- 您現在的位置：買賣IC網 > PDF目錄375097 > A1141EUA (Allegro MicroSystems, Inc.) Sensitive Two-Wire Chopper-Stabilized Unipolar Hall-Effect Switches PDF資料下載
參數資料
| 型號： | A1141EUA |
| 廠商： | Allegro MicroSystems, Inc. |
| 英文描述： | Sensitive Two-Wire Chopper-Stabilized Unipolar Hall-Effect Switches |
| 中文描述： | 敏感的兩線斬波穩定單極霍爾效應開關 |
| 文件頁數： | 8/11頁 |
| 文件大?。?/td> | 393K |
| 代理商： | A1141EUA |
8
A1140-DS
Worcester, Massachusetts 01615-0036 (508) 853-5000
www.allegromicro.com
115 Northeast Cutoff, Box 15036
Allegro MicroSystems, Inc.
Sensitive Two-Wire Chopper-Stabilized Unipolar Hall Effect Switches
A1140/41/42/43
Application Information
For additional general application information, visit the Allegro
MicroSystems Web site at www. allegromicro.com.
GND
A114x
VCC
V+
0.01 uF
A
B
B
GND
ECU
Package UA Only
A
B
Maximum separation 5 mm
R
SENSE
C
BYP
Figure 3. Typical application circuit
Typical Application Circuit
The A114x family of devices must be protected by an external
bypass capacitor, C
BYP
, connected between the supply, VCC,
and the ground, GND, of the device. C
BYP
reduces both external
noise and the noise generated by the chopper-stabilization func-
tion. As shown in
fi
gure 3, a 0.01 μF capacitor is typical.
Installation of C
BYP
must ensure that the traces that connect it to
the A114x pins are no greater than 5 mm in length.
All high-frequency interferences conducted along the supply
lines are passed directly to the load through C
BYP
, and it serves
only to protect the A114x internal circuitry. As a result, the load
ECU (electronic control unit) must have suf
fi
cient protection,
other than C
BYP
, installed in parallel with the A114x.
A series resistor on the supply side, R
S
(not shown), in combi-
nation with C
BYP
, creates a
fi
lter for EMI pulses. (Additional
information on EMC is provided on the Allegro MicroSystems
Web site.)
When determining the minimum V
CC
requirement of the A114x
device, the voltage drops across R
S
and the ECU sense resistor,
R
SENSE
, must be taken into consideration. The typical value for
R
SENSE
is approximately 100
.
相關PDF資料 |
PDF描述 |
|---|---|
| A1141LLH | Sensitive Two-Wire Chopper-Stabilized Unipolar Hall-Effect Switches |
| A1142LUA | Sensitive Two-Wire Chopper-Stabilized Unipolar Hall-Effect Switches |
| A1143ELH | Sensitive Two-Wire Chopper-Stabilized Unipolar Hall-Effect Switches |
| A1140EUATI-T4 | Sensitive Two-Wire Chopper-Stabilized Unipolar Hall Effect Switches |
| A1140LUATI-T4 | Sensitive Two-Wire Chopper-Stabilized Unipolar Hall Effect Switches |
相關代理商/技術參數 |
參數描述 |
|---|---|
| A1141EUATI-T4 | 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:Sensitive Two-Wire Chopper-Stabilized Unipolar Hall Effect Switches |
| A1141LLH | 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:Sensitive Two-Wire Chopper-Stabilized Unipolar Hall-Effect Switches |
| A1141LUA | 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:Sensitive Two-Wire Chopper-Stabilized Unipolar Hall-Effect Switches |
| A1141LUATI-T4 | 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:Sensitive Two-Wire Chopper-Stabilized Unipolar Hall Effect Switches |
| A1141U2N2NZNQ | 功能描述:旋鈕開關 SP 90 DEG. 2 POS RoHS:否 制造商:C&K Components 位置數量:5 卡片組數量: 每卡片組極數:2 電流額定值:250 mA 電壓額定值:125 V 指數角: 觸點類型: 觸點形式:DPST 端接類型:Solder 安裝類型:Panel 觸點電鍍:Silver |
發布緊急采購，3分鐘左右您將得到回復。