- 您現在的位置：買賣IC網 > PDF目錄5292 > AD8052ARZ-REEL7 (Analog Devices Inc)IC OPAMP VF R-R DUAL LDIST 8SOIC PDF資料下載
參數資料
| 型號： | AD8052ARZ-REEL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 11/25頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC OPAMP VF R-R DUAL LDIST 8SOIC |
| 標準包裝： | 750 |
| 放大器類型： | 電壓反饋 |
| 電路數： | 2 |
| 輸出類型： | 滿擺幅 |
| 轉換速率： | 170 V/µs |
| -3db帶寬： | 110MHz |
| 電流 - 輸入偏壓： | 1.4µA |
| 電壓 - 輸入偏移： | 1800µV |
| 電流 - 電源： | 4.8mA |
| 電流 - 輸出 / 通道： | 45mA |
| 電壓 - 電源，單路/雙路(±)： | 3 V ~ 12 V，±1.5 V ~ 6 V |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SO |
| 包裝： | 帶卷 (TR) |
AD8051/AD8052/AD8054
Rev. J | Page 18 of 24
LAYOUT CONSIDERATIONS
The specified high speed performance of the AD8051/AD8052/
AD8054 requires careful attention to board layout and component
selection. Proper RF design techniques and low parasitic
component selection are necessary.
The PCB should have a ground plane covering all unused
portions of the component side of the board to provide a low
impedance path. The ground plane should be removed from the
area near the input pins to reduce parasitic capacitance.
Chip capacitors should be used for supply bypassing. One end
should be connected to the ground plane and the other within
3 mm of each power pin. An additional large (4.7 μF to 10 μF)
tantalum electrolytic capacitor should be connected in parallel,
but not necessarily so close, to supply current for fast, large
signal changes at the output.
The feedback resistor should be located close to the inverting
input pin to keep the parasitic capacitance at this node to a
minimum. Parasitic capacitance of less than 1 pF at the inverting
input can significantly affect high speed performance.
Stripline design techniques should be used for long signal traces
(greater than about 25 mm). These should be designed with a
characteristic impedance of 50 Ω or 75 Ω and be properly
terminated at each end.
ACTIVE FILTERS
Active filters at higher frequencies require wider bandwidth op
amps to work effectively. Excessive phase shift produced by
lower frequency op amps can significantly affect active filter
performance.
Figure 46 shows an example of a 2 MHz biquad bandwidth filter
that uses three op amps of an AD8054. Such circuits are
sometimes used in medical ultrasound systems to lower the
noise bandwidth of the analog signal before analog-to-digital
conversion.
Note that the unused amplifier’s inputs should be tied to ground.
12
13
14
2
1
6
5
7
9
10
8
AD8054
3
AD8054
R6
1k
R4
2k
R3
2k
R5
2k
R2
2k
R1
3k
C1
50pF
C2
50pF
VIN
BAND-PASS
FILTER OUTPUT
01062-
046
Figure 46. 2 MHz Biquad Band-Pass Filter Using AD8054
The frequency response of the circuit is shown in Figure 47.
FREQUENCY (Hz)
0
–10
–20
–30
–40
GA
IN
(
d
B
)
10k
100k
1M
10M
100M
01
06
2-
04
7
Figure 47. Frequency Response of 2 MHz Band-Pass Biquad Filter
相關PDF資料 |
PDF描述 |
|---|---|
| PPPC141LGBN-RC | CONN FEMALE 14POS .100" R/A GOLD |
| LT6200IS6-5#TR | IC OP AMP 800MHZ R-R I/O SOT23-6 |
| NPPN031FGGN-RC | CONN RECEPT 2MM SINGLE R/A 3POS |
| LT6200IS6-10#TRPBF | IC OP AMP 1.6GHZ R-R I/O SOT23-6 |
| LT6200IS6-10#TR | IC OP AMP 1.6GHZ R-R I/O SOT23-6 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD8052LV | 制造商:CADEKA 制造商全稱:CADEKA 功能描述:Low Cost, +2.7V to 5.5V, 260MHz Rail-to-Rail Amplifier |
| AD8052LVIMP8X | 制造商:CADEKA 制造商全稱:CADEKA 功能描述:Low Cost, +2.7V to 5.5V, 260MHz Rail-to-Rail Amplifier |
| AD8052LVISO8 | 制造商:CADEKA 制造商全稱:CADEKA 功能描述:Low Cost, +2.7V to 5.5V, 260MHz Rail-to-Rail Amplifier |
| AD8052LVISO8X | 功能描述:儀表放大器 DUAL VOLTAGE FEEDBCK RAIL TO RAIL RoHS:否 制造商:Texas Instruments 通道數量: 輸入補償電壓:150 V 可用增益調整: 最大輸入電阻:10 kOhms 共模抑制比（最小值）:88 dB 工作電源電壓:2.7 V to 36 V 電源電流:200 uA 最大工作溫度:+ 125 C 最小工作溫度:- 40 C 封裝 / 箱體:MSOP-8 封裝:Bulk |
| AD8052RM | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Voltage-Feedback Operational Amplifier |
發布緊急采購，3分鐘左右您將得到回復。