參數資料
型號: A29002UV-70
廠商: AMIC Technology Corporation
英文描述: Reed Switch; Pull-In Amp Turns Max:20; Pull-In Amp Turns Min:10; Circuitry:SPST-NO; Switching Current Max:0.5A; Switching Voltage Max:200V; Mounting Type:Surface Mount; Contact Rating:10 VA; Supply Current:1.5A RoHS Compliant: Yes
中文描述: 256K × 8位CMOS 5.0伏只,引導扇區閃存
文件頁數: 7/32頁
文件大?。?/td> 312K
代理商: A29002UV-70
A29002/A290021 Series
(February, 2002, Version 1.0)
7
AMIC Technology, Inc.
Sector Protection/Unprotection
The hardware sector protection feature disables both
program and erase operations in any sector. The hardware
sector unprotection feature re-enables both program and
erase operations in previously protected sectors.
Sector protection/unprotection must be implemented using
programming equipment. The procedure requires a high
voltage (V
ID
) on address pin A9 and the control pins.
The device is shipped with all sectors unprotected.
It is possible to determine whether a sector is protected or
unprotected. See "Autoselect Mode" for details.
Hardware Data Protection
The requirement of command unlocking sequence for
programming or erasing provides data protection against
inadvertent writes (refer to the Command Definitions table).
In addition, the following hardware data protection measures
prevent accidental erasure or programming, which might
otherwise be caused by spurious system level signals during
V
CC
power-up transitions, or from system noise. The device is
powered up to read array data to avoid accidentally writing
data to the array.
Write Pulse "Glitch" Protection
Noise pulses of less than 5ns (typical) on
OE
,
CE
or
WE
do not initiate a write cycle.
Logical Inhibit
Write cycles are inhibited by holding any one of
OE
=V
IL
,
CE
= V
IH
or
WE
= V
IH
. To initiate a write cycle,
CE
and
WE
must be a logical zero while
OE
is a logical one.
Power-Up Write Inhibit
If
WE
=
CE
= V
IL
and
OE
= V
IH
during power up, the
device does not accept commands on the rising edge of
WE
. The internal state machine is automatically reset to
reading array data on the initial power-up.
Temporary Sector Unprotect (N/A on A290021)
This feature allows temporary unprotection of previous
protected sectors to change data in-system. The Sector
Unprotect mode is activated by setting the
RESET
pin to V
ID
.
During this mode, formerly protected sectors can be
programmed or erased by selecting the sector addresses.
Once V
ID
is removed from the
RESET
pin, all the previously
protected sectors are protected again. Figure 1 shows the
algorithm, and the Temporary Sector Unprotect diagram
shows the timing waveforms, for this feature.
START
RESET = V
ID
(Note 1)
Perform Erase or
Program Operations
RESET = V
IH
Temporary Sector
Unprotect
Completed (Note 2)
Notes:
1. All protected sectors unprotected.
2. All previously protected sectors are protected once again.
Figure 1. Temporary Sector Unprotect Operation
相關PDF資料
PDF描述
A29010 128K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory
A29010-55 128K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory
A29010L-55 128K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory
A29010L-70 128K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory
A29010L-90 128K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory
相關代理商/技術參數
參數描述
A29002UV-90 制造商:AMICC 制造商全稱:AMIC Technology 功能描述:256K X 8 Bit CMOS 5.0 Volt-only, Boot Sector Flash Memory
A29010 制造商:AMICC 制造商全稱:AMIC Technology 功能描述:128K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory
A29010-55 制造商:AMICC 制造商全稱:AMIC Technology 功能描述:128K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory
A29010-70 制造商:AMICC 制造商全稱:AMIC Technology 功能描述:128K X 8 Bit CMOS 5.0 Volt-only, Uniform Sector Flash Memory
A29010-70F 制造商:AMIC Technology 功能描述:MEMORY FLASH NOR 5V 1M 32DIP 制造商:AMIC Technology 功能描述:MEMORY, FLASH, NOR, 5V, 1M, 32DIP 制造商:AMIC Technology 功能描述:MEMORY, FLASH, NOR, 5V, 1M, 32DIP; Memory Type:Flash - NOR; Memory Size:1Mbit; Memory Configuration:128K x 8bit; Supply Voltage Min:4.5V; Supply Voltage Max:5.5V; Memory Case Style:DIP; No. of Pins:32; Access Time:70ns; Interface ;RoHS Compliant: Yes