- 您現在的位置：買賣IC網 > PDF目錄8990 > AD5449YRUZ (Analog Devices Inc)IC DAC DUAL 12BIT MULT 16-TSSOP PDF資料下載
參數資料
| 型號： | AD5449YRUZ |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 11/29頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DAC DUAL 12BIT MULT 16-TSSOP |
| 產品培訓模塊： | Data Converter Fundamentals DAC Architectures |
| 標準包裝： | 96 |
| 設置時間： | 80ns |
| 位數： | 12 |
| 數據接口： | 串行 |
| 轉換器數目： | 2 |
| 電壓電源： | 單電源 |
| 功率耗散（最大）： | 3.5µW |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 16-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 16-TSSOP |
| 包裝： | 管件 |
| 輸出數目和類型： | 4 電流，單極；4 電流，雙極 |
| 采樣率（每秒）： | 2.47M |
| 產品目錄頁面： | 782 (CN2011-ZH PDF) |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
AD5429/AD5439/AD5449
Data Sheet
Rev. E | Page 18 of 28
ADDING GAIN
In applications in which the output voltage must be greater than
VIN, gain can be added with an additional external amplifier, or
it can be achieved in a single stage. Consider the effect of temper-
ature coefficients of the thin film resistors of the DAC. Simply
placing a resistor in series with the RFB resistor causes mismatches
in the temperature coefficients, resulting in larger gain temper-
ature coefficient errors. Instead, the circuit in Figure 42 shows
the recommended method of increasing the gain of the circuit.
R1, R2, and R3 should have similar temperature coefficients,
but they need not match the temperature coefficients of the
DAC. This approach is recommended in circuits in which
gains of greater than 1 are required.
DIVIDER OR PROGRAMMABLE GAIN ELEMENT
Current-steering DACs are very flexible and lend themselves
to many applications. If this type of DAC is connected as the
feedback element of an op amp and RFBA is used as the input
resistor, as shown in Figure 43, the output voltage is inversely
proportional to the digital input fraction, D.
For D = 1 2n, the output voltage is
(
)n
IN
OUT
V
D
V
/
=
/
=
2
1
/
As D is reduced, the output voltage increases. For small values of
the Digital Fraction D, it is important to ensure that the amplifier
does not saturate and the required accuracy is met. For example,
an 8-bit DAC driven with binary code of 0x10 (0001 0000)—that
is, 16 decimal—in the circuit of Figure 43 should cause the output
voltage to be 16 × VIN. However, if the DAC has a linearity speci-
fication of ±0.5 LSB, D can have a weight in the range of 15.5/256
to 16.5/256, so that the possible output voltage is in the range of
15.5 VIN to 16.5 VIN. This range represents an error of 3%, even
though the DAC itself has a maximum error of 0.2%.
DAC leakage current is also a potential error source in divider
circuits. The leakage current must be counterbalanced by an
opposite current supplied from the op amp through the DAC.
Because only a fraction, D, of the current into the VREFx terminal
is routed to the IOUT1 terminal, the output voltage changes as
follows:
Output Error Voltage Due to DAC Leakage = (Leakage × R)/D
where R is the DAC resistance at the VREFx terminal.
For a DAC leakage current of 10 nA, R = 10 k, and a gain (that
is, 1/D) of 16, the error voltage is 1.6 mV.
VDD
RFBA
IOUT1A
IOUT2A
C1
GND
VDD
VREFA
NOTES
1. ADDITIONAL PINS OMITTED FOR CLARITY.
2. C1 PHASE COMPENSATION (1pF TO 2pF) MAY BE REQUIRED
8-/10-/12-BIT
DAC
VIN
R1
R3
R2
VOUT
R1 =
R2R3
R2 + R3
GAIN =
R2 + R3
R2
04464-011
IF A1 IS A HIGH SPEED AMPLIFIER.
Figure 42. Increasing Gain of Current Output DAC
VIN
NOTES
1. ADDITIONAL PINS OMITTED FOR CLARITY.
VREFA
VDD
RFBA
IOUT1A
IOUT2A
GND
VOUT
04464-
012
8-/10-/12-BIT
DAC
Figure 43. Current-Steering DAC Used as a Divider or Programmable Gain Element
相關PDF資料 |
PDF描述 |
|---|---|
| VE-JT1-MZ-F3 | CONVERTER MOD DC/DC 12V 25W |
| VI-BN2-MV-F3 | CONVERTER MOD DC/DC 15V 150W |
| VI-BN2-MV-F2 | CONVERTER MOD DC/DC 15V 150W |
| VE-JT1-MZ-F2 | CONVERTER MOD DC/DC 12V 25W |
| VI-BN2-MV-F1 | CONVERTER MOD DC/DC 15V 150W |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5449YRUZ-REEL | 功能描述:IC DAC DUAL 12BIT MULT 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:8 電壓電源:單電源 功率耗散（最大）:2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP（4x3） 包裝:管件 輸出數目和類型:8 電壓，單極 采樣率（每秒）:* |
| AD5449YRUZ-REEL7 | 功能描述:IC DAC DUAL 12BIT MULT 16TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:8 電壓電源:單電源 功率耗散（最大）:2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP（4x3） 包裝:管件 輸出數目和類型:8 電壓，單極 采樣率（每秒）:* |
| AD544JH | 制造商:Rochester Electronics LLC 功能描述:ULTRA-LOW DRIFT OP AMP IC - Bulk |
| AD544JH/+ | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| AD544KH | 制造商:AD 功能描述:544 ANALOG |
發布緊急采購，3分鐘左右您將得到回復。