包裝: 1
應用: 車載系統(tǒng)
輸出類型: 單端
電路數: 1
-3db帶寬: 10.5MHz
電流 - 電源: 7.6mA
電流 - 輸出 / 通道: 50mA
電壓 - 電源,單路/雙路(±): 2.6 V ~ 3.6 V
安裝類型: 表面貼裝
封裝/外殼: 8-WFDFN 裸露焊盤,CSP
供應商設備封裝: 8-LFCSP-WD(3x3)
包裝: 標準包裝
其它名稱: ADA4432-1BCPZ-R7DKR
ADA4432-1/ADA4433-1
Data Sheet
Rev. A | Page 18 of 28
CONFIGURING THE ADA4433-1 FOR SINGLE-
ENDED INPUT SIGNALS
The ADA4433-1 is a fully differential filter/driver that can be
used as a single-ended-to-differential amplifier or as a differential-
to-differential amplifier. In single-ended-to-differential output
applications, bias the IN input appropriately to optimize the
output range. To make the most efficient use of the output range
of the ADA4433-1, especially with low supply voltages, it is
important to allow the differential output voltage to swing in
both a positive and negative direction around the output common-
mode voltage (VOCM) level, the midsupply point. To do this, the
differential input voltage must swing both positive and negative.
Figure 46 shows a 1 V p-p single-ended signal on +IN with IN
grounded. This produces a differential input voltage that ranges
from 0 V to 1 V. The resulting differential output voltage is
strictly positive, where each output swings only above V+OUT or
below VOUT, the midsupply VOCM level. Directly at the output of the
ADA4433-1, the output voltage extends from 0.65 V to 2.65 V,
requiring a full 2 V of output to produce a 1 V p-p signal at the
receiver (represented by the voltage across 2R).
To make a more efficient use of the output range, the IN input is
biased at the midpoint of the expected input signal range, as shown
in Figure 47. A 1 V p-p single-ended signal on +IN, with IN
biased at 0.5 V, produces a differential input voltage that ranges
from 0.5 V to +0.5 V. The resulting differential output voltage
now contains both positive and negative components, where
each output swings both above and below the midsupply VOCM
level. Directly at the output of the ADA4433-1, the output
voltage now extends only from 1.15 V to 2.15 V, requiring only
1 V of the output to produce a 1 V p-p signal at the receiver.
Figure 46. Single-Ended-to-Differential Configuration with Negative Input (IN) Connected to Ground
Figure 47. Single-Ended-to-Differential Configuration with Negative Input (IN) Connected to 0.5 V
INPUT SIGNAL
ADA4433-1
V+IN
VOCM =
1.65V
V+OUT
V–OUT
+
V–IN
VDIFF (IN) = V+IN – V–IN
VDIFF (OUT) = V+OUT – V–OUT
VOUT = VDIFF (OUT) ÷ 2
VOUT
R
2R
2.65V
0.65V
R
0V
1.0V
1V p-p
DIFFERENTIAL OUTPUT SIGNAL
DIFFERENTIAL OUTPUT SIGNAL ACROSS 2R
1V p-p
10597-
028
INPUT SIGNAL
ADA4433-1
VOCM =
1.65V
+
VDIFF (IN) = V+IN – V–IN
VDIFF (OUT) = V+OUT – V–OUT
VOUT = VDIFF (OUT) ÷ 2
VOUT
R
2R
1.15V
2.15V
R
0V
0.5V
1.0V
1V p-p
DIFFERENTIAL OUTPUT SIGNAL
DIFFERENTIAL OUTPUT SIGNAL ACROSS 2R
1V p-p
10597-
029
V+IN
V+OUT
V–OUT
V–IN
相關PDF資料
PDF描述
AD5541AR IC DAC 16BIT SRL IN/VOUT 8-SOIC
AD767JP IC DAC 12BIT W/AMP 28-PLCC
AD7245JP IC DAC 12BIT LC2MOS 28-PLCC
VE-2W0-IV-F2 CONVERTER MOD DC/DC 5V 150W
AD7245AAP IC DAC 12BIT W/REF 28-PLCC
相關代理商/技術參數
參數描述
ADA4432-1BRJ-EBZ 制造商:AD 制造商全稱:Analog Devices 功能描述:SD Video Filter Amplifiers
ADA4432-1BRJZ-R2 制造商:Analog Devices 功能描述:HIGH SPEED VIDEO FILTER AMPLIFIERS - Tape and Reel
ADA4432-1BRJZ-R7 功能描述:IC SD VIDEO FILTER AMP SOT23-6 RoHS:是 類別:集成電路 (IC) >> 線性 - 放大器 - 視頻放大器和頻緩沖器 系列:- 標準包裝:1,000 系列:- 應用:驅動器 輸出類型:差分 電路數:3 -3db帶寬:350MHz 轉換速率:1000 V/µs 電流 - 電源:14.5mA 電流 - 輸出 / 通道:60mA 電壓 - 電源,單路/雙路(±):5 V ~ 12 V,±2.5 V ~ 6 V 安裝類型:表面貼裝 封裝/外殼:20-VFQFN 裸露焊盤 供應商設備封裝:20-QFN 裸露焊盤(4x4) 包裝:帶卷 (TR)
ADA4432-1WBCPZ-R7 制造商:AD 制造商全稱:Analog Devices 功能描述:SD Video Filter Amplifiers
ADA4432-1WBRJZ-R2 功能描述:IC SD VIDEO FILTER AMP 6SOT23 制造商:analog devices inc. 系列:- 包裝:帶卷(TR) 零件狀態(tài):過期 應用:車載系統(tǒng) 輸出類型:單端 電路數:1 -3db 帶寬:10.5MHz 壓擺率:- 電流 - 電源:7.6mA 電流 - 輸出/通道:50mA 電壓 - 電源,單/雙(±):2.6 V ~ 3.6 V 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商器件封裝:SOT-23 標準包裝:250