- 您現在的位置：買賣IC網 > PDF目錄10113 > AD9649BCPZRL7-65 (Analog Devices Inc)IC ADC 14BIT 65MSPS 32LFCSP PDF資料下載
參數資料
| 型號： | AD9649BCPZRL7-65 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 9/32頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 14BIT 65MSPS 32LFCSP |
| 標準包裝： | 1,500 |
| 位數： | 14 |
| 采樣率（每秒）： | 65M |
| 數據接口： | 串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 87.5mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 32-VFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 32-LFCSP-VQ |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 2 個單端，單極；1 個差分，單極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁
AD9649
Rev. 0 | Page 17 of
32
THEORY OF OPERATION
The AD9649 architecture consists of a multistage, pipelined ADC.
Each stage provides sufficient overlap to correct for flash errors in
the preceding stage. The quantized outputs from each stage are
combined into a final 14-bit result in the digital correction logic.
The pipelined architecture permits the first stage to operate with
a new input sample, whereas the remaining stages operate with pre-
ceding samples. Sampling occurs on the rising edge of the clock.
Each stage of the pipeline, excluding the last, consists of a low
resolution flash ADC connected to a switched-capacitor DAC
and an interstage residue amplifier (for example, a multiplying
digital-to-analog converter (MDAC)). The residue amplifier
magnifies the difference between the reconstructed DAC output
and the flash input for the next stage in the pipeline. One bit of
redundancy is used in each stage to facilitate digital correction
of flash errors. The last stage consists of a flash ADC.
The output staging block aligns the data, corrects errors, and
passes the data to the CMOS output buffers. The output buffers
are powered from a separate (DRVDD) supply, allowing adjust-
ment of the output voltage swing. During power-down, the output
buffers go into a high impedance state.
ANALOG INPUT CONSIDERATIONS
The analog input to the AD9649 is a differential switched-
capacitor circuit designed for processing differential input
signals. This circuit can support a wide common-mode range
while maintaining excellent performance. By using an input
common-mode voltage of midsupply, users can minimize
signal-dependent errors and achieve optimum performance.
SS
H
CPAR
CSAMPLE
CPAR
VIN–
H
SS
H
VIN+
H
0
85
39
-0
06
Figure 35. Switched-Capacitor Input Circuit
The clock signal alternately switches the input circuit between
sample mode and hold mode (see Figure 35). When the input
circuit is switched to sample mode, the signal source must be
capable of charging the sample capacitors and settling within one-
half of a clock cycle. A small resistor in series with each input
can help reduce the peak transient current injected from the output
stage of the driving source. In addition, low Q inductors or ferrite
beads can be placed on each leg of the input to reduce high differ-
ential capacitance at the analog inputs and, therefore, achieve the
maximum bandwidth of the ADC. Such use of low Q inductors or
ferrite beads is required when driving the converter front end at
high IF frequencies. Either a shunt capacitor or two single-ended
capacitors can be placed on the inputs to provide a matching pas-
sive network. This ultimately creates a low-pass filter at the input
to limit unwanted broadband noise. See the AN-742 Application
Note, the AN-827 Application Note, and the Analog Dialogue
Converters” (Volume 39, April 2005) for more information. In
general, the precise values depend on the application.
Input Common Mode
The analog inputs of the AD9649 are not internally dc-biased.
Therefore, in ac-coupled applications, the user must provide an
external dc bias. Setting the device so that VCM = AVDD/2
is recommended for optimum performance, but the device can
function over a wider range with reasonable performance, as
100
90
80
70
60
50
0.5
0.6
0.7
0.8
0.9
1.0
1.1
1.2
1.3
INPUT COMMON-MODE VOLTAGE (V)
S
N
R/
S
F
DR
(
d
BF
S
/d
B
c)
SFDR (dBc)
SNR (dBFS)
0
85
39
-04
9
Figure 36. SNR/SFDR vs. Input Common-Mode Voltage,
fIN = 32.1 MHz, fS = 80 MSPS
100
90
80
70
60
50
0.5
0.6
0.7
0.8
0.9
1.0
1.1
1.2
1.3
INPUT COMMON-MODE VOLTAGE (V)
S
N
R/
S
F
DR
(
d
BF
S
/d
B
c)
SFDR (dBc)
SNR (dBFS)
0
85
39
-05
0
Figure 37. SNR/SFDR vs. Input Common-Mode Voltage,
fIN = 10.3 MHz, fS = 20 MSPS
An on-board, common-mode voltage reference is included in
the design and is available from the VCM pin. The VCM pin
must be decoupled to ground by a 0.1 μF capacitor, as described
in the Applications Information section.
相關PDF資料 |
PDF描述 |
|---|---|
| VI-BN2-MW-F2 | CONVERTER MOD DC/DC 15V 100W |
| MS27656E25F61PB | CONN RCPT 61POS WALL MNT W/PINS |
| MS3100A16S-1P | CONN RCPT 7POS WALL MNT W/PINS |
| VI-BN2-MW-F1 | CONVERTER MOD DC/DC 15V 100W |
| LTC2864CS-2#PBF | IC TRANSCEIVER RS485 14-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD9649BCPZRL7-80 | 功能描述:IC ADC 14BIT 80MSPS 32LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
| AD9649W | 功能描述:IC ADC 制造商:analog devices inc. 系列:* 零件狀態:上次購買時間 標準包裝:1 |
| AD9649XCPZ-80 | 功能描述:14 Bit Analog to Digital Converter 1 Input 1 Pipelined 32-LFCSP-WQ (5x5) 制造商:analog devices inc. 系列:- 包裝:托盤 零件狀態:上次購買時間 位數:14 采樣率（每秒）:80M 輸入數:1 輸入類型:差分 數據接口:并聯 配置:S/H-ADC 無線電 - S/H:ADC:1:1 A/D 轉換器數:1 架構:管線 參考類型:內部 電壓 - 電源，模擬:1.7 V ~ 1.9 V 電壓 - 電源，數字:1.7 V ~ 3.6 V 特性:- 工作溫度:-40°C ~ 85°C 封裝/外殼:32-VFQFN 裸露焊盤，CSP 供應商器件封裝:32-LFCSP-WQ（5x5） 標準包裝:1 |
| AD9650 | 制造商:AD 制造商全稱:Analog Devices 功能描述:16-Bit, 25 MSPS/65 MSPS/80 MSPS/105 MSPS, 1.8 V Dual Analog-to-Digital Converter (ADC) |
| AD9650-105EBZ | 功能描述:數據轉換 IC 開發工具 16Bit Hi SNR 105 Msps Dual ADC RoHS:否 制造商:Texas Instruments 產品:Demonstration Kits 類型:ADC 工具用于評估:ADS130E08 接口類型:SPI 工作電源電壓:- 6 V to + 6 V |
發布緊急采購，3分鐘左右您將得到回復。