參數資料
型號： AD8556ARZ-REEL7
廠商： Analog Devices Inc
文件頁數： 8/28頁
文件大?。?/td> 0K
描述： IC AMP CHOPPER 2MHZ 10MA 8SOIC
標準包裝： 1,000
系列： DigiTrim®
放大器類型： 斷路器（零漂移）
電路數： 1
轉換速率： 1.2 V/µs
增益帶寬積： 2MHz
電流 - 輸入偏壓： 49nA
電壓 - 輸入偏移： 2µV
電流 - 電源： 2mA
電流 - 輸出 / 通道： 10mA
電壓 - 電源，單路/雙路(±)： 4.5 V ~ 5.5 V
工作溫度： -40°C ~ 140°C
安裝類型： 表面貼裝
封裝/外殼： 8-SOIC（0.154"，3.90mm 寬）
供應商設備封裝： 8-SO
包裝： 帶卷 (TR)
AD8556
Rev. A | Page 16 of 28
THEORY OF OPERATION
A1, A2, R1, R2, R3, P1, and P2 form the first gain stage of the
differential amplifier. A1 and A2 are auto-zeroed op amps that
minimize input offset errors. P1 and P2 are digital potentiometers,
guaranteed to be monotonic. Programming P1 and P2 allows
the first stage gain to be varied from 4.0 to 6.4 with 7-bit
resolution (see Table 5 and Equation 1), giving a fine gain
adjustment resolution of 0.37%. R1, R2, R3, P1, and P2 each
have a similar temperature coefficient; therefore, the first stage
gain temperature coefficient is lower than 100 ppm/°C.
×
≈
127
4
6.4
4
Code
GAIN1
(1)
A3, R4, R5, R6, R7, P3, and P4 form the second gain stage of
the differential amplifier. A3 is also an auto-zeroed op amp that
minimizes input offset errors. P3 and P4 are digital potentiometers
that allow the second stage gain to be varied from 17.5 to 200 in
eight steps (see Table 6). R4, R5, R6, R7, P3, and P4 each have a
similar temperature coefficient; therefore, the second stage gain
temperature coefficient is lower than 100 ppm/°C.
RF together with an external capacitor, connected between
FILT/DIGOUT and VSS or VDD, form a low-pass filter. The
filtered signal is buffered by A4 to give a low impedance output
at VOUT. RF is nominally 18 kΩ, allowing an 880 Hz low-pass
filter to be implemented by connecting a 10 nF external capacitor
between FILT/DIGOUT and VSS or between FILT/DIGOUT
and VDD. If low-pass filtering is not needed, the FILT/DIGOUT
pin must be left floating.
A5 implements a voltage buffer that provides the positive supply
to A4, the amplifier output buffer. Its function is to limit VOUT
to a maximum value, useful for driving ADCs operating on
supply voltages lower than VDD. The input to A5, VCLAMP,
has a very high input resistance. It should be connected to a
known voltage and not left floating. However, the high input
impedance allows the clamp voltage to be set using a high
impedance source, such as a potential divider. If the maximum
value of VOUT does not need to be limited, VCLAMP should
be connected to VDD.
A4 implements a rail-to-rail input and output unity-gain
voltage buffer. The output stage of A4 is supplied from a
buffered version of VCLAMP instead of VDD, allowing the
positive swing to be limited. The maximum output current is
limited between 5 mA to 10 mA.
An 8-bit DAC is used to generate a variable offset for the
amplifier output. This DAC is guaranteed to be monotonic.
To preserve the ratiometric nature of the input signal, the DAC
references are driven from VSS and VDD, and the DAC output
can swing from VSS (Code 0) to VDD (Code 255). The 8-bit
resolution is equivalent to 0.39% of the difference between
VDD and VSS, for example, 19.5 mV with a 5 V supply. The
DAC output voltage (VDAC) is given approximately by
() VSS
VSS
VDD
Code
VDAC
+
+
≈
256
0.5
(2)
where the temperature coefficient of VDAC is lower than
200 ppm/°C.
The amplifier output voltage (VOUT) is given by
VOUT
= GAIN (VPOS VNEG) + VDAC
(3)
where GAIN is the product of the first and second stage gains.
A3
A2
A4
A5
VDD
DAC
VSS
VDD
VSS
VDD
VSS
VCLAMP
VPOS
VSS
FILT/
DIGOUT
VOUT
A1
VDD
VSS
VNEG
R1
R3
R2
R5
R7
P4
R4
R6
RF
P3
P2
P1
0544
8-
00
1
Figure 47. Functional Schematic
相關PDF資料
PDF描述
GRPB022VWVN-RC CONN HEADER .050" 4POS DL PCB AU
TSW-148-14-G-D CONN HEADER 96POS .100" DL GOLD
TSW-148-08-G-D CONN HEADER 96POS .100" DL GOLD
LTC2053CMS8-SYNC#PBF IC INSTRUMNT AMP R-RIN/OUT 8MSOP
FTS-130-03-L-D CONN HEADER 60POS DUAL .05" T/H
相關代理商/技術參數
參數描述
AD8556CP-EBZ 功能描述:AD8556 DigiTrim? Series 1 - Single Channels per IC Chopper (Zero-Drift) Amplifier Evaluation Board 制造商:analog devices inc. 系列:DigiTrim? 零件狀態:有效 每 IC 通道數:1 - 單 放大器類型:斷路器（零漂移） 輸出類型:單端 壓擺率:1.2 V/μs -3db 帶寬:- 電流 - 輸出/通道:10mA 工作溫度:-40°C ~ 140°C 電流 - 電源（主 IC）:2mA 電壓 - 電源，單/雙（±）:4.5 V ~ 5.5 V 板類型:完全填充 所含物品:板 使用的 IC/零件:AD8556 標準包裝:1
AD8556-EVALZ 制造商:Analog Devices 功能描述:EVALUATION BOARD - Boxed Product (Development Kits)
AD8557 制造商:AD 制造商全稱:Analog Devices 功能描述:Wide Supply Range, Micropower,
AD85571 制造商:AD 制造商全稱:Analog Devices 功能描述:10 MHz, 20 V/レs, G = 1, 10, 100, 1000 i CMOS㈢ Programmable Gain Instrumentation Amplifier
AD8557ACPZ-R2 功能描述:IC AMP CHOPPER 2MHZ 55MA 16LFCSP RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:DigiTrim® 標準包裝:50 系列:- 放大器類型:J-FET 電路數:2 輸出類型:- 轉換速率:13 V/µs 增益帶寬積:3MHz -3db帶寬:- 電流 - 輸入偏壓:65pA 電壓 - 輸入偏移:3000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:- 電壓 - 電源，單路/雙路(±):7 V ~ 36 V，±3.5 V ~ 18 V 工作溫度:-40°C ~ 85°C 安裝類型:通孔 封裝/外殼:8-DIP（0.300"，7.62mm） 供應商設備封裝:8-PDIP 包裝:管件
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*