CF VOUT 0.1 F –15 +15 C1 33pF R" />
參數資料
型號： AD711KR-REEL7
廠商： Analog Devices Inc
文件頁數： 2/16頁
文件大?。?/td> 0K
描述： IC OPAMP BIFET PREC 25MA 8SOIC
標準包裝： 750
放大器類型： J-FET
電路數： 1
轉換速率： 20 V/µs
-3db帶寬： 4MHz
電流 - 輸入偏壓： 15pA
電壓 - 輸入偏移： 200µV
電流 - 電源： 2.5mA
電流 - 輸出 / 通道： 25mA
電壓 - 電源，單路/雙路(±)： 9 V ~ 36 V，±4.5 V ~ 18 V
工作溫度： 0°C ~ 70°C
安裝類型： 表面貼裝
封裝/外殼： 8-SOIC（0.154"，3.90mm 寬）
供應商設備封裝： 8-SOIC
包裝： 帶卷 (TR)
REV. E
AD711
–10–
AD711K
CF
VOUT
0.1 F
–15
+15
C1
33pF
R2*
OUT1
RFB
VDD
VREF
DGND AGND
R1*
VIN
ANALOG
COMMON
GAIN
ADJUST
DB11-DB0
VDD
AD7545
*FOR VALUES R1 AND R2,
REFER TO TABLE 1
Figure 8. Unipolar Binary Operation
R1 and R2 calibrate the zero offset and gain error of the DAC.
Specific values for these resistors depend upon the grade of
AD7545 and are shown below.
Table I. Recommended Trim Resistor Values vs. Grades
of the AD7545 for VDD = 5 V
TRIM
RESISTOR JN/AQ/SD KN/BQ/TD LN/CQ/UD GLN/GCQ/GUD
R1
500
W
200
W
100
W
20
W
R2
150
W
68
W
33
W
6.8
W
NOISE CHARACTERISTICS
The random nature of noise, particularly in the 1/f region, makes
it difficult to specify in practical terms. At the same time,
designers of precision instrumentation require certain guaranteed
maximum noise levels to realize the full accuracy of their equipment.
The AD711C grade is specified at a maximum level of 4.0
mV p-p,
in a 0.1 Hz to 10 Hz bandwidth. Each AD711C receives a 100%
noise test for two 10-second intervals; devices with any excursion
in excess of 4.0
mV are rejected. The screened lot is then submitted
to Quality Control for verification on an AQL basis.
All other grades of the AD711 are sample-tested on an AQL
basis to a limit of 6
mV p-p, 0.1 to 10 Hz.
DRIVING THE ANALOG INPUT OF AN A/D CONVERTER
An op amp driving the analog input of an A/D converter, such
as that shown in Figure 11, must be capable of maintaining a
constant output voltage under dynamically changing load conditions.
In successive-approximation converters, the input current is
point is diode clamped but may deviate several hundred millivolts
resulting in high frequency modulation of A/D input current.
Figures 10a and 10b show the settling time characteristics of the
AD711 when used as a DAC output buffer for the AD7545.
a. Full-Scale Positive
b. Full-Scale Negative
Transition
Figure 10. Settling Characteristics for AD711 with AD7545
compared to a series of switched trial currents. The comparison
point is diode clamped but may deviate several hundred milli-
volts resulting in high frequency modulation of A/D input
current. The output impedance of a feedback amplifier is made
artificially low by the loop gain. At high frequencies, where the
loop gain is low, the amplifier output impedance can approach
its open loop value. Most IC amplifiers exhibit a minimum open
loop output impedance of 25
W due to current limiting resistors.
A few hundred microamps reflected from the change in con-
verter loading can introduce errors in instantaneous input
Figures 8 and 9 show the AD711 and AD7545 (12-bit CMOS
DAC) configured for unipolar binary (2-quadrant multiplication)
or bipolar (4-quadrant multiplication) operation. Capacitor C1
provides phase compensation to reduce overshoot and ringing.
