- 您現在的位置：買賣IC網 > PDF目錄1979 > AD5755-1ACPZ (Analog Devices Inc)IC DAC 16BIT SERIAL 64LFCSP PDF資料下載
參數資料
| 型號： | AD5755-1ACPZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 42/52頁 |
| 文件大小： | 0K |
| 描述： | IC DAC 16BIT SERIAL 64LFCSP |
| 視頻文件： | AD5755: 16-Bit Multi-Channel, Voltage and Current Output DAC |
| 特色產品： | AD5755 / AD5755-1 / AD5757 DACs |
| 標準包裝： | 1 |
| 設置時間： | 11µs |
| 位數： | 16 |
| 數據接口： | DSP，MICROWIRE?，QSPI?，串行，SPI? |
| 轉換器數目： | 4 |
| 電壓電源： | 模擬和數字，雙 ± |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 64-VFQFN 裸露焊盤，CSP |
| 供應商設備封裝： | 64-LFCSP-VQ（9x9） |
| 包裝： | 托盤 |
| 輸出數目和類型： | 4 電流，4 電壓 |
| 采樣率（每秒）： | * |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁當前第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁
Data Sheet
AD5755-1
Rev. E | Page 47 of 52
DRIVING INDUCTIVE LOADS
When driving inductive or poorly defined loads, a capacitor
may be required between IOUT_x and AGND to ensure stability.
A 0.01 F capacitor between IOUT_x and AGND ensures stability
of a load of 50 mH. The capacitive component of the load may
cause slower settling, although this may be masked by the set-
tling time of the AD5755-1. There is no maximum capacitance
limit for the current output of the AD5755-1.
TRANSIENT VOLTAGE PROTECTION
The AD5755-1 contains ESD protection diodes that prevent
damage from normal handling. The industrial control
environment can, however, subject I/O circuits to much higher
transients. To protect the AD5755-1 from excessively high
voltage transients, external power diodes and a surge current
typical value for RP is 10 . The two protection diodes and the
resistor (RP) must have appropriate power ratings.
RLOAD
RP
D2
D1
AVSS
AD5755-1
VBOOST_x
IOUT_x
AGND
09226-
079
RFILTER
CFILTER
0.1F
10
(FROM
DC-TO-DC
CONVERTER)
CDCDC
4.7F
Figure 86. Output Transient Voltage Protection
Further protection can be provided using transient voltage
suppressors (TVSs), also referred to as transorbs. These compo-
nents are available as unidirectional suppressors, which protect
against positive high voltage transients, and as bidirectional
suppressors, which protect against both positive and negative
high voltage transients. Transient voltage suppressors are avail-
able in a wide range of standoff and breakdown voltage ratings.
The TVS should be sized with the lowest breakdown voltage
possible while not conducting in the functional range of the
current output.
It is recommended that all field connected nodes be protected.
The voltage output node can be protected with a similar circuit,
where D2 and the transorb are connected to AVSS. For the volt-
age output node, the +VSENSE_x pin should also be protected with
a large value series resistance to the transorb, such as 5 k. In
this way, the IOUT_x and VOUT_x pins can also be tied together and
share the same protection circuitry.
MICROPROCESSOR INTERFACING
Microprocessor interfacing to the AD5755-1 is via a serial bus
that uses a protocol compatible with microcontrollers and DSP
processors. The communications channel is a 3-wire minimum
interface consisting of a clock signal, a data signal, and a latch
signal. The AD5755-1 requires a 24-bit data-word with data
valid on the falling edge of SCLK.
The DAC output update is initiated on either the rising edge of
LDAC or, if LDAC is held low, on the rising edge of SYNC. The
contents of the registers can be read using the readback function.
AD5755-1-TO-ADSP-BF527 INTERFACE
The AD5755-1 can be connected directly to the SPORT
interface of the ADSP-BF527, an Analog Devices, Inc.,
Blackfin DSP. Figure 87 shows how the SPORT interface
can be connected to control the AD5755-1.
