- 您現在的位置：買賣IC網 > PDF目錄5385 > AD8519ARZ-REEL7 (Analog Devices Inc)IC OPAMP GP R-R 8MHZ 25MA 8SOIC PDF資料下載
參數資料
| 型號： | AD8519ARZ-REEL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 5/16頁 |
| 文件大小： | 0K |
| 描述： | IC OPAMP GP R-R 8MHZ 25MA 8SOIC |
| 產品變化通告： | Product Discontinuance 27/Oct/2011 |
| 標準包裝： | 1,000 |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 2.9 V/µs |
| 增益帶寬積： | 8MHz |
| 電流 - 輸入偏壓： | 300nA |
| 電壓 - 輸入偏移： | 600µV |
| 電流 - 電源： | 600µA |
| 電流 - 輸出 / 通道： | 25mA |
| 電壓 - 電源，單路/雙路(±)： | 2.7 V ~ 12 V，±1.35 V ~ 6 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SO |
| 包裝： | 帶卷 (TR) |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁
AD8519/AD8529
Rev. D | Page 13 of 16
10× MICROPHONE PREAMP MEETS PC99
SPECIFICATIONS
This circuit, while lacking a unique topology, is anything but
featureless when an AD8519 is used as the op amp. This preamp
gives 20 dB gain over a frequency range of 20 Hz to 20 kHz and
is fully PC99 compliant in all parameters including THD + N,
dynamic range, frequency range, amplitude range, and crosstalk.
Not only does this preamp comply with the PC99 specifications,
it far surpasses them. In fact, when the input noise is 120 dB,
this preamp has a VOUT noise of around 100 dB, which is suit-
able for most professional 20-bit audio systems. At 120 dB THD
+ N in unity gain, the AD8519 is suitable for 24-bit professional
audio systems. In other words, the AD8519 will not be the
limiting performance factor in audio systems despite its small
size and low cost.
Slew rate related distortion is not present at the lower voltages
because the AD8519 is so fast at 2.1 V/μs. A general rule of
thumb for determining the necessary slew rate for an audio
system is to take the maximum output voltage range of the
device, given the design’s power rails, and divide by two. In
Figure 24, the power rails are 2.7 V and the output is rail-to-rail.
Enter these numbers into the equation: 2.7/2 = 1.35 V, and the
minimum ideal slew rate is 1.35 V/μs.
While this data sheet gives only one audio example, many audio
circuits are enhanced with the use of the AD8519. Examples
include: active audio filters such as bass, treble, and equalizers;
PWM filters at the output of audio DACs; buffers and summers
for mixing stations; and gain stages for volume control.
1k
AD8519
2.7V
30.9k
2.7V
3.09k
46.4k
93.1k
2.7V
240pF
48k
CODEC LINE IN
OR MIC IN
10F ELECT
MIC
IN
1nF
NPO
C1
1F
01
75
6-
0
24
Figure 24. 10× Microphone Preamplifier
TWO-ELEMENT VARYING BRIDGE AMPLIFIER
There are a host of bridge configurations available to designers.
For a complete analysis, look at the ubiquitous bridge and its
different forms. Refer to the 1992 Amplifier Applications Guide1.
Figure 25 is a schematic of a two-element varying bridge. This
configuration is commonly found in pressure and flow transduc-
ers. With a two-element varying bridge, the signal is 2× as
compared to a single-element varying bridge. The advantages
of this type of bridge are gain setting range and single-supply
application. Negative characteristics are nonlinear operation
and required R matching. Given these sets of conditions,
requirements, and characteristics, the AD8519 can be successfully
used in this configuration because of its rail-to-rail output and
low offset. Perhaps the greatest benefits of the AD8519, when
used in the bridge configuration, are the advantages it can bring
when placed in a remote bridge sensor. For example, the tiny
SC70 and SOT-23 packages reduce the overall sensor size; low
power allows for remote powering via batteries or solar cells,
high output current drive to drive a long cable; and 2.7 V
operation for two-cell operation.
R
AD8519
2.7V
RF
0
17
56
-0
25
Figure 25. Two-Element Varying Bridge Amplifier
1 Adolfo Garcia and James Wong, Chapter 2, 1992, Amplifier Applications Guide.
相關PDF資料 |
PDF描述 |
|---|---|
| 1-338068-2 | CONN FMALE-ON-BRD 12POS VERT T/H |
| 0034.7105 | MSTU 100MA 250V FST 18.8MM PC |
| MMD21-0111H1 | CONN RACK/PANEL 11POS 5A |
| 0034.7124 | FUSE 8A 250V 8.5X8.5 T 4.3 |
| MMD25-0071H1 | CONN RACK/PANEL 7POS 5A |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8522 | 制造商:AD 制造商全稱:Analog Devices 功能描述:+5 Volt, Serial Input, Dual 12-Bit DAC |
| AD8522ACPZ-REEL | 功能描述:IC DAC DUAL 12BIT 5V 制造商:analog devices inc. 系列:- 零件狀態:上次購買時間 標準包裝:1 |
| AD8522ACPZ-REEL7 | 功能描述:IC DAC DUAL 12BIT 5V 制造商:analog devices inc. 系列:- 零件狀態:上次購買時間 標準包裝:1 |
| AD8522AN | 功能描述:IC DAC DUAL 12BIT 5V 14-DIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 標準包裝:750 系列:- 設置時間:7µs 位數:16 數據接口:并聯 轉換器數目:1 電壓電源:雙 ± 功率耗散（最大）:100mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-LCC（J 形引線） 供應商設備封裝:28-PLCC（11.51x11.51） 包裝:帶卷 (TR) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:143k |
| AD8522AN | 制造商:Analog Devices 功能描述:SEMICONDUCTORSLINEAR |
發布緊急采購，3分鐘左右您將得到回復。