參數資料
型號: AD8010ARZ-16
廠商: Analog Devices Inc
文件頁數: 3/12頁
文件大小: 0K
描述: IC OPAMP CF 200MA LP 16SOIC
標準包裝: 47
放大器類型: 電流反饋
電路數: 1
轉換速率: 800 V/µs
-3db帶寬: 230MHz
電流 - 輸入偏壓: 10µA
電壓 - 輸入偏移: 5000µV
電流 - 電源: 15.5mA
電流 - 輸出 / 通道: 200mA
電壓 - 電源,單路/雙路(±): 9 V ~ 12 V,±4.5 V ~ 6 V
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: 16-SOIC(0.295",7.50mm 寬)
供應商設備封裝: 16-SOIC W
包裝: 管件
AD8010
–11–
REV. B
Table I. –3 dB Bandwidth and Slew Rate vs. Closed-Loop
Gain and Resistor Values
Package: N-8
Closed-Loop
–3 dB BW
Slew Rate
Gain
RF ( )RG ( )
(MHz)
(V/ s)
+1
453
285
900
+2
374
255
900
+5
348
86.6
200
800
+10
562
61.9
120
550
Package: R-16
Closed-Loop
–3 dB BW
Slew Rate
Gain
RF ( )RG ( )
(MHz)
(V/ s)
+1
412
245
900
+2
392
220
900
+5
392
97.6
160
800
+10
604
66.5
95
550
Package: SO-8
Closed-Loop
–3 dB BW
Slew Rate
Gain
RF ( )RG ( )
(MHz)
(V/ s)
+1
392
345
950
+2
374
305
1000
+5
348
86.6
220
1000
+10
499
54.9
135
650
1. VO = 0.2 V p-p for –3 dB Bandwidth.
2. VO = 2 V p-p for Slew Rate.
3. Bypassing per Figure 29.
150
50
RF
RG
VOUT
18.75
VIN
Figure 32. Test Circuit for Table I
Closed-Loop Gain and Bandwidth
The AD8010 is a current feedback amplifier optimized for use
in high performance video and data acquisition applications.
Since it uses a current feedback architecture, its closed-loop
–3 dB bandwidth is dependent on the magnitude of the feedback
resistor. The desired closed-loop bandwidth and gain are obtained
by varying the feedback resistor (RF) to set the bandwidth, and
varying the gain resistor (RG) to set the desired gain. The char-
acteristic curves and specifications for this data sheet reflect the
performance of the AD8010 using the values of RF noted at the
top of the specifications table. If a greater –3 dB bandwidth
and/or slew rate is required (at the expense of video performance),
Table I provides the recommended resistor values. Figure 32
shows the test circuit and conditions used to produce Table I.
Effect of Feedback Resistor Tolerance on Gain Flatness
Because of the relationship between the 3 dB bandwidth and the
feedback resistor, the fine scale gain flatness will, to some extent,
vary with feedback resistor tolerance. It is therefore recommended
that resistors with a 1% tolerance be used if it is desired to main-
tain flatness over a wide range of production lots. In addition,
resistors of different construction have different associated para-
sitic capacitance and inductance. Metal-film resistors were used
for the bulk of the characterization for this data sheet. It is pos-
sible that values other than those indicated will be optimal for
other resistor types.
Quality of Coaxial Cable
Optimum flatness when driving a coax cable is possible only
when the driven cable is terminated at each end with a resistor
matching its characteristic impedance. If the coax was ideal,
then the resulting flatness would not be affected by the length of
the cable. While outstanding results can be achieved using inex-
pensive cables, it should be noted that some variation in flatness
due to varying cable lengths may be experienced.
相關PDF資料
PDF描述
AD8011ARZ-REEL IC OPAMP CF LP LDIST 30MA 8SOIC
AD8012ARZ-REEL7 IC OPAMP CF DUAL LP 125MA 8SOIC
AD8014AR IC OPAMP CF LP LN LDIST 8SOIC
AD8015AR IC AMP TRANSIMPEDANCE 8-SOIC
AD8017ARZ-REEL IC AMP GP DUAL LP LDIST 8SOIC
相關代理商/技術參數
參數描述
AD8010ARZ-16-REEL 制造商:Analog Devices 功能描述:ADSL Driver Single 16-Pin SOIC W T/R 制造商:Rochester Electronics LLC 功能描述:- Tape and Reel
AD8010ARZ-16-REEL7 功能描述:IC OPAMP CF 200MA LP 16SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:150 系列:- 放大器類型:音頻 電路數:2 輸出類型:- 轉換速率:5 V/µs 增益帶寬積:12MHz -3db帶寬:- 電流 - 輸入偏壓:100nA 電壓 - 輸入偏移:500µV 電流 - 電源:6mA 電流 - 輸出 / 通道:50mA 電壓 - 電源,單路/雙路(±):4 V ~ 32 V,±2 V ~ 16 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP(0.173",4.40mm 寬) 供應商設備封裝:8-TSSOP 包裝:管件
AD8010ARZ-REEL 制造商:Analog Devices 功能描述:ADSL Driver Single 8-Pin SOIC N T/R
AD8011 制造商:AD 制造商全稱:Analog Devices 功能描述:300 MHz, 1 mA Current Feedback Amplifier