- 您現在的位置：買賣IC網 > PDF目錄9310 > AD5228BUJZ100-R2 (Analog Devices Inc)IC DGTL POT 100K UP/DN TSOT23-8 PDF資料下載
參數資料
| 型號： | AD5228BUJZ100-R2 |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 15/20頁 |
| 文件大?。?/td> | 0K |
| 描述： | IC DGTL POT 100K UP/DN TSOT23-8 |
| 標準包裝： | 250 |
| 接片： | 32 |
| 電阻（歐姆）： | 100k |
| 電路數： | 1 |
| 溫度系數： | 標準值 35 ppm/°C |
| 存儲器類型： | 易失 |
| 接口： | 2 線按鈕 |
| 電源電壓： | 2.7 V ~ 5.5 V |
| 工作溫度： | -40°C ~ 105°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | SOT-23-8 薄型，TSOT-23-8 |
| 供應商設備封裝： | TSOT-23-8 |
| 包裝： | 帶卷 (TR) |
| 配用： | EVAL-AD5228EBZ-ND - BOARD EVAL FOR AD5228 DGTL POT |
AD5228
Rev. A | Page 4 of 20
Parameter
Symbol
Conditions
Min
Typ1
Max
Unit
DYNAMIC CHARACTERISTICS 4, 9, 10, 11
Built-in Debounce and Settling Time 12
tDB
6
ms
PU Low Pulse Width
tPU
12
ms
PD Low Pulse Width
tPD
12
ms
PU High Repetitive Pulse Width
tPU_REP
1
μs
PD High Repetitive Pulse Width
tPD_REP
1
μs
Autoscan Start Time
tAS_START
PU or PD = 0 V
0.6
0.8
1.2
s
Autoscan Time
tAS
PU or PD = 0 V
0.16
0.25
0.38
s
Bandwidth –3 dB
BW_10
RAB = 10 kΩ, midscale
460
kHz
BW_50
RAB = 50 kΩ, midscale
100
kHz
BW_100
RAB = 100 kΩ, midscale
50
kHz
Total Harmonic Distortion
THD
VA = 1 V rms, RAB = 10 kΩ,
VB = 0 V dc, f = 1 kHz
0.05
%
Resistor Noise Voltage
eN_WB
RWB = 5 kΩ, f = 1 kHz
14
nV/
√Hz
1 Typicals represent average readings at 25°C, VDD = 5 V.
2 Resistor position nonlinearity error, R-INL, is the deviation from an ideal value measured between the maximum resistance and the minimum resistance wiper
positions. R-DNL measures the relative step change from ideal between successive tap positions. Parts are guaranteed monotonic.
3 INL and DNL are measured at VW with the RDAC configured as a potentiometer divider similar to a voltage output D/A converter. VA = VDD and VB = 0 V.
4 Guaranteed by design and not subject to production test.
5 DNL specification limits of ±1 LSB maximum are guaranteed monotonic operating conditions.
6 Resistor Terminals A, B, and W have no limitations on polarity with respect to each other.
7
PU and PD have 100 kΩ internal pull-up resistors, IDD_ACT = VDD/100 kΩ + IOSC (internal oscillator operating current) when PU or PD is connected to ground.
8 PDISS is calculated based on IDD_STBY × VDD only. IDD_ACT duration should be short. Users should not hold PU or PD pin to ground longer than necessary to elevate power
dissipation.
9 Bandwidth, noise, and settling time are dependent on the terminal resistance value chosen. The lowest R value results in the fastest settling time and highest
bandwidth. The highest R value results in the minimum overall power consumption.
10 All dynamic characteristics use VDD = 5 V.
11 Note that all input control voltages are specified with tR = tF = 1 ns (10% to 90% of VDD) and timed from a voltage level of 1.6 V. Switching characteristics are measured
using VDD = 5 V.
12 The debouncer keeps monitoring the logic-low level once PU is connected to ground. Once the signal lasts longer than 11 ms, the debouncer assumes the last
bounce is met and allows the AD5228 to increment by one step. If the PU signal remains at low and reaches tAS_START, the AD5528 increments again, see Figure 7. Similar
characteristics apply to PD operation.
INTERFACE TIMING DIAGRAMS
04422-0-006
RWB
PU
tDB
tPD
tPD_REP
04422-0-004
RWB
PU
tPU
tPU_REP
tDB
Figure 2. Increment RWB in Discrete Steps
Figure 4. Decrement RWB in Discrete Steps
04422-0-007
RWB
PD
tDB
tAS
tAS_START
04422-0-005
RWB
PU
tDB
tAS
tAS_START
Figure 5. Decrement RWB in Autoscan Mode
Figure 3. Increment RWB in Autoscan Mode
相關PDF資料 |
PDF描述 |
|---|---|
| VI-B1H-MW-B1 | CONVERTER MOD DC/DC 52V 100W |
| VI-B1H-MV | CONVERTER MOD DC/DC 52V 150W |
| VI-B1F-MW-B1 | CONVERTER MOD DC/DC 72V 100W |
| MS27468E23F35PB | CONN RCPT 100POS JAM NUT W/PINS |
| AD5161BRMZ100-RL7 | IC DGTL POT SPI 100K 10-MSOP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5228BUJZ100-RL7 | 功能描述:IC DGTL POT 32POS 100K TSOT23-8 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 接片:256 電阻（歐姆）:100k 電路數:1 溫度系數:標準值 35 ppm/°C 存儲器類型:非易失 接口:3 線串口 電源電壓:2.7 V ~ 5.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WDFN 裸露焊盤 供應商設備封裝:8-TDFN-EP（3x3） 包裝:剪切帶 (CT) 產品目錄頁面:1399 (CN2011-ZH PDF) 其它名稱:MAX5423ETA+TCT |
| AD5228BUJZ102-R2 | 制造商:AD 制造商全稱:Analog Devices 功能描述:32-Position Manual Up/Down Control Potentiometer |
| AD5228BUJZ102-RL7 | 制造商:AD 制造商全稱:Analog Devices 功能描述:32-Position Manual Up/Down Control Potentiometer |
| AD5228BUJZ10-R2 | 功能描述:IC DGTL POT 10K UP/DN TSOT23-8 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 標準包裝:3,000 系列:DPP 接片:32 電阻（歐姆）:10k 電路數:1 溫度系數:標準值 300 ppm/°C 存儲器類型:非易失 接口:3 線串行（芯片選擇，遞增，增/減） 電源電壓:2.5 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WFDFN 裸露焊盤 供應商設備封裝:8-TDFN（2x3） 包裝:帶卷 (TR) |
| AD5228BUJZ10-RL7 | 功能描述:IC DGTL POT UP/DN 10K TSOT23-8 RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 接片:256 電阻（歐姆）:100k 電路數:1 溫度系數:標準值 35 ppm/°C 存儲器類型:非易失 接口:3 線串口 電源電壓:2.7 V ~ 5.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WDFN 裸露焊盤 供應商設備封裝:8-TDFN-EP（3x3） 包裝:剪切帶 (CT) 產品目錄頁面:1399 (CN2011-ZH PDF) 其它名稱:MAX5423ETA+TCT |
發布緊急采購，3分鐘左右您將得到回復。