- 您現在的位置：買賣IC網 > PDF目錄375112 > A29400UV-70 (AMIC Technology Corporation) Dipole Antenna; Bandwidth Max:2.65GHz; For Use With:Hand-Held Spectrum Analyzer; Leaded Process Compatible:No; Peak Reflow Compatible (260 C):No RoHS Compliant: No PDF資料下載
參數資料
| 型號： | A29400UV-70 |
| 廠商： | AMIC Technology Corporation |
| 英文描述： | Dipole Antenna; Bandwidth Max:2.65GHz; For Use With:Hand-Held Spectrum Analyzer; Leaded Process Compatible:No; Peak Reflow Compatible (260 C):No RoHS Compliant: No |
| 中文描述： | 為512k × 8位/ 256 × 16位的CMOS 5.0伏只，引導扇區閃存 |
| 文件頁數： | 8/33頁 |
| 文件大?。?/td> | 497K |
| 代理商： | A29400UV-70 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
Sector Protection/Unprotection
A29400 Series
PRELIMINARY (February, 2001, Version 0.1)
8
AMIC Technology, Inc.
The hardware sector protection feature disables both
program and erase operations in any sector. The hardware
sector unprotection feature re-enables both program and
erase operations in previously protected sectors.
Sector protection/unprotection must be implemented using
programming equipment. The procedure requires a high
voltage (V
ID
) on address pin A9 and the control pins.
The device is shipped with all sectors unprotected.
It is possible to determine whether a sector is protected or
unprotected. See "Autoselect Mode" for details.
Hardware Data Protection
The requirement of command unlocking sequence for
programming or erasing provides data protection against
inadvertent writes (refer to the Command Definitions table).
In addition, the following hardware data protection measures
prevent accidental erasure or programming, which might
otherwise be caused by spurious system level signals during
V
CC
power-up transitions, or from system noise. The device
is powered up to read array data to avoid accidentally writing
data to the array.
Write Pulse "Glitch" Protection
Noise pulses of less than 5ns (typical) on
OE
,
CE
or
WE
do not initiate a write cycle.
Logical Inhibit
Write cycles are inhibited by holding any one of
OE
=V
IL
,
CE
= V
IH
or
WE
= V
IH
. To initiate a write cycle,
CE
and
WE
must be a logical zero while
OE
is a logical one.
Power-Up Write Inhibit
If
WE
=
CE
= V
IL
and
OE
= V
IH
during power up, the
device does not accept commands on the rising edge of
WE
. The internal state machine is automatically reset to
reading array data on the initial power-up.
Temporary Sector Unprotect
This feature allows temporary unprotection of previous
protected sectors to change data in-system. The Sector
Unprotect mode is activated by setting the RESET pin to
V
ID
. During this mode, formerly protected sectors can be
programmed or erased by selecting the sector addresses.
Once V
ID
is removed from the RESET pin, all the previously
protected sectors are protected again. Figure 1 shows the
algorithm, and the Temporary Sector Unprotect diagram
shows the timing waveforms, for this feature.
START
RESET = V
ID
(Note 1)
Perform Erase or
Program Operations
RESET = V
IH
Temporary Sector
Unprotect
Completed (Note 2)
Notes:
1. All protected sectors unprotected.
2. All previously protected sectors are protected once again.
Figure 1. Temporary Sector Unprotect Operation
相關PDF資料 |
PDF描述 |
|---|---|
| A29400UV-90 | LOGIC PROBE 20MHZ |
| A29512A | 64K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory |
| A29512A-55 | 64K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory |
| A29512A-70 | 64K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory |
| A29512AL-55 | 64K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory |
相關代理商/技術參數 |
參數描述 |
|---|---|
| A29400UV-90 | 制造商:AMICC 制造商全稱:AMIC Technology 功能描述:512K X 8 Bit / 256K X 16 Bit CMOS 5.0 Volt-only, Boot Sector Flash Memory |
| A294018B | 制造商:LG Corporation 功能描述:HAND SET |
| A29406 | 制造商:Esico Triton 功能描述:ESICO |
| A-294-08X | 制造商:Molex 功能描述: |
| A-294-08XT | 制造商:Molex 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。