+15V
0.1 F
AD711K
–15V
R3
10k
1%
+15V
0.1 F
AD711K
–15V
R5
20k
1%
R4
20k
1%
R2*
C1
33pF
OUT1
RFB
VDD
VREF
DGND
AGND
R1*
VIN
GAIN
ADJUST
DB11-DB0
VDD
VOUT
AD7545
12
DATA INPUT
ANALOG
COMMON
*FOR VALUES R1 AND R2,
REFER TO TABLE 1
Figure 9. Bipolar Operation
+15V
0.1 F
AD711
–15V
R2
100
GAIN
ADJUST
12/8
R1
100
OFFSET
ADJUST
CS
AO
R/C
CE
REF IN
REF OUT
BIP OFF
10VIN
20VIN
ANA COM
STS
HIGH
BITS
MIDDLE
BITS
LOW
BITS
+5V
+15V
–15V
DIG COM
AD574
10V
ANALOG
INPUT
ANALOG COM
Figure 11. AD711 as ADC Unity Gain Buffer
相關PDF資料
PDF描述
SST 2.5 FUSE 2.5A 125V 6125 SLOW SST
RW1S5CAR200JET RES POWER .200 OHM 1.5W 5% SMT
P6KE180CA-E3/73 TVS 600W 180V 5% BIDIR AXIAL
CLT-146-02-L-D CONN RCPT 92POS DUAL 2MM SMD
P6KE120CA-E3/73 TVS 600W 120V 5% BIDIR AXIAL
相關代理商/技術參數
參數描述
AD711KRZ 功能描述:IC OPAMP BIFET PREC 25MA 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:2,500 系列:- 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.6 V/µs 增益帶寬積:1MHz -3db帶寬:- 電流 - 輸入偏壓:45nA 電壓 - 輸入偏移:2000µV 電流 - 電源:1.4mA 電流 - 輸出 / 通道:40mA 電壓 - 電源，單路/雙路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:14-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:14-TSSOP 包裝:帶卷 (TR) 其它名稱:LM324ADTBR2G-NDLM324ADTBR2GOSTR
AD711KRZ 制造商:Analog Devices 功能描述:IC OP-AMP 4MHZ 20V/ ((NW)) 制造商:Analog Devices 功能描述:IC, OP-AMP, 4MHZ, 20V/ us, SOIC-8
AD711KRZ-REEL 功能描述:IC OPAMP BIFET PREC 25MA 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 標準包裝:50 系列:LinCMOS™ 放大器類型:通用 電路數:4 輸出類型:- 轉換速率:0.05 V/µs 增益帶寬積:110kHz -3db帶寬:- 電流 - 輸入偏壓:0.7pA 電壓 - 輸入偏移:210µV 電流 - 電源:57µA 電流 - 輸出 / 通道:30mA 電壓 - 電源，單路/雙路(±):3 V ~ 16 V，±1.5 V ~ 8 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:14-SOIC 包裝:管件 產品目錄頁面:865 (CN2011-ZH PDF) 其它名稱:296-1834296-1834-5
AD711KRZ-REEL7 功能描述:IC OPAMP BIFET PREC 25MA 8SOIC RoHS:是 類別:集成電路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 其它有關文件:Automotive Product Guide 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 放大器類型:通用 電路數:1 輸出類型:滿擺幅 轉換速率:3 V/µs 增益帶寬積:10MHz -3db帶寬:- 電流 - 輸入偏壓:1pA 電壓 - 輸入偏移:70µV 電流 - 電源:2.5mA 電流 - 輸出 / 通道:48mA 電壓 - 電源，單路/雙路(±):2.7 V ~ 5.5 V，±1.35 V ~ 2.75 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-6 供應商設備封裝:SOT-6 包裝:Digi-Reel® 其它名稱:MAX4475AUT#TG16DKR
AD711SCHIPS 制造商:AD 制造商全稱:Analog Devices 功能描述:Precision, Low Cost, High Speed, BiFET Op Amp
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*