- 您現在的位置：買賣IC網 > PDF目錄375110 > A29010L-90 (AMIC Technology Corporation) 128K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory PDF資料下載
參數資料
| 型號： | A29010L-90 |
| 廠商： | AMIC Technology Corporation |
| 英文描述： | 128K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory |
| 中文描述： | 128K的× 8位CMOS 5.0伏只，統一部門快閃記憶體 |
| 文件頁數： | 8/30頁 |
| 文件大?。?/td> | 288K |
| 代理商： | A29010L-90 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁當前第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
A29010 Series
PRELIMINARY (August, 2001, Version 0.3)
8
AMIC Technology, Inc.
Autoselect Command Sequence
The autoselect command sequence allows the host system
to access the manufacturer and devices codes, and
determine whether or not a sector is protected. The
Command Definitions table shows the address and data
requirements. This method is an alternative to that shown in
the Autoselect Codes (High Voltage Method) table, which is
intended for PROM programmers and requires V
ID
on
address bit A9.
The autoselect command sequence is initiated by writing two
unlock cycles, followed by the autoselect command. The
device then enters the autoselect mode, and the system may
read at any address any number of times, without initiating
another command sequence.
Byte Program Command Sequence
Programming is a four-bus-cycle operation. The program
command sequence is initiated by writing two unlock write
cycles, followed by the program set-up command. The
program address and data are written next, which in turn
initiate the Embedded Program algorithm. The system is not
required to provide further controls or timings. The device
automatically provides internally generated program pulses
and verify the programmed cell margin. The Command
Definitions table shows the address and data requirements
for the byte program command sequence.
When the Embedded Program algorithm is complete, the
device then returns to reading array data and addresses are
no longer latched. The system can determine the status of
the program operation by using I/O
7
or I/O
6
. See "Write
Operation Status" for information on these status bits.
Any commands written to the device during the Embedded
Program Algorithm are ignored. Programming is allowed in
any sequence and across sector boundaries. A bit cannot be
programmed from a "0" back to a "1 ". Attempting to do so
may halt the operation and set I/O
5
to "1", or cause the
Data
Polling algorithm to indicate the operation was
successful. However, a succeeding read will show that the
data is still "0". Only erase operations can convert a "0" to a
"1".
START
Write Program
Command
Sequence
Data Poll
from System
Verify Data
Last Address
Programming
Completed
No
Yes
Yes
Increment Address
Embedded
Program
algorithm in
progress
Note : See the appropriate Command Definitions table for
program command sequence.
Figure 1. Program Operation
相關PDF資料 |
PDF描述 |
|---|---|
| A29010-70 | 128K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory |
| A29010-90 | Circular Connector; No. of Contacts:22; Series:TVS06; Body Material:Metal; Connecting Termination:Crimp; Connector Shell Size:13; Circular Contact Gender:Pin; Circular Shell Style:Straight Plug; Insert Arrangement:13-35 |
| A29010V-55 | Hook-Up Wire; Conductor Size AWG:24; No. Strands x Strand Size:19 x 36; Jacket Color:Light Blue; Approval Bodies:UL; Approval Categories:UL AWM Style 1180; Passes VW-1 Flame Test; Cable/Wire MIL SPEC:MIL-W-16878/5 Type EE RoHS Compliant: Yes |
| A29010V-70 | Hook-Up Wire; Conductor Size AWG:24; No. Strands x Strand Size:19 x 36; Jacket Color:Light Blue; Approval Bodies:UL; Approval Categories:UL AWM Style 1180; Passes VW-1 Flame Test; Cable/Wire MIL SPEC:MIL-W-16878/5 Type EE RoHS Compliant: Yes |
| A29010V-90 | Hook-Up Wire; Conductor Size AWG:24; No. Strands x Strand Size:19 x 36; Jacket Color:Purple; Approval Bodies:UL; Approval Categories:UL AWM Style 1180; Passes VW-1 Flame Test; Cable/Wire MIL SPEC:MIL-W-16878/5 Type EE RoHS Compliant: Yes |
相關代理商/技術參數 |
參數描述 |
|---|---|
| A29010SERIES | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:128K X 8 Bit CMOS 5.0 Volt-only. Uniform Sector Flash Memory |
| A29010V-55 | 制造商:AMICC 制造商全稱:AMIC Technology 功能描述:128K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory |
| A29010V-70 | 制造商:AMICC 制造商全稱:AMIC Technology 功能描述:128K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory |
| A29010V-70F | 制造商:AMIC Technology 功能描述:MEMORY FLASH NOR 5V 1M 32TSOP 制造商:AMIC Technology 功能描述:MEMORY, FLASH, NOR, 5V, 1M, 32TSOP 制造商:AMIC Technology 功能描述:MEMORY, FLASH, NOR, 5V, 1M, 32TSOP; Memory Type:Flash - NOR; Memory Size:1Mbit; Memory Configuration:128K x 8bit; Supply Voltage Min:4.5V; Supply Voltage Max:5.5V; Memory Case Style:TSOP-1; No. of Pins:32; Access Time:70ns; Interface;RoHS Compliant: Yes |
| A29010V-90 | 制造商:AMICC 制造商全稱:AMIC Technology 功能描述:128K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory |
發布緊急采購，3分鐘左右您將得到回復。