- 您現在的位置：買賣IC網 > PDF目錄2137 > AD841SE (Analog Devices Inc)IC OPAMP GP 40MHZ 50MA 20CLCC PDF資料下載
參數資料
| 型號： | AD841SE |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 4/16頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP GP 40MHZ 50MA 20CLCC |
| 標準包裝： | 1 |
| 放大器類型： | 通用 |
| 電路數： | 1 |
| 轉換速率： | 300 V/µs |
| 增益帶寬積： | 40MHz |
| 電流 - 輸入偏壓： | 3.5µA |
| 電壓 - 輸入偏移： | 500µV |
| 電流 - 電源： | 11mA |
| 電流 - 輸出 / 通道： | 50mA |
| 電壓 - 電源，單路/雙路(±)： | ±5 V ~ 18 V |
| 工作溫度： | -55°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-CLCC |
| 供應商設備封裝： | 20-LCCC |
| 包裝： | 管件 |
AD841
Data Sheet
Rev. C | Page 12 of 16
TERMINATED LINE DRIVER
The AD841 functions very well as a high speed line driver of
either terminated or unterminated cables. Figure 33 shows the
AD841 driving a doubly terminated cable in a follower config-
uration. The AD841 maintains a typical slew rate of 300 V/s,
which means it can drive a ±10 V, 4.7 MHz signal or a ±3 V,
15.9 MHz signal.
The termination resistor, RT, (when equal to the characteristic
impedance of the cable) minimizes reflections from the far end
of the cable. A back-termination resistor, RBT, (also equal to the
characteristic impedance of the cable) may be placed between
the AD841 output and the cable to damp any stray signals
caused by a mismatch between RT and the cable’s characteristic
impedance. This results in a cleaner signal, but because half the
output voltage is dropped across RBT, the op amp must supply
double the output signal required if there is no back termina-
tion. Therefore, the full power bandwidth is cut in half.
If termination is not used, cables appear as capacitive loads. If
this capacitive load is large, it should be decoupled from the
AD841 by a resistor in series with the output (see Figure 32).
Figure 33. Line Driver Configuration
OVERDRIVE RECOVERY
Figure 34 shows the overdrive recovery capability of the AD841.
Typical recovery time is 200 ns from negative overdrive and
700 ns from positive overdrive.
Figure 34. Overdrive Recovery
Figure 35. Overdrive Recovery Test Circuit
11
6
4
5
10
–
+
AD841
+VS
–VS
2.2F
0.1F
2.2F
0.1F
TERMINATION
RESISTOR
FOR INPUT
SIGNAL
RB
100
VIN
RBT
(OPTIONAL)
RT
VOUT
50 OR
75 CABLE
RT = RBT = CABLE CHARACTERISTIC IMPEDANCE
1
1340-
033
100
90
10
0%
10V
200ns
1V
OVERDRIVEN
OUTPUT: 10V/DIV
INPUT SQUARE
WAVE: 1V/DIV
1
1340-
034
11
6
4
5
10
–
+
AD841
+VS
–VS
2.2F
0.1F
2.2F
0.1F
OUTPUT
1k
50
HP3314A
PULSE GENERATOR
OR EQUIVALENT
1s ± 1V SQUARE
WAVE INPUT
1
1340-
035
相關PDF資料 |
PDF描述 |
|---|---|
| AD8420ARMZ-R7 | IC AMP INSTR RR 2.5KHZ 8MSOP |
| AD8421BRMZ | IC OP AMP INSTRUMENTATION 8MSOP |
| AD8426ACPZ-R7 | IC AMP INSTR RR 1.5MHZ 16LFCSP |
| AD8428BRZ | IC OPAMP INST 3.5MHZ LN 8SOIC |
| AD8429BRZ-R7 | IC OP AMP INST LOW NOISE 8SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD841SE/883B | 功能描述:高速運算放大器 FAST SETTLING H.S. OP AMP RoHS:否 制造商:Texas Instruments 通道數量:1 電壓增益 dB:116 dB 輸入補償電壓:0.5 mV 轉換速度:55 V/us 工作電源電壓:36 V 電源電流:7.5 mA 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube 產品: |
| AD841SEZ | 制造商:Analog Devices 功能描述:OP Amp Single GP ±18V 20-Pin LCC |
| AD841SH | 制造商:Analog Devices 功能描述:OP Amp Single GP 制造商:Rochester Electronics LLC 功能描述:FAST SETTLING H.S. OP AMP - Bulk |
| AD841SH/883B | 制造商:Analog Devices 功能描述:OP Amp Single GP 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| AD841SHZ | 制造商:Analog Devices 功能描述:OP Amp Single GP 制造商:Analog Devices 功能描述:OP Amp Single GP ±18V 12-Pin TO-8 |
發布緊急采購，3分鐘左右您將得到回復。