- 您現在的位置：買賣IC網 > PDF目錄373914 > AD7713 (Analog Devices, Inc.) Loop-Powered Signal Conditioning ADC(循環驅動LC2MOS信號調節A/D轉換器) PDF資料下載
參數資料
| 型號： | AD7713 |
| 廠商： | Analog Devices, Inc. |
| 英文描述： | Loop-Powered Signal Conditioning ADC(循環驅動LC2MOS信號調節A/D轉換器) |
| 中文描述： | 回路供電信號調理模數轉換器（循環驅動LC2MOS信號調節的A / D轉換器） |
| 文件頁數： | 10/28頁 |
| 文件大?。?/td> | 529K |
| 代理商： | AD7713 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁當前第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
REV. C
–10–
AD7713
PGA Gain
G2
0
0
0
0
1
1
1
1
Gl
0
0
1
1
0
0
1
1
G0
0
1
0
1
0
1
0
1
Gain
1
2
4
8
16
32
64
128
(Default Condition After the Internal Power-On Reset)
Channel Selection
CH1 CH0 Channel
0
0
0
1
1
0
AIN1
AIN2
AIN3
(Default Condition After the Internal Power-On Reset)
Word Length
WL
Output Word Length
0
16-Bit
1
24-Bit
(Default Condition After Internal Power-On Reset)
RTD Excitation Currents
RO
0
Off
1
On
(Default Condition After Internal Power-On Reset)
Burn-Out Current
BO
0
Off
1
On
(Default Condition After Internal Power-On Reset)
Bipolar/Unipolar Selection (Both Inputs)
B/U
0 Bipolar
(Default Condition After Internal Power-On Reset)
1 Unipolar
Filter Selection (FS11–FS0)
The on-chip digital filter provides a Sinc
3
(or (Sinx/x)
3
) filter response. The 12 bits of data programmed into these bits determine
the filter cutoff frequency, the position of the first notch of the filter and the data rate for the part. In association with the gain selec-
tion, it also determines the output noise (and hence the effective resolution) of the device.
The first notch of the filter occurs at a frequency determined by the relationship: filter first notch frequency = (f
CLK IN
/512)/
code
where
code
is the decimal equivalent of the code in bits FS0 to FS11 and is in the range 19 to 2,000. With the nominal f
CLK IN
of
2 MHz, this results in a first notch frequency range from 1.952 Hz to 205.59 kHz. To ensure correct operation of the AD7713, the
value of the code loaded to these bits must be within this range. Failure to do this will result in unspecified operation of the device.
Changing the filter notch frequency, as well as the selected gain, impacts resolution. Tables I and II and Figure 2 show the effect of
the filter notch frequency and gain on the effective resolution of the AD7713. The output data rate (or effective conversion time) for
the device is equal to the frequency selected for the first notch of the filter. For example, if the first notch of the filter is selected at
10 Hz, then a new word is available at a 10 Hz rate or every 100 ms. If the first notch is at 200 Hz, a new word is available every 5 ms.
The settling time of the filter to a full-scale step input change is worst case 4
×
1/(output data rate). This settling time is to 100% of
the final value. For example, with the first filter notch at 100 Hz, the settling time of the filter to a full-scale step input change is
400 ms max. If the first notch is at 200 Hz, the settling time of the filter to a full-scale input step is 20 ms max. This settling time
can be reduced to 3
×
l/(output data rate) by synchronizing the step input change to a reset of the digital filter. In other words, if the
step input takes place with
SYNC
low, the settling time will be 3
×
l/(output data rate). If a change of channels takes place, the set-
tling time is 3
×
l/(output data rate) regardless of the
SYNC
input.
The –3 dB frequency is determined by the programmed first notch frequency according to the relationship: filter –3 dB frequency
= 0.262
×
first notch frequency.
相關PDF資料 |
PDF描述 |
|---|---|
| AD7714AN-3 | VARISTOR 30VRMS 0805 SMD |
| AD7714AN-5 | VARISTOR 40VRMS 1206 SMD |
| AD7714YRU | 3 V/5 V, CMOS, 500 uA Signal Conditioning ADC |
| AD7714* | 3 V/5 V. CMOS. 500 uA Signal Conditioning ADC |
| AD7714ARS-3 | 3 V/5 V, CMOS, 500 uA Signal Conditioning ADC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD7713AN | 功能描述:IC ADC 24BIT SIGMA-DELTA 24-DIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
| AD7713ANZ | 功能描述:IC ADC 24BIT SIGMA-DELTA 24-DIP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 其它有關文件:TSA1204 View All Specifications 標準包裝:1 系列:- 位數:12 采樣率（每秒）:20M 數據接口:并聯 轉換器數目:2 功率耗散（最大）:155mW 電壓電源:模擬和數字 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:48-TQFP 供應商設備封裝:48-TQFP（7x7） 包裝:Digi-Reel® 輸入數目和類型:4 個單端，單極；2 個差分，單極 產品目錄頁面:1156 (CN2011-ZH PDF) 其它名稱:497-5435-6 |
| AD7713AQ | 制造商:Rochester Electronics LLC 功能描述:24 BIT SIGMA DELTA ADC IC - Bulk |
| AD7713AR | 功能描述:IC ADC SIGNAL COND LC2MOS 24SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 模數轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:2,500 系列:- 位數:12 采樣率（每秒）:3M 數據接口:- 轉換器數目:- 功率耗散（最大）:- 電壓電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-23-6 包裝:帶卷 (TR) 輸入數目和類型:- |
發布緊急采購，3分鐘左右您將得到回復。