- 您現在的位置：買賣IC網 > PDF目錄1887 > 73M1822-IM/F (Maxim Integrated Products)MICRODAA VOICE DATA/FAX 42-QFN PDF資料下載
參數資料
| 型號： | 73M1822-IM/F |
| 廠商： | Maxim Integrated Products |
| 文件頁數： | 68/82頁 |
| 文件大?。?/td> | 0K |
| 描述： | MICRODAA VOICE DATA/FAX 42-QFN |
| 產品培訓模塊： | Lead (SnPb) Finish for COTS Obsolescence Mitigation Program |
| 標準包裝： | 260 |
| 系列： | MicroDAA™ |
| 應用： | 傳真，調制解調器，尋呼機 |
| 接口： | 串行 |
| 電源電壓： | * |
| 封裝/外殼： | 42-VFQFN 裸露焊盤 |
| 供應商設備封裝： | 42-QFN（8x8） |
| 包裝： | 管件 |
| 安裝類型： | 表面貼裝 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁當前第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁
73M1822/73M1922 Data Sheet
DS_1x22_017
70
Rev. 1.6
12 Line Sensing and Status
12.1 Auxiliary A/D Converter
An 8-bit auxiliary A/D converter integrated in the 73M1x22 provides line monitoring and sensing capabilities.
The A/D converter input signals are connected to the RGP and RGN pins of the device. It is possible to use
this A/D converter to sample signals unrelated to PSTN DAA functions. However, in this application, it is
necessary to isolate the input signal with optical or other means since the 73M1x22 is connected directly to
the PSTN. Under normal conditions, RGP and RGN are AC coupled to the line through high voltage (250
V) capacitors.
Through the use of this auxiliary A/D converter, the following line status sensing features are supported by
the 73M1x22:
Ring detection.
PSTN line already in use detection.
Off-hook detection that a parallel phone has been picked-up – parallel pick-up detection (PPU).
On-hook detection of DC loop voltage polarity reversals.
On-hook detection of Type II Caller ID.
12.2 Ring Detection
Ring Detection is provided through circuitry connected to the device pins RGP and RGN. Any large voltage
transition (ringing or line reversal) will be a source for the “Wake up” signal to the 73M1x22. Upon reception
of a wake-up signal, the 73M1x22 passes the detected signal to the host where it is to be qualified for
frequency and cadence (on and off timing of the ring tone bursts) as a valid ring signal.
12.3 Line In Use Detection (LIU)
If the 73M1x22 is preparing to go off-hook and dial, it is required to be aware whether the phone line is
already in use by another device. If the 73M1x22 determines that the phone line is presently in use, it can
avoid going off-hook and interrupting the call in progress. The timing of the 73M1x22 off-hook transition can
be delayed until the 73M1x22 determines that the phone line is available. LIU sensing is done at pin DCIN
with the Aux A/D.
12.4 Parallel Pick Up (PPU)
Parallel Pick Up is a means for the 73M1x22 to determine and notify a host in the case when the DAA is off-
hook and a second or parallel connected device during the course of a connection is also made to go off-
hook.
12.5 Polarity Reversal Detection
A third type of line sensing requirement is associated with Caller ID protocols found in Japan and some
European countries. In these countries, the Caller ID signals are sent prior to the start of normal ringing. A
polarity reversal is used to indicate to the 73M1x22 that transmission of Caller ID information is about to
begin. The detection of a polarity reversal takes place while the 73M1x22 is in the on-hook state.
12.6 Off-hook Detection of Caller ID Type II
It is also possible to receive Caller ID signals while the telephone is in use, referred to as Type II CID. This
requires the 73M1x12 to constantly monitor the line for signals, such as special in-band or CAS tones, while
the 73M1x22 is in the off-hook state. This is done through the normal receive path.
相關PDF資料 |
PDF描述 |
|---|---|
| 73M1866B-IM/F | MICRODAA SGL PCM HIGHWAY 42-QFN |
| 73M2901CE-IGVR/F | IC MODEM 3.3V V.22BIS 32-TQFP |
| 73S1209F-68IMR/F/P | IC SMART CARD READER PROG 68-QFN |
| 73S1210F-68IMR/F/P | IC SMART CARD READER PROG 68-QFN |
| 73S1215F-68IMR/F/P | IC SMART CARD READER PROG 68-QFN |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 73M1822-IMR/F | 功能描述:電信線路管理 IC MicroDAA w/Serial Interface RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| 73M1822-KEYCHN | 功能描述:網絡開發工具 Keychain Eval Module RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V |
| 73M1866B-IFX | 功能描述:電信線路管理 IC MicroDAA w/PCM Highway RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| 73M1866B-IM/F | 功能描述:電信線路管理 IC MicroDAA w/PCM Highway RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| 73M1866B-IMR/F | 功能描述:電信線路管理 IC MicroDAA w/PCM Highway RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。