- 您現在的位置：買賣IC網 > PDF目錄1983 > AD7827BRZ (Analog Devices Inc)IC ADC 8BIT SAMPLING SRL 8SOIC PDF資料下載
參數資料
| 型號： | AD7827BRZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 10/12頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC ADC 8BIT SAMPLING SRL 8SOIC |
| 產品變化通告： | AD7827 Series Discontinuation 18/Jul/2012 |
| 標準包裝： | 98 |
| 位數： | 8 |
| 采樣率（每秒）： | 1M |
| 數據接口： | DSP，串行 |
| 轉換器數目： | 1 |
| 功率耗散（最大）： | 30mW |
| 電壓電源： | 單電源 |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 8-SOIC（0.154"，3.90mm 寬） |
| 供應商設備封裝： | 8-SOIC |
| 包裝： | 管件 |
| 輸入數目和類型： | 1 個單端，單極 |
AD7827
–7–
REV. 0
ADC TRANSFER FUNCTION
The output coding of the AD7827 is straight binary. The
designed code transitions occur at successive integer LSB
values (i.e., 1 LSB, 2 LSBs, etc.). The LSB size is = VREF/256
(VDD = 5 V) or the LSB size = (0.8 VREF)/256 (VDD = 3 V). The
ideal transfer characteristic for the AD7827 is shown in Figure 6
below.
(VDD = 5V)
1LSB = VREF/256
(VDD = 3V)
1LSB = 0.8VREF/256
1LSB (VDD = 5V) VREF/2
(VDD = 3V) 0.8VREF/2
VREF/2+1.25V – 1LSB
0.8VREF/2+1V – 1LSB
(VDD = 5V) VREF/2 – 1.25V
(VDD = 3V) 0.8VREF/2 – 1V
11111111
111....110
111....000
10000000
000....111
000....010
000....001
00000000
ADC
CODE
Figure 6. Transfer Characteristic
ANALOG INPUT
The AD7827 has a single input channel with an input range of
0 V to 2.5 V or 0 V to 2.0 V, depending on the supply voltage
(VDD). This input range is automatically set up by an on-chip
“VDD detector” circuit. 5 V operation of the ADC is detected
when VDD exceeds 4.1 V and 3 V operation is detected when
VDD falls below 3.8 V. This circuit also possesses a degree of
glitch rejection; for example, a glitch from 5.5 V to 2.7 V up to
60 ns wide will not trip the VDD detector.
Note: Although there is a VREF pin from which a voltage refer-
ence of 2.5 V may be sourced, or to which an external reference
may be applied, this does not provide an option of varying the value
of the voltage reference. As stated in the specifications for the
AD7827, the input voltage range at this pin is 2.5 V
± 2%.
Analog Input Structure
Figure 7 shows an equivalent circuit of the analog input struc-
ture of the AD7827. The two diodes, D1 and D2, provide ESD
protection for the analog inputs. Care must be taken to ensure
that the analog input signal never exceeds the supply rails by
more than 200 mV. This will cause these diodes to become
forward biased and start conducting current into the substrate.
The maximum current these diodes can conduct without caus-
ing irreversible damage to the part is 20 mA. The capacitor C2
in Figure 7 is typically about 4 pF and can mostly be attributed
to pin capacitance. The resistor R1 is a lumped component
made up of the on resistance of several components including
that of the multiplexer and the track-and-hold. This resistor is
typically about 310
. The capacitor C1 is the track-and-hold
capacitor and has a capacitance of 0.5 pF. Switch 1 is the track-
and-hold switch, while Switch 2 is that of the sampling capaci-
tor as shown in Figures 2 and 3.
When in track phase, Switch 1 is closed and Switch 2 is in
Position A. When in hold mode, Switch 1 opens while Switch 2
remains in Position A. The track-and-hold remains in hold
mode for 120 ns—see Circuit Description, after which it returns
to track mode and the ADC enters its conversion phase. At this
point Switch 1 opens and Switch 2 moves to Position B. At the
end of the conversion Switch 2 moves back to Position A.
VDD
VIN
D1
R1
310
D2
SW1
C1
0.5pF
A
B
SW2
C2
4pF
Figure 7. Equivalent Analog Input Circuit
The on-chip track-and-hold can accommodate input frequen-
cies to 10 MHz, making the AD7827 ideal for subsampling
applications. When the AD7827 is converting a 10 MHz input
signal at a sampling rate of 1 MSPS, the effective number of
bits typically remains above seven corresponding to a signal-to-
noise ratio of 42 dBs as shown in Figure 8.
INPUT FREQUENCY – MHz
50
38
0.2
10
134
5
6
8
48
46
44
42
40
FSAMPLE = 1MHz
SNR
–
dB
Figure 8. SNR vs. Input Frequency On the AD7827
相關PDF資料 |
PDF描述 |
|---|---|
| AD7828LPZ-REEL | IC ADC 8BIT 8CH HS 28-PLCC |
| AD7829BRW-1 | IC ADC 8BIT 8CH 2MSPS 28-SOIC |
| AD7834BR | IC DAC 14BIT QUAD SRL 28-SOIC |
| AD7836ASZ | IC DAC 14BIT QUAD LC2MOS 44MQFP |
| AD7837BQ | IC DAC 12BIT DUAL MULT 24-CDIP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7827BRZ-REEL | 功能描述:IC ADC 8BIT SAMPLING SRL 8SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
| AD7827BRZ-REEL7 | 功能描述:IC ADC 8BIT SAMPLING SRL 8SOIC RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
| AD7828 | 制造商:AD 制造商全稱:Analog Devices 功能描述:LC2MOS High Speed 4- & 8-Channel 8-Bit ADCs |
| AD7828BCHIPS | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Single-Ended Data Acquisition System |
| AD7828BQ | 功能描述:IC ADC 8BIT 8CH HS 28-CDIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 標準包裝:1 系列:- 位數:14 采樣率（每秒）:83k 數據接口:串行，并聯 轉換器數目:1 功率耗散（最大）:95mW 電壓電源:雙 ± 工作溫度:0°C ~ 70°C 安裝類型:通孔 封裝/外殼:28-DIP（0.600"，15.24mm） 供應商設備封裝:28-PDIP 包裝:管件 輸入數目和類型:1 個單端，雙極 |
發布緊急采購，3分鐘左右您將得到回復。