參數資料
型號： 73M2901CE-IGVR/F
廠商： Maxim Integrated Products
文件頁數： 23/27頁
文件大?。?/td> 0K
描述： IC MODEM 3.3V V.22BIS 32-TQFP
產品培訓模塊： Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
標準包裝： 2,000
數據格式： V.21，V.22，V.23，Bell 103，Bell 212A
波特率： 300 ~ 9.6k
電源電壓： 2.7 V ~ 3.6 V
安裝類型： 表面貼裝
封裝/外殼： 32-TQFP
供應商設備封裝： 32-TQFP
包裝： 帶卷 (TR)
DS_2901CE_031
73M2901CE Data Sheet
Rev. 3.4
5
RING is used to inform the 73M2901CE that the external DAA circuitry or ring energy detector has
detected a ring signal. It will go active when each “RING” message is sent on RXD.
In addition, sending any character on the TXD line also generates an internal interrupt.
1.5
Crystal Oscillator
The Teridian 73M2901CE single chip modem can use an external 11.0592 MHz reference clock or can
generate a clock using only a crystal and two capacitors. If an external clock is used, it should be applied
to the OSCIN pin.
1.5.1
Specifying a Crystal
The manufacturer of a crystal resonator verifies its frequency of oscillation in a test set-up, but to ensure
that the same frequency is obtained in the application, the circuit conditions must be the same.
The Teridian 73M2901CE modem requires a parallel mode (anti-resonant) crystal, the important
specifications of which are as follows:
Mode:
Parallel (anti-resonant)
Frequency:
11.0592 MHz
Frequency tolerance:
±50 ppm at initial temperature
Temperature drift:
An additional ±50 ppm over full range
Load capacitance:
18 pF to 22 pF
ESR:
75
max
Drive level:
Less than 1 mW
The peak voltage level of the oscillator should be checked to assure it will not violate the maximum
voltage levels allowed on the oscillator pins. A resistor in series with the crystal can be used, if
necessary, to reduce the oscillator’s peak voltage levels.
Crystals with low ESRs may oscillate at higher than specified voltage levels.
1.6
Reset
A reset is accomplished by holding the RESET pin high. To ensure a proper power-on reset, the reset
pin must be held high for a minimum of 3
s. At power on, the voltage at VPD, VPA, and RESET must
come up at the same time for a proper reset.
The signals
DCD, CTS and DSR will be held inactive for 25 ms, acknowledging the reset operation, within
a 250 ms time window after the reset-triggering event. The 73M2901CE is ready for operation after the
250 ms window and/or after the signals
DCD, CTS and DSR become active.
1.7
Asynchronous and Synchronous Serial Data Interface
The serial data interface consists of the TXD and RXD data paths (LSB shifted in and out first) and the
TXCLK and RXCLK serial synchronous clock outputs associated with the data pins;
CTS/RTS flow
control;
DCD, DSR and DTR. In asynchronous mode, the data is passed at the bit rate (tolerance is +1%,
-2.5%).
相關PDF資料
PDF描述
73S1209F-68IMR/F/P IC SMART CARD READER PROG 68-QFN
73S1210F-68IMR/F/P IC SMART CARD READER PROG 68-QFN
73S1215F-68IMR/F/P IC SMART CARD READER PROG 68-QFN
73S1217F-68IMR/F/P IC SMART CARD READER PROG 68-QFN
73S1217F-68MR/F/PE IC SOC SMART CARD READER 68QFN
相關代理商/技術參數
參數描述
73M2901CE-IM/F 功能描述:電信線路管理 IC V.22bis Single-Chip Modem RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
73M2901CE-IM/F1 功能描述:電信線路管理 IC RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
73M2901CE-IMR/F 功能描述:電信線路管理 IC V.22bis Single-Chip Modem RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
73M2901CE-IMR/F1 功能描述:電信線路管理 IC RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray
73M2901CL 制造商:TDK 制造商全稱:TDK Electronics 功能描述:V.22 BIS SINGLE CHIP MODEM
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*