參數資料
型號: 950810YFLF-T
廠商: INTEGRATED DEVICE TECHNOLOGY INC
元件分類: 時鐘產生/分配
英文描述: 200 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO56
封裝: 0.300 INCH, LEAD FREE, MO-118, SSOP-56
文件頁數: 2/19頁
文件大?。?/td> 202K
代理商: 950810YFLF-T
10
ICS950810
0472F—01/12/04
1.
The ICS clock generator is a slave/receiver, I
2C component. It can read back the data stored in the latches for
verification. Read-Back will support Intel PIIX4 "Block-Read" protocol.
2.
The data transfer rate supported by this clock generator is 100K bits/sec or less (standard mode)
3.
The input is operating at 3.3V logic levels.
4.
The data byte format is 8 bit bytes.
5.
To simplify the clock generator I
2C interface, the protocol is set to use only "Block-Writes" from the controller. The
bytes must be accessed in sequential order from lowest to highest byte with the ability to stop after any complete
byte has been transferred. The Command code and Byte count shown above must be sent, but the data is ignored
for those two bytes. The data is loaded until a Stop sequence is issued.
6.
At power-on, all registers are set to a default condition, as shown.
General I
2C serial interface information
The information in this section assumes familiarity with I
2C programming.
For more information, contact ICS for an I
2C programming application note.
How to Write:
Controller (host) sends a start bit.
Controller (host) sends the write address D2
(H)
ICS clock will acknowledge
Controller (host) sends a dummy command code
ICS clock will acknowledge
Controller (host) sends a dummy byte count
ICS clock will acknowledge
Controller (host) starts sending first byte (Byte 0)
through byte 5
ICS clock will acknowledge each byte one at a time.
Controller (host) sends a Stop bit
How to Read:
Controller (host) will send start bit.
Controller (host) sends the read address D3
(H)
ICS clock will acknowledge
ICS clock will send the byte count
Controller (host) acknowledges
ICS clock sends first byte (Byte 0) through byte 6
Controller (host) will need to acknowledge each byte
Controller (host) will send a stop bit
Notes:
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D2(H)
ACK
Dummy Command Code
ACK
Dummy Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Stop Bit
How to Write:
Controller (Host)
ICS (Slave/Receiver)
Start Bit
Address
D3(H)
ACK
Byte Count
ACK
Byte 0
ACK
Byte 1
ACK
Byte 2
ACK
Byte 3
ACK
Byte 4
ACK
Byte 5
ACK
Byte 6
ACK
Stop Bit
How to Read:
相關PDF資料
PDF描述
950810YG-T 200 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO56
08056C103JA79A Circular Connector; MIL SPEC:MIL-C-5015; Body Material:Metal; Series:GT; No. of Contacts:30; Connector Shell Size:32; Connecting Termination:Solder; Circular Shell Style:Box Mount Receptacle; Body Style:Straight
950811YGT 200 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO56
950811YGLFT 200 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO56
08056C103JAT2A General Specifications
相關代理商/技術參數
參數描述
950811 制造商:Weidmuller 功能描述:NEXT 50/35/16,4GP,ST,ZINC -EA - Bulk
950811-000 功能描述:熱收縮管和套管 RoHS:否 制造商:3M Electronic Specialty 類型:Tubing 材料:Polyolefin, Flexible 顏色:Clear 最低收縮溫度:+ 100 C 恢復直徑: 長度:100 ft 內徑:1.5 in 收縮率:2:1
9508113 制造商:Molex 功能描述:
950811AFLF 制造商:Integrated Device Technology Inc 功能描述:PLL Frequency Generator Dual 56-Pin SSOP Tube 制造商:Integrated Device Technology Inc 功能描述:PLL FREQ GENERATOR DUAL 56SSOP - Bulk
950811AGLF 制造商:Integrated Device Technology Inc 功能描述:PLL Frequency Generator Dual 56-Pin TSSOP Tube 制造商:Integrated Device Technology Inc 功能描述:PLL FREQ GENERATOR DUAL 56TSSOP - Rail/Tube