- 您現在的位置：買賣IC網 > PDF目錄375098 > A1145EUA (Allegro MicroSystems, Inc.) Ultrasensitive Two-Wire Chopper-Stabilized Unipolar Hall Effect Switches PDF資料下載
參數資料
| 型號： | A1145EUA |
| 廠商： | Allegro MicroSystems, Inc. |
| 元件分類： | 霍爾效應傳感器 |
| 英文描述： | Ultrasensitive Two-Wire Chopper-Stabilized Unipolar Hall Effect Switches |
| 中文描述： | 超靈敏雙線斬波穩定單極霍爾效應開關 |
| 文件頁數： | 9/13頁 |
| 文件大?。?/td> | 319K |
| 代理商： | A1145EUA |
9
A1145-DS, Rev. 6
Worcester, Massachusetts 01615-0036 (508) 853-5000
www.allegromicro.com
115 Northeast Cutoff, Box 15036
Allegro MicroSystems, Inc.
Ultrasensitive Two-Wire Chopper-Stabilized Unipolar Hall Effect Switches
A1145 and A1146
Application Information
For additional general application information, visit the Allegro
Web site at www. allegromicro.com.
GND
A114x
VCC
V+
0.01 μF
A
B
B
GND
ECU
Package UA Only
A
B
Maximum separation 5 mm
R
SENSE
C
BYP
Figure 3. Typical application circuit
Typical Application Circuit
The A114x family of devices must be protected by an external
bypass capacitor, C
BYP
, connected between the supply, VCC,
and the ground, GND, of the device. C
BYP
reduces both external
noise and the noise generated by the chopper-stabilization func-
tion. As shown in figure 3, a 0.01
μ
F capacitor is typical.
Installation of C
BYP
must ensure that the traces that connect it to
the A114x pins are no greater than 5 mm in length.
All high-frequency interferences conducted along the supply
lines are passed directly to the load through C
BYP
, and it serves
only to protect the A114x internal circuitry. As a result, the load
ECU (electronic control unit) must have sufficient protection,
other than C
BYP
, installed in parallel with the A114x.
A series resistor on the supply side, RS (not shown), in combina-
tion with C
BYP
, creates a filter for EMI pulses.
When determining the minimum V
CC
requirement of the A114x
device, the voltage drops across R
S
and the ECU sense resistor,
R
SENSE
, must be taken into consideration. The typical value for
R
SENSE
is approximately 100
Ω
.
相關PDF資料 |
PDF描述 |
|---|---|
| A1147LLHLT | Low Current Ultrasensitive Two-Wire Chopper-Stabilized Unipolar Hall Effect Switches |
| A1148LUA | Low Current Ultrasensitive Two-Wire Chopper-Stabilized Unipolar Hall Effect Switches |
| A1148LUA-T | Low Current Ultrasensitive Two-Wire Chopper-Stabilized Unipolar Hall Effect Switches |
| A1148LUATI | Low Current Ultrasensitive Two-Wire Chopper-Stabilized Unipolar Hall Effect Switches |
| A1148LUATI-T | Low Current Ultrasensitive Two-Wire Chopper-Stabilized Unipolar Hall Effect Switches |
相關代理商/技術參數 |
參數描述 |
|---|---|
| A1145EUA-T | 功能描述:IC SWITCH HALL EFFECT UNI 3-SIP RoHS:是 類別:傳感器，轉換器 >> 磁性 - 霍爾效應，數字式開關，線性，羅盤 (IC) 系列:- 標準包裝:1 系列:- 傳感范圍:20mT ~ 80mT 類型:旋轉 電源電壓:4.5 V ~ 5.5 V 電流 - 電源:15mA 電流 - 輸出（最大）:- 輸出類型:數字式，PWM，8.5 位串行 特點:可編程 工作溫度:-40°C ~ 150°C 封裝/外殼:20-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:20-SSOP 包裝:Digi-Reel® 其它名稱:AS5132-HSST-500DKR |
| A1145EUATI | 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:Ultrasensitive Two-Wire Chopper-Stabilized Unipolar Hall Effect Switches |
| A1145EUATI-T | 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:Ultrasensitive Two-Wire Chopper-Stabilized Unipolar Hall Effect Switches |
| A1145LLHLT | 功能描述:IC SWITCH HALL EFFECT UNI SOT-23 RoHS:否 類別:傳感器，轉換器 >> 磁性 - 霍爾效應，數字式開關，線性，羅盤 (IC) 系列:- 標準包裝:1 系列:- 傳感范圍:20mT ~ 80mT 類型:旋轉 電源電壓:4.5 V ~ 5.5 V 電流 - 電源:15mA 電流 - 輸出（最大）:- 輸出類型:數字式，PWM，8.5 位串行 特點:可編程 工作溫度:-40°C ~ 150°C 封裝/外殼:20-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:20-SSOP 包裝:Digi-Reel® 其它名稱:AS5132-HSST-500DKR |
| A1145LLHLT-T | 功能描述:IC SWITCH HALL EFFECT UNI SOT-23 RoHS:是 類別:傳感器，轉換器 >> 磁性 - 霍爾效應，數字式開關，線性，羅盤 (IC) 系列:- 標準包裝:1 系列:- 傳感范圍:20mT ~ 80mT 類型:旋轉 電源電壓:4.5 V ~ 5.5 V 電流 - 電源:15mA 電流 - 輸出（最大）:- 輸出類型:數字式，PWM，8.5 位串行 特點:可編程 工作溫度:-40°C ~ 150°C 封裝/外殼:20-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:20-SSOP 包裝:Digi-Reel® 其它名稱:AS5132-HSST-500DKR |
發布緊急采購，3分鐘左右您將得到回復。