參數資料
型號: A29800UV-90
廠商: AMIC Technology Corporation
英文描述: PULSER PROBE
中文描述: 1024K × 8位/ 16位為512k ×電壓的CMOS 5.0只,引導扇區閃存
文件頁數: 16/34頁
文件大?。?/td> 514K
代理商: A29800UV-90
A29800 Series
PRELIMINARY (May, 2001, Version 0.0)
16
AMIC Technology, Inc.
I/O
5
: Exceeded Timing Limits
I/O
5
indicates whether the program or erase time has
exceeded a specified internal pulse count limit. Under
these conditions I/O
5
produces a "1." This is a failure
condition that indicates the program or erase cycle was
not successfully completed.
The I/O
5
failure condition may appear if the system tries to
program a "1 "to a location that is previously programmed
to "0." Only an erase operation can change a "0" back to a
"1." Under this condition, the device halts the operation,
and when the operation has exceeded the timing limits,
I/O
5
produces a "1."
Under both these conditions, the system must issue the
reset command to return the device to reading array data.
I/O
3
: Sector Erase Timer
After writing a sector erase command sequence, the
system may read I/O
3
to determine whether or not an
erase operation has begun. (The sector erase timer does
not apply to the chip erase command.) If additional
sectors are selected for erasure, the entire time-out also
applies after each additional sector erase command.
When the time-out is complete, I/O
3
switches from "0" to
"1." The system may ignore I/O
3
if the system can
guarantee that the time between additional sector erase
commands will always be less than 50
μ
s. See also the
"Sector Erase Command Sequence" section.
After the sector erase command sequence is written, the
system should read the status on I/O
7
(
Data
Polling) or
I/O
6
(Toggle Bit 1) to ensure the device has accepted the
command sequence, and then read I/O
3
. If I/O
3
is "1", the
internally controlled erase cycle has begun; all further
commands (other than Erase Suspend) are ignored until
the erase operation is complete. If I/O
3
is "0", the device
will accept additional sector erase commands. To ensure
the command has been accepted, the system software
should check the status of I/O
3
prior to and following each
subsequent sector erase command. If I/O
3
is high on the
second status check, the last command might not have
been accepted. Table 6 shows the outputs for I/O
3
.
START
Read I/O
7
-I/O
0
Toggle Bit
= Toggle
Program/Erase
Operation Not
Commplete, Write
Reset Command
Yes
Notes :
1. Read toggle bit twice to determine whether or not it is
toggling. See text.
2. Recheck toggle bit because it may stop toggling as I/O
5
changes to "1". See text.
No
Read I/O
7
- I/O
0
Twice
I/O
5
= 1
Toggle Bit
= Toggle
Yes
Yes
Program/Erase
Operation Complete
No
No
Read I/O
7
-I/O
0
(Notes 1,2)
Figure 5. Toggle Bit Algorithm
(Note 1)
相關PDF資料
PDF描述
A2981 8-CHANNEL SOURCE DRIVERS
A2984SLW 8-CHANNEL SOURCE DRIVERS
A2987 8-CHANNEL SOURCE DRIVER WITH OVER-CURRENT PROTECTION
A29DL16x 16 Megabit (2M x 8-Bit/1M x 16-Bit) CMOS 3.0 Volt-only, Simultaneous Operation Flash Memory
A29DL162 16 Megabit (2M x 8-Bit/1M x 16-Bit) CMOS 3.0 Volt-only, Simultaneous Operation Flash Memory
相關代理商/技術參數
參數描述
A2981 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:8-CHANNEL SOURCE DRIVERS
A2982 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:8-CHANNEL SOURCE DRIVERS
A298213XX 制造商:NORTH TECH 功能描述: 制造商: 功能描述: 制造商:undefined 功能描述:
A2982ELW 功能描述:IC SOURCE DRIVER 8CHAN 20-SOIC RoHS:否 類別:集成電路 (IC) >> PMIC - MOSFET,電橋驅動器 - 內部開關 系列:- 標準包裝:1,000 系列:- 類型:高端/低端驅動器 輸入類型:SPI 輸出數:8 導通狀態電阻:850 毫歐,1.6 歐姆 電流 - 輸出 / 通道:205mA,410mA 電流 - 峰值輸出:500mA,1A 電源電壓:9 V ~ 16 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:20-SOIC(0.295",7.50mm 寬) 供應商設備封裝:PG-DSO-20-45 包裝:帶卷 (TR)
A2982ELW-T 功能描述:IC SOURCE DRIVER 8CHAN 20-SOIC RoHS:是 類別:集成電路 (IC) >> PMIC - MOSFET,電橋驅動器 - 內部開關 系列:- 標準包裝:1,000 系列:- 類型:高端/低端驅動器 輸入類型:SPI 輸出數:8 導通狀態電阻:850 毫歐,1.6 歐姆 電流 - 輸出 / 通道:205mA,410mA 電流 - 峰值輸出:500mA,1A 電源電壓:9 V ~ 16 V 工作溫度:-40°C ~ 150°C 安裝類型:表面貼裝 封裝/外殼:20-SOIC(0.295",7.50mm 寬) 供應商設備封裝:PG-DSO-20-45 包裝:帶卷 (TR)