參數資料
型號: 74LVC1G57GN,132
廠商: NXP Semiconductors
文件頁數: 7/15頁
文件大?。?/td> 0K
描述: IC CONFIG MULTI-FUNC GATE 6XSON
標準包裝: 5,000
系列: *
CS35L01/03
18
DS909F1
5.3.3
Output Filter Power Dissipation Considerations
In systems without inductive series elements like inductors or ferrite beads, power losses in the output
filter are equal to the switching losses that occur in the system due to the cyclical charging and discharging
of capacitors connected to the amplifier outputs. In systems that require an inductive series element, con-
ducted losses also occurs due to the series impedance added to the output path.
5.3.3.1
Conduction Losses for All modes of Operation
For all modes of operation (SD, FSD, HD, and FHD) of the CS35L01/03, the conduction losses are gov-
erned by the equation:
Where:
P
= Power dissipated in the series impedance.
I
= RMS AC output current
Z
= impedance of the series element at the frequency of the AC current
This equation neglects any series impedances presented by the PCB traces or speaker wires in the output
path.
5.3.3.2
Switching Losses in SD/FSD Mode
Switching losses in SD/FSD Mode are governed by the equation
Where:
P
= Power dissipated in the capacitor (neglecting parasites).
C
= Value of filtering capacitor
V
= Peak voltage developed across the capacitor
f
= Switching frequency of the outputs
These calculations are straightforward, as the peak voltage is simply the voltage level attached to VBATT,
the capacitor is the value of capacitor that has been added for filtering (neglecting parasitic board capac-
itances), and the frequency is 192 kHz or 76 kHz for SD and FSD, respectively.
5.3.3.3
Switching Losses in HD/FHD.
Many factors affect the switching losses when the device is operated in HD/FHD mode. These factors in-
clude the frequency of the content being amplified, the voltage level of VBATT, and the amplitude of the
output signal will factor into both the voltage presented across the capacitors and the frequency at which
the capacitors are charged or discharged.
Static signals (i.e. sine waves at a fixed amplitude) are easier to consider than are dynamic signals (i.e.
musical content), as they are governed by the same equation as that listed in Section 5.3.3.1 and Section
5.3.3.2 on page 18. Modifications to that equation are limited to the voltage term (V) and the frequency
term (f), depending on whether the static input signal amplitude is causing the output devices to switch at
76 kHz or 192 kHz, and to operate off of the VBATT supply or off of the internally generated LDO.
PI2Z
=
P
1
2
---CV2f
=
相關PDF資料
PDF描述
3386Y-1-204LF TRIMMER 200K OHM 0.5W TH
3386Y-1-203LF TRIMMER 20K OHM 0.5W TH
3386Y-1-202LF TRIMMER 2K OHM 0.5W TH
W2H11A4718AT1F CAP FEEDTHRU 470PF 100V NP0 0805
LD6806F/27P,115 IC REG LDO 200MA 2.7V 6XSON
相關代理商/技術參數
參數描述
74LVC1G57GS,132 功能描述:轉換 - 電壓電平 18ns 5.5V 250mW RoHS:否 制造商:Micrel 類型:CML/LVDS/LVPECL to LVCMOS/LVTTL 傳播延遲時間:1.9 ns 電源電流:14 mA 電源電壓-最大:3.6 V 電源電壓-最小:3 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:MLF-8
74LVC1G57GV 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Low-power configurable multiple function gate
74LVC1G57GV,125 功能描述:邏輯門 3.3V LP CONFIG GATE RoHS:否 制造商:Texas Instruments 產品:OR 邏輯系列:LVC 柵極數量:2 線路數量(輸入/輸出):2 / 1 高電平輸出電流:- 16 mA 低電平輸出電流:16 mA 傳播延遲時間:3.8 ns 電源電壓-最大:5.5 V 電源電壓-最小:1.65 V 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:DCU-8 封裝:Reel
74LVC1G57GV-G 功能描述:邏輯門 3.3V LP CONFIG GATE RoHS:否 制造商:Texas Instruments 產品:OR 邏輯系列:LVC 柵極數量:2 線路數量(輸入/輸出):2 / 1 高電平輸出電流:- 16 mA 低電平輸出電流:16 mA 傳播延遲時間:3.8 ns 電源電壓-最大:5.5 V 電源電壓-最小:1.65 V 最大工作溫度:+ 125 C 安裝風格:SMD/SMT 封裝 / 箱體:DCU-8 封裝:Reel
74LVC1G57GV-Q100H 功能描述:Configurable Multiple Function Configurable 1 Circuit 3 Input 6-TSOP 制造商:nxp semiconductors 系列:汽車級,AEC-Q100,74LVC 包裝:帶卷(TR) 零件狀態:有效 邏輯類型:可配置多功能 電路數:1 輸入數:3 施密特觸發器輸入:是 輸出類型:單端 電流 - 輸出高,低:32mA,32mA 電壓 - 電源:1.65 V ~ 5.5 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SC-74,SOT-457 供應商器件封裝:6-TSOP 標準包裝:3,000