- 您現在的位置：買賣IC網 > PDF目錄24813 > 935263511026 (NXP SEMICONDUCTORS) SPECIALTY TELECOM CIRCUIT, UUC13 PDF資料下載
參數資料
| 型號： | 935263511026 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 通信及網絡 |
| 英文描述： | SPECIALTY TELECOM CIRCUIT, UUC13 |
| 封裝： | DIE-13 |
| 文件頁數： | 27/29頁 |
| 文件大小： | 236K |
| 代理商： | 935263511026 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁
2000 Mar 28
7
Philips Semiconductors
Product specication
Gigabit Ethernet/Fibre Channel
transimpedance amplier
TZA3043; TZA3043B
AGC
The TZA3043 transimpedance amplifier can handle input
currents from 1
A to 1.5 mA. This means a dynamic
range of 63 dB. At low input currents, the transimpedance
must be high to get enough output voltage, and the noise
should be low enough to guaranty minimum bit error rate.
At high input currents however, the transimpedance
should be low to avoid pulse width distortion. This means
that the gain of the amplifier has to vary depending on the
input signal level to handle such a wide dynamic range.
This is achieved in the TZA3043 by implementing an
Automatic Gain Control (AGC) loop. The AGC loop
consists of a peak detector, a hold capacitor and a gain
control circuit.
The peak amplitude of the signal is detected by the peak
detector and it is stored on the hold capacitor. The voltage
over the hold capacitor is compared to a threshold level.
The threshold level is set to 25
A (p-p) input current. AGC
becomes active only for input signals larger than the
threshold level.
It is disabled for smaller signals. The transimpedance is
then at its maximum value (8.3 k
differential).
When AGC is active, the feedback resistor of the
transimpedance amplifier is reduced to keep the output
voltage constant. The transimpedance is regulated from
8.3 k
at low currents (I < 30 A) to 1 k at high currents
(I < 500
A). Above 500 A the transimpedance is at its
minimum and can not be reduced further but the front-end
remains linear until input currents of 1.5 mA.
The upper part of Fig.9 shows the output voltages of the
TZA3043 (OUT and OUTQ) as a function of the DC input
current. In the lower part, the difference of both voltages is
shown. It can be seen from the figure that the output
changes linearly up to 25
A input current where AGC
becomes active. From this point on, AGC tries to keep the
differential output voltage constant around 200 mV for
medium range input currents (input currents <200
A).
The AGC can not regulate any more above 500
A input
current and the output voltage rises again with the input
current.
handbook, full pagewidth
0
600
400
200
MGU105
1102
10
(1)
(2)
(3)
Ii (A)
Vo
(V)
Vo(dif)
(mV)
103
104
3.1
3.3
3.7
3.5
3.9
VCC = 5 V
VOUT
VOUTQ
Fig.9 AGC characteristics.
Vo(dif) =VOUT VOUTQ.
(1) VCC =3V.
(2) VCC = 3.3 V.
(3) VCC =5V.
相關PDF資料 |
PDF描述 |
|---|---|
| 935263510112 | SPECIALTY TELECOM CIRCUIT, PDSO8 |
| 08-130150-01 | OUTLINE EXTENDED PFC MINI 1/RU |
| 08-130150-01-A1 | OUTLINE EXTENDED PFC MINI 1/RU |
| 935264068118 | DUAL 2 LINE TO 1 LINE MULTIPLEXER, TRUE OUTPUT, PDSO14 |
| 935268471118 | 2 LINE TO 1 LINE MULTIPLEXER, TRUE OUTPUT, PDSO14 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 935264217557 | 制造商:NXP Semiconductors 功能描述:SUB ONLY IC |
| 935267356112 | 制造商:NXP Semiconductors 功能描述:IC TEA1507PN |
| 935268081112 | 制造商:NXP Semiconductors 功能描述:SUB ONLY IC |
| 935268721125 | 制造商:NXP Semiconductors 功能描述:Buffer/Line Driver 1-CH Non-Inverting 3-ST CMOS 5-Pin TSSOP T/R |
| 935269304128 | 制造商:ST-Ericsson 功能描述:IC AUDIO CODEC W/TCH SCRN 48LQFP |
發布緊急采購，3分鐘左右您將得到回復。