- 您現在的位置：買賣IC網 > PDF目錄10356 > AD7920AKSZ-REEL7 (Analog Devices Inc)IC ADC 12BIT SRL 250KSPS SC70-6 PDF資料下載
參數資料
| 型號： | AD7920AKSZ-REEL7 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 9/24頁 |
| 文件大小： | 0K |
| 描述： | IC ADC 12BIT SRL 250KSPS SC70-6 |
| 標準包裝： | 3,000 |
| 位數： | 12 |
| 采樣率（每秒）： | 250k |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 15mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 6-TSSOP，SC-88，SOT-363 |
| 供應商設備封裝： | SC-70-6 |
| 包裝： | 帶卷 (TR) |
| 輸入數目和類型： | 1 個單端，單極 |
| 配用： | EVAL-AD7920CBZ-ND - BOARD EVALUATION FOR AD7920 |
AD7910/AD7920
Rev. C | Page 17 of 24
VALID DATA
CS
SCLK
SDATA
110
12
14
16
AD7910/AD7920
02976-019
Figure 19. Normal Mode Operation
THREE-STATE
SDATA
SCLK
CS
110
12
14
16
2
02976-020
Figure 20. Entering Power-Down Mode
SCLK
CS
SDATA
THE PART
BEGINS TO
POWER UP
THE PART IS FULLY
POWERED UP WITH
VIN FULLY ACQUIRED
A
10
12
14
16
1
16
VALID DATA
INVALID DATA
02976-021
1
Figure 21. Exiting Power-Down Mode
When power supplies are first applied to the AD7910/AD7920, the
ADC can power up in either power-down mode or in normal
mode. Because of this, it is best to allow a dummy cycle to elapse to
ensure the part is fully powered up before attempting a valid
conversion. Likewise, if the intention is to keep the part in power-
down mode while not in use and the user wishes the part to power
up in power-down mode, the dummy cycle can be used to ensure
the device is in power-down mode by executing a cycle such as that
shown in Figure 20. Once supplies are applied to the
AD7910/AD7920, the power-up time is the same as that when
powering up from power-down mode. It takes approximately 1 μs
to power up fully if the part powers up in normal mode. It is not
necessary to wait 1 μs before executing a dummy cycle to ensure
the desired mode of operation.
Instead, the dummy cycle can occur directly after power is
supplied to the ADC. If the first valid conversion is performed
directly after the dummy conversion, care must be taken to
ensure that adequate acquisition time is allowed. As mentioned
earlier, when powering up from the power-down mode, the part
returns to track upon the first SCLK edge applied after the
falling edge of CS. However, when the ADC powers up initially
after supplies are applied, the track-and-hold is in track. This
means, assuming the user has the facility to monitor the ADC
supply current, if the ADC powers up in the desired mode of
operation and thus a dummy cycle is not required to change
mode then a dummy cycle is required to place the track-and-
hold into track.
相關PDF資料 |
PDF描述 |
|---|---|
| VE-J5P-MX | CONVERTER MOD DC/DC 13.8V 75W |
| VI-BNR-IV-F4 | CONVERTER MOD DC/DC 7.5V 150W |
| D38999/26WB5SNLC | CONN HSG PLUG 5POS STRGHT SCKT |
| MS3106A20-25P | CONN PLUG 13POS STRAIGHT W/PINS |
| D38999/20WC4PNLC | CONN HSG RCPT 4POS WALL MT PINS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7920BKS | 制造商:AD 制造商全稱:Analog Devices 功能描述:250 kSPS, 10-/12-Bit ADCs in 6-Lead SC70 |
| AD7920BKS-500RL7 | 制造商:Analog Devices 功能描述:ADC Single SAR 250ksps 12-bit Serial 6-Pin SC-70 T/R 制造商:Rochester Electronics LLC 功能描述:12-BIT 250KSPS,ADC SC70 PKG I.C. - Bulk |
| AD7920BKS-REEL | 制造商:AD 制造商全稱:Analog Devices 功能描述:250 kSPS, 10-/12-Bit ADCs in 6-Lead SC70 |
| AD7920BKS-REEL7 | 制造商:Analog Devices 功能描述:ADC Single SAR 250ksps 12-bit Serial 6-Pin SC-70 T/R |
| AD7920BKSZ-500RL7 | 功能描述:IC ADC 12BIT SRL 250KSPS SC70-6 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:microPOWER™ 位數:8 采樣率（每秒）:1M 數據接口:串行，SPI? 轉換器數目:1 功率耗散（最大）:- 電壓電源:模擬和數字 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:24-VFQFN 裸露焊盤 供應商設備封裝:24-VQFN 裸露焊盤（4x4） 包裝:Digi-Reel® 輸入數目和類型:8 個單端，單極 產品目錄頁面:892 (CN2011-ZH PDF) 其它名稱:296-25851-6 |
發布緊急采購，3分鐘左右您將得到回復。