- 您現在的位置：買賣IC網 > PDF目錄36217 > 90E22PYGI (INTEGRATED DEVICE TECHNOLOGY INC) SPECIALTY ANALOG CIRCUIT, PDSO28 PDF資料下載
參數資料
| 型號： | 90E22PYGI |
| 廠商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分類： | 模擬信號調理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, PDSO28 |
| 封裝： | GREEN, SSOP-28 |
| 文件頁數： | 5/54頁 |
| 文件大小： | 610K |
| 代理商： | 90E22PYGI |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁
90E21/22/23/24
SINGLE-PHASE HIGH-PERFORMANCE WIDE-SPAN ENERGY METERING IC
Functional Description
13
March 22, 2011
3.4
N LINE METERING AND ANTI-TAMPERING
3.4.1
METERING MODE AND L/N LINE CURRENT SAMPLING
GAIN CONFIGURATION
The 90E23 and 90E24 have two current sampling circuits with N line
metering and anti-tampering functions. The MMD1 and MMD0 pins are
used to configure the metering mode. Refer to Table-7.
The 90E23 and 90E24 have two current sampling circuits with differ-
ent gain configurations. L line gain can be 1, 4, 8, 16 and 24, and N line
gain can be 1, 2 and 4. The configuration is made by the MMode register
(2BH). Generally L line can be sampled over shunt resistor or CT. N line
can be sampled over CT for isolation consideration. Note that Rogowski
coil is not supported.
3.4.2
ANTI-TAMPERING MODE
Threshold
In anti-tampering mode, the power difference threshold between L
line and N line can be: 1%, 2%,... 12%, 12.5%, 6.25%, 3.125% and
1.5625%, altogether 16 choices. The configuration is made by the
Pthresh[3:0] bits (MMode, 2BH) and the default value is 3.125%. The
threshold is applicable for active energy. The metering line of the reac-
tive energy follows that of the active energy.
Compare Method
In anti-tampering mode, the compare method is as follows:
If current metering line is L line and
N line is switched as the metering line, otherwise L line keeps as the
metering line.
If current metering line is N line and
L line is switched as the metering line, otherwise N line keeps as the
metering line.
This method can achieve hysteresis around the threshold automati-
cally. L line is employed after reset by default.
Special Treatment at Low Power
When power is low, general factors such as the quantization error or
calibration difference between L line and N line might cause the power
difference to be exceeded. To ensure L line and N line to start up nor-
mally, special treatment as follows is adopted:
The line with higher power is selected as the metering line when both
L line and N line power are lower than 8 times of the startup power but
higher than the startup power.
Table-7 Metering Mode
MMD1 MMD0
Metering Mode
CFx (CF1 or CF2) Output
00
Anti-tampering
Mode
(larger power)
CFx represents the larger energy
line. Refer to section 3.4.2.
0
1
L Line Mode (fixed L line)
CFx represents L line energy all
the time.
10
L+N Mode (applicable for
single-phase
three-wire
system)
CFx represents the arithmetic
sum of L line and N line energy
11
Flexible Mode (line speci-
fied by the LNSel bit
(MMode, 2BH))
CFx represents energy of the
specified line.
Threshold
100%
*
Power
Active
Line
L
Power
Active
Line
L
-
Power
Active
Line
N
>
Threshold
100%
*
Power
Active
Line
N
Power
Active
Line
N
-
Power
Active
Line
L
>
相關PDF資料 |
PDF描述 |
|---|---|
| 90E21PYGI | SPECIALTY ANALOG CIRCUIT, PDSO28 |
| 90E9AA | 1 FUNCTIONS, 90 MHz, 4.5 kHz BW(delta f), MONOLITHIC CRYSTAL FILTER |
| 90EEWI | ELECTRIC FUSE, 90A, 690VAC, 690VDC, 200000A (IR), INLINE/HOLDER |
| 90EEW | ELECTRIC FUSE, 90A, 690VAC, 690VDC, 200000A (IR), INLINE/HOLDER |
| 90EWI | ELECTRIC FUSE, 90A, 690VAC, 690VDC, 200000A (IR), INLINE/HOLDER |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 90E22PYGI8 | 功能描述:電流和電力監控器、調節器 RoHS:否 制造商:STMicroelectronics 產品:Current Regulators 電源電壓-最大:48 V 電源電壓-最小:5.5 V 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:HPSO-8 封裝:Reel |
| 90E23PYGI | 功能描述:電流和電力監控器、調節器 RoHS:否 制造商:STMicroelectronics 產品:Current Regulators 電源電壓-最大:48 V 電源電壓-最小:5.5 V 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:HPSO-8 封裝:Reel |
| 90E23PYGI8 | 功能描述:電流和電力監控器、調節器 RoHS:否 制造商:STMicroelectronics 產品:Current Regulators 電源電壓-最大:48 V 電源電壓-最小:5.5 V 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:HPSO-8 封裝:Reel |
| 90E24PYGI | 功能描述:電流和電力監控器、調節器 RoHS:否 制造商:STMicroelectronics 產品:Current Regulators 電源電壓-最大:48 V 電源電壓-最小:5.5 V 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:HPSO-8 封裝:Reel |
| 90E24PYGI8 | 功能描述:電流和電力監控器、調節器 RoHS:否 制造商:STMicroelectronics 產品:Current Regulators 電源電壓-最大:48 V 電源電壓-最小:5.5 V 工作溫度范圍:- 40 C to + 150 C 安裝風格:SMD/SMT 封裝 / 箱體:HPSO-8 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。