- 您現在的位置：買賣IC網 > PDF目錄375222 > AAT3680ITP-4.2-T1 (Advanced Analogic Technologies, Inc.) Lithium-Ion Linear Battery Charge Controller PDF資料下載
參數資料
| 型號： | AAT3680ITP-4.2-T1 |
| 廠商： | Advanced Analogic Technologies, Inc. |
| 英文描述： | Lithium-Ion Linear Battery Charge Controller |
| 中文描述： | 鋰離子線性電池充電控制器 |
| 文件頁數： | 9/18頁 |
| 文件大?。?/td> | 265K |
| 代理商： | AAT3680ITP-4.2-T1 |
Protection Circuitry
The AAT3680 is truly a highly integrated battery
management system IC including several protection
features. In addition to battery temperature monitor-
ing, the IC constantly monitors for over-current and
over-voltage conditions; if an over-current situation
occurs, the AAT3680 latches off the pass device to
prevent damage to the battery or the system, and
enters shutdown mode until the over-current event is
terminated.
An over voltage condition is defined as a condition
where the voltage on the BAT pin exceeds the max-
imum battery charge voltage. If an over-voltage con-
dition occurs, the IC turns off the pass device until
voltage on the BAT pin drops below the maximum
battery charge constant voltage threshold. The
AAT3680 will resume normal operation after the
over-current or over voltage condition is removed.
During an over-current or over-voltage event, the
STAT will report a FAULT signal.
In the event of a battery over-temperature condition,
the IC will turn off the pass device and report a
FAULT signal on the STAT pin. After the system
recovers from a temperature fault, the IC will resume
operation in the 1X trickle charge mode to prevent
damage to the system in the event a defective bat-
tery is placed under charge. Once the battery volt-
age rises above the trickle charge to constant cur-
rent charge threshold, the IC will resume the con-
stant current mode.
AAT3680
Lithium-Ion Linear Battery Charge Controller
3680.2003.4.0.91
9
High Speed Data Reporting Application Schematic
Q1
FZT788B
AAT3680
C2
10
μ
F
C1
μ
F
R2
100k
R
SENSE
0.2
R1
BATT+
BATT-
TEMP
RT1
RT2
VP
VP
Battery
Pack
DRV
CSI
VP
VSS
STAT
TS
BAT
TX2
STAT
C3
0.1
μ
F
100k
Figure 4: Typical Charge Profile
Preconditioning
(Trickle Charge)
Phase
Constant Current
Phase
Constant Voltage
Phase
Output Charge
Voltage (V
CH
)
Preconditioning
Voltage Threshold
(V
MIN
)
Regulation
Current
(I
CHARGE(REG)
)
Trickle Charge
and Termination
Threshold
相關PDF資料 |
PDF描述 |
|---|---|
| AAT3680ITP-8.2-T1 | Lithium-Ion Linear Battery Charge Controller |
| AAT3680ITP-8.4-T1 | Lithium-Ion Linear Battery Charge Controller |
| AAT3682 | Lithium-Ion/Polymer Linear Battery Charger |
| AAT3682ISN-4.2-T1 | Lithium-Ion/Polymer Linear Battery Charger |
| AAT4250IGV-T1 | Slew Rate Controlled Load Switch |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AAT3681AIJS-4.1-5-T1 | 功能描述:電池管理 500mA USB Port/Adptr Li-Ion/Ply Batt Chgr RoHS:否 制造商:Texas Instruments 電池類型:Li-Ion 輸出電壓:5 V 輸出電流:4.5 A 工作電源電壓:3.9 V to 17 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:VQFN-24 封裝:Reel |
| AAT3681AIJS-4.1-T1 | 功能描述:電池管理 500mA USB Port/Adptr Li-Ion/Ply Batt Chgr RoHS:否 制造商:Texas Instruments 電池類型:Li-Ion 輸出電壓:5 V 輸出電流:4.5 A 工作電源電壓:3.9 V to 17 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:VQFN-24 封裝:Reel |
| AAT3681AIJS-4.2-1-T1 | 功能描述:IC BATT CHG LI-ION SC70JW-8 制造商:skyworks solutions inc. 系列:- 包裝:* 零件狀態:上次購買時間 電池化學:鋰離子/聚合物 電池?cái)?shù):1 電流 - 充電:恒流 - 可編程 可編程特性:- 故障保護:超溫，過壓，短路 充電電流 - 最大值:500mA 電池組電壓:4.2V 電壓 -?供電（最高）:7.5V 接口:USB 工作溫度:-40°C ~ 85°C（TA） 封裝/外殼:* 供應商器件封裝:* 標準包裝:1 |
| AAT3681AIJS-4.2-2-T1 | 制造商:Skyworks Solutions Inc 功能描述:POWER MANAGEMENT IC |
| AAT3681AIJS-4.2-4-T1 | 功能描述:電池管理 500mA USB Port/Adptr Li-Ion/Ply Batt Chgr RoHS:否 制造商:Texas Instruments 電池類型:Li-Ion 輸出電壓:5 V 輸出電流:4.5 A 工作電源電壓:3.9 V to 17 V 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:VQFN-24 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。