- 您現在的位置：買賣IC網 > PDF目錄1984 > AD7854BRZ (Analog Devices Inc)IC ADC 12BIT PARALLEL LP 28-SOIC PDF資料下載
參數資料
| 型號： | AD7854BRZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 2/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 12BIT PARALLEL LP 28-SOIC |
| 產品變化通告： | Product Discontinuance 27/Oct/2011 |
| 標準包裝： | 27 |
| 位數： | 12 |
| 采樣率（每秒）： | 200k |
| 數據接口： | 并聯 |
| 轉換器數目： | 2 |
| 功率耗散（最大）： | 30mW |
| 電壓電源： | 模擬和數字 |
| 工作溫度： | -40°C ~ 85°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 28-SOIC（0.295"，7.50mm 寬） |
| 供應商設備封裝： | 28-SOIC W |
| 包裝： | 管件 |
| 輸入數目和類型： | 1 個偽差分，單極；1 個偽差分，雙極 |
第1頁當前第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
AD7854/AD7854L
–10–
REV. B
STATUS REGISTER
The arrangement of the status register is shown below. The status register is a read-only register and contains 16 bits of data. The
status register is selected by writing to the control register and putting two 1s in RDSLT1 and RDSLT0. The function of the bits in
the status register are described below. The power-up status of all bits is 0.
START
READ STATUS REGISTER
WRITE TO CONTROL REGISTER
SETTING RDSLT0 = RDSLT1 = 1
Figure 4. Flowchart for Reading the Status Register
MSB
ZERO
PMGT1
PMGT0
ONE
AMODE
BUSY
CALMD
CALSLT1
CALSLT0
STCAL
LSB
Status Register Bit Function Description
Bit
Mnemonic
Comment
15
ZERO
These six bits are always 0.
14
ZERO
13
ZERO
12
ZERO
11
ZERO
10
ZERO
9
PMGT1
Power Management Bits. These bits will indicate if the part is in a power-down mode or not. See Table VI
8
PMGT0
in Power-Down Section for description.
7
ONE
Both these bits are always 1.
6
ONE
5
AMODE
Analog Mode Bit. When this bit is a 0, the device is set up for the unipolar analog input range. When this
bit is a 1, the device is set up for the bipolar analog input range.
4
BUSY
Conversion/Calibration Busy Bit. When this bit is 1, this indicates that there is a conversion or calibration
in progress. When this bit is 0, there is no conversion or calibration in progress.
3
CALMD
Calibration Mode Bit. A 0 in this bit indicates a self-calibration is selected, and a 1 in this bit indicates a
system calibration is selected (see Table III).
2
CALSLT1
Calibration Selection Bits and Start Calibration Bit. The STCAL bit is read as a 1 if a calibration is in
1
CALSLT0
progress and as a 0 if there is no calibration in progress. The CALSLT1 and CALSLT0 bits indicate
0
STCAL
which of the calibration registers are addressed for reading and writing (see section on the Calibration
Registers for more details).
相關PDF資料 |
PDF描述 |
|---|---|
| AD7856ARZ-REEL7 | IC ADC 14BIT 8CHAN 5V 24SOIC |
| AD7858LBNZ | IC ADC 12BIT 8CHAN SRL 24DIP |
| AD7859BSZ | IC ADC 12BIT 8CHAN LP 44-MQFP |
| AD7861AP | IC ADC 11BIT 4CH 44-PLCC |
| AD7862BRZ-10 | IC ADC 12BIT DUAL 250KSPS 28SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7854L | 制造商:AD 制造商全稱:Analog Devices 功能描述:3 V to 5 V Single Supply, 200 kSPS 12-Bit Sampling ADCs |
| AD7854LAQ | 制造商:Rochester Electronics LLC 功能描述:12 BIT SINGLE CHANNEL PARALLEL ADC I.C. - Bulk |
| AD7854LAR | 制造商:Analog Devices 功能描述:ADC Single SAR 100ksps 12-bit Parallel 28-Pin SOIC W 制造商:Rochester Electronics LLC 功能描述:12-BIT SINGLE CHANNEL PARALLEL ADC I.C. - Bulk |
| AD7854LAR-REEL | 制造商:Analog Devices 功能描述:ADC Single SAR 100ksps 12-bit Parallel 28-Pin SOIC W T/R 制造商:Analog Devices 功能描述:ADC SGL SAR 100KSPS 12-BIT PARALLEL 28SOIC W - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。