- 您現在的位置：買賣IC網 > PDF目錄1979 > AD5790BCPZ (Analog Devices Inc)IC DAC VOLT OUT 20BIT 24LFCSP PDF資料下載
參數資料
| 型號： | AD5790BCPZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 16/28頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DAC VOLT OUT 20BIT 24LFCSP |
| 標準包裝： | 1 |
| 設置時間： | 2.5µs |
| 位數： | 20 |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 1 |
| 電壓電源： | 模擬和數字，雙 ± |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 24-VFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 24-LFCSP-VQ EP（4x5） |
| 包裝： | 托盤 |
| 輸出數目和類型： | 1 電壓，雙極 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁
Data Sheet
AD5790
Rev. D | Page 23 of 28
AD5790 FEATURES
POWER-ON TO 0 V
The AD5790 contains a power-on reset circuit that, as well as
resetting all registers to their default values, controls the output
voltage during power-up. Upon power-on, the DAC is placed in
tristate (its reference inputs are disconnected), and its output is
clamped to AGND through a ~6 kΩ resistor. The DAC remains
in this state until programmed otherwise via the control register.
This is a useful feature in applications where it is important to
know the state of the DAC output while it is in the process of
powering up.
CONFIGURING THE AD5790
After power-on, the AD5790 must be configured to put it into
normal operating mode before programming the output. To do
this, the control register must be programmed. The DAC is
removed from tristate by clearing the DACTRI bit, and the
output clamp is removed by clearing the OPGND bit. At this
point, the output goes to VREFN, unless an alternative value is
first programmed to the DAC register.
DAC OUTPUT STATE
The DAC output can be placed in one of three states, controlled
by the DACTRI and OPGND bits of the control register, as
shown in Table 15.
Table 15. Output State Truth Table
DACTRI
OPGND
Output State
0
Normal operating mode
0
1
Output is clamped via ~6 kΩ to AGND
1
0
Output is in tristate
1
Output is clamped via ~6 kΩ to AGND
OUTPUT AMPLIFIER CONFIGURATION
There are a number of different ways that an output amplifier
can be connected to the AD5790, depending on the voltage
references applied and the desired output voltage span.
Unity-Gain Configuration
Figure 50 shows an output amplifier configured for unity gain.
In this configuration, the output spans from VREFN to VREFP.
A1
6.8k 6.8k
R1
RFB
VREFP
RFB
INV
VOUT
20-BIT
DAC
VREFN
AD5790
AD8675
ADA4898-1
ADA4004-1
1
0239-
0
52
Figure 50. Output Amplifier in Unity-Gain Configuration
A second unity-gain configuration for the output amplifier is
one that removes an offset from the input bias currents of the
amplifier. It does this by inserting a resistance in the feedback
path of the amplifier that is equal to the output resistance of the
DAC. The DAC output resistance is 3.4 kΩ. By connecting R1
and RFB in parallel, a resistance equal to the DAC resistance is
available on chip. Because the resistors are all on one piece of
silicon, they are temperature coefficient matched. To enable this
mode of operation the RBUF bit of the control register must be
set to Logic 1. Figure 51 shows how the output amplifier is
connected to the AD5790. In this configuration, the output
amplifier is in unity gain and the output spans from VREFN to
VREFP. This unity-gain configuration allows a capacitor to be placed
in the amplifier feedback path to improve dynamic performance.
RFB
6.8k
R1
6.8k
VREFP
RFB
INV
VOUT
10pF
20-BIT
DAC
VREFN
AD5790
AD8675
ADA4898-1
ADA4004-1
102
39
-053
Figure 51. Output Amplifier in Unity Gain with Amplifier Input Bias Current
Compensation
相關PDF資料 |
PDF描述 |
|---|---|
| AD5791BRUZ | IC DAC 20BIT SRL 20TSSOP |
| AD5821ABCBZ-REEL | IC DAC 10BIT CURRENTSINK 9WLCSP |
| AD6600ASTZ | IC ADC DUAL W/RSSI 44-LQFP |
| AD6644ASTZ-65 | IC ADC 14BIT 65MSPS CMOS 52-LQFP |
| AD6645ASVZ-105 | IC ADC 14BIT 105MSPS 52TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5790BCPZ-RL7 | 制造商:Analog Devices 功能描述:DAC 1-CH Segment 20-bit 24-Pin LFCSP EP T/R 制造商:Analog Devices 功能描述:20BIT, 2LSB, UNBUFFERED REF - Tape and Reel 制造商:Analog Devices 功能描述:IC DAC VOLT OUT 20BIT 24LFCSP 制造商:Analog Devices Inc. 功能描述:Digital to Analog Converters - DAC 20bit 2LSB unbuffered Ref 制造商:Analog Devices 功能描述:CONVERTER - DAC |
| AD5791 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Ultra Stable, 16-Bit ±0.5 LSB INL |
| AD5791_13 | 制造商:AD 制造商全稱:Analog Devices 功能描述:1 ppm 20-Bit, 1 LSB INL, Voltage Output DAC |
| AD5791ARUZ | 功能描述:IC DAC 20BIT SRL 20TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:1 系列:- 設置時間:4.5µs 位數:12 數據接口:串行，SPI? 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOICN 包裝:剪切帶 (CT) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:* 其它名稱:MCP4921T-E/SNCTMCP4921T-E/SNRCTMCP4921T-E/SNRCT-ND |
| AD5791BRUZ | 功能描述:IC DAC 20BIT SRL 20TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1,000 系列:- 設置時間:1µs 位數:8 數據接口:串行 轉換器數目:8 電壓電源:雙 ± 功率耗散（最大）:941mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:24-SOIC（0.295"，7.50mm 寬） 供應商設備封裝:24-SOIC W 包裝:帶卷 (TR) 輸出數目和類型:8 電壓，單極 采樣率（每秒）:* |
發布緊急采購，3分鐘左右您將得到回復。