09226-
080
AD5755-1
SYNC
SCLK
SDIN
LDAC
SPORT_TFS
SPORT_TSCK
SPORT_DTO
GPIO0
ADSP-BF527
Figure 87. AD5755-1-to-ADSP-BF527 SPORT Interface
LAYOUT GUIDELINES
Grounding
In any circuit where accuracy is important, careful consideration
of the power supply and ground return layout helps to ensure
the rated performance. The printed circuit board on which the
AD5755-1 is mounted should be designed so that the analog
and digital sections are separated and confined to certain areas of
the board. If the AD5755-1 is in a system where multiple devices
require an AGND-to-DGND connection, the connection should
be made at one point only. The star ground point should be
established as close as possible to the device.
The GNDSWx and ground connection for the AVCC supply are
referred to as PGND. PGND should be confined to certain areas
of the board, and the PGND-to-AGND connection should be
made at one point only.
Supply Decoupling
The AD5755-1 should have ample supply bypassing of 10 F
in parallel with 0.1 F on each supply located as close to the
package as possible, ideally right up against the device. The
10 F capacitors are the tantalum bead type. The 0.1 F
capacitor should have low effective series resistance (ESR) and
low effective series inductance (ESL), such as the common
ceramic types, which provide a low impedance path to ground
at high frequencies to handle transient currents due to internal
logic switching.
相關PDF資料 |
PDF描述 |
|---|---|
| AD5755BCPZ-REEL7 | IC DAC 16BIT QUAD 64-LFCSP |
| AD5760BCPZ | IC DAC VOLT OUT 16BIT 24LFCSP |
| AD5762RCSUZ-REEL7 | IC DAC 16BIT QUAD VOUT 32-TQFP |
| AD5763CSUZ-REEL7 | DAC 16BIT DUAL 5V 2LSB 32-TQFP |
| AD5764CSUZ | IC DAC 16BIT QUAD VOUT 32TQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5755-1ACPZ-REEL7 | 功能描述:IC DAC 16BIT SERIAL 64LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Data Converter Fundamentals DAC Architectures 標準包裝:750 系列:- 設置時間:7µs 位數:16 數據接口:并聯 轉換器數目:1 電壓電源:雙 ± 功率耗散（最大）:100mW 工作溫度:0°C ~ 70°C 安裝類型:表面貼裝 封裝/外殼:28-LCC（J 形引線） 供應商設備封裝:28-PLCC（11.51x11.51） 包裝:帶卷 (TR) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:143k |
| AD5755-1X | 制造商:AD 制造商全稱:Analog Devices 功能描述:Quad Channel, 16-Bit, Serial Input, 4-20mA & Voltage Output DAC, Dynamic Power Control, HART Connectivity |
| AD5755ACPZ | 功能描述:數模轉換器- DAC 16Bit Quad V/I DAC with Dynamic Power RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| AD5755ACPZ-REEL7 | 功能描述:IC DAC 16BIT QUAD 64-LFCSP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 設置時間:4µs 位數:12 數據接口:串行 轉換器數目:2 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-TSSOP，8-MSOP（0.118"，3.00mm 寬） 供應商設備封裝:8-uMAX 包裝:管件 輸出數目和類型:2 電壓，單極 采樣率（每秒）:* 產品目錄頁面:1398 (CN2011-ZH PDF) |
| AD5755BCPZ | 制造商:Analog Devices 功能描述: 制造商:Analog Devices 功能描述:DAC QUAD 16BIT -26.4/33VIN 64LFCSP 制造商:Analog Devices 功能描述:DAC, QUAD, 16BIT, -26.4/33VIN, 64LFCSP 制造商:Analog Devices 功能描述:DAC, QUAD, 16BIT, -26.4/33VIN, 64LFCSP, Resolution (Bits):16bit, Input Channel Type:Serial, Digital IC Case Style:LFCSP, No. of Pins:64, Data Interface:Microwire, QSPI, SPI, Supply Current:8.6mA, Operating Temperature Min:-40C, , RoHS Compliant: Yes |
發布緊急采購，3分鐘左右您將得到回復。