參數資料
型號: AD7911AUJZ-R2
廠商: Analog Devices Inc
文件頁數: 13/28頁
文件大?。?/td> 0K
描述: IC ADC 10BIT 250KSPS TSOT23-8
標準包裝: 1
位數: 10
采樣率(每秒): 250k
數據接口: DSP,MICROWIRE?,QSPI?,串行,SPI?
轉換器數目: 1
功率耗散(最大): 20mW
電壓電源: 單電源
工作溫度: -40°C ~ 85°C
安裝類型: 表面貼裝
封裝/外殼: SOT-23-8 薄型,TSOT-23-8
供應商設備封裝: TSOT-23-8
包裝: 標準包裝
輸入數目和類型: 2 個單端,單極
其它名稱: AD7911AUJZ-R2DKR
AD7911/AD7921
Rev. A | Page 20 of 28
POWER VS. THROUGHPUT RATE
By using the power-down mode on the AD7911/AD7921 when
not converting, the average power consumption of the ADC
decreases at lower throughput rates. Figure 29 shows how, as the
throughput rate is reduced, the device remains in its power-
down state longer and the average power consumption over
time drops accordingly.
For example, if the AD7911/AD7921 are operating in a
continuous sampling mode with a throughput rate of 50 kSPS
and a SCLK of 5 MHz (VDD = 5 V) and the devices are placed in
power-down mode between conversions, then the power
consumption is calculated as follows. The power dissipation
during normal operation is 20 mW (VDD = 5 V). If one dummy
cycle powers up the part between conversions (3.2 μs), and the
remaining conversion time is another cycle (3.2 μs), then the
AD7911/AD7921 dissipate 20 mW for 6.4 μs during each
conversion cycle. If the throughput rate is 50 kSPS and the cycle
time is 20 μs, then the average power dissipated during each
cycle is
(6.4/20) × (20 mW) = 6.4 mW
If VDD = 3 V, SCLK= 5 MHz, and the device is again in power-
down mode between conversions, then the power dissipation
during normal operation is 6 mW. The AD7911/AD7921 now
dissipate 6 mW for 6.4 μs during each conversion cycle. With a
throughput rate of 50 kSPS, the average power dissipated during
each cycle is
(6.4/20) × (6 mW) = 1.92 mW
In the previous examples, the power dissipation when the part
is in power-down mode has not been taken into account,
because the shutdown current is so low that it does not have any
effect on the overall power dissipation value. Figure 29 shows
the power consumption versus throughput rate when using the
power-down mode between conversions with both 5 V and 3 V
supplies.
Power-down mode is intended for use with throughput rates of
approximately 120 kSPS and under, because higher sampling
rates do not have a power saving in power-down mode.
0.01
100
10
1
0.1
0
135
120
105
90
75
60
45
30
15
04350-0-035
THROUGHPUT (kSPS)
P
O
WE
R
(mW)
VDD = 5V, SCLK = 5MHz
VDD = 3V, SCLK = 5MHz
Figure 29. Power Consumption vs. Throughput Rate
相關PDF資料
PDF描述
MS27467T11F35SA CONN PLUG 13POS STRAIGHT W/SCKT
LTC2430CGN#PBF IC ADC 20BIT DIFFINPUT/REF16SSOP
LTC2430CGN IC ADC 20BIT DIFFINPUT/REF16SSOP
AD7914BRUZ-REEL7 IC ADC 10BIT 4CH W/SEQ 16TSSOP
MS27473T14C35S CONN PLUG 37POS STRAIGHT W/SCKT
相關代理商/技術參數
參數描述
AD7911AUJZ-REEL7 功能描述:IC ADC 10BIT 250KSPS TSOT23-8 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:2,500 系列:- 位數:16 采樣率(每秒):15 數據接口:MICROWIRE?,串行,SPI? 轉換器數目:1 功率耗散(最大):480µW 電壓電源:單電源 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:38-WFQFN 裸露焊盤 供應商設備封裝:38-QFN(5x7) 包裝:帶卷 (TR) 輸入數目和類型:16 個單端,雙極;8 個差分,雙極 配用:DC1011A-C-ND - BOARD DELTA SIGMA ADC LTC2494
AD7912 制造商:AD 制造商全稱:Analog Devices 功能描述:2-Channel, 2.35 V to 5.25 V, 1 MSPS, 10-/12-Bit ADCs
AD7912ARM 制造商:Analog Devices 功能描述:ADC Single SAR 1Msps 10-bit Serial 8-Pin MSOP 制造商:Rochester Electronics LLC 功能描述:DUAL 10-BIT, 1MSPS, ADC I.C - Bulk 制造商:Analog Devices 功能描述:10BIT ADC DUAL SMD 7912 MSOP8
AD7912ARM-REEL 制造商:Analog Devices 功能描述:ADC Single SAR 1Msps 10-bit Serial 8-Pin MSOP T/R 制造商:Analog Devices 功能描述:ADC SGL SAR 1MSPS 10-BIT SERL 8MSOP - Tape and Reel
AD7912ARM-REEL7 制造商:Analog Devices 功能描述:ADC Single SAR 1Msps 10-bit Serial 8-Pin MSOP T/R 制造商:Analog Devices 功能描述:ADC SGL SAR 1MSPS 10-BIT SERL 8MSOP - Tape and Reel 制造商:Rochester Electronics LLC 功能描述:DUAL 10-BIT, 1MSPS, ADC I.C - Tape and Reel