Technical Data
14
354
01.2000
switching system
This low level switching element was designed for switching low
powers in electronic circuits. The mechanism assures reliable
switching of loads ranging from a few
μ
A/
μ
V up to 100 mA/42 VAC/
VDC.
Single-break momentary contact, as normally open or normally
closed with 4 independent points of contact. 2 momentary contacts
per switching element; combination of normally open and normally
closed is possible.
Special features are the long life, extremely short rebound time and
stable contact resistance.
material
actuator case
polyamide
material of contacts
gold-plated
switching element
polysulfone, heat-resistant and self-extinguishing
mechanical characteristics
actuating force
3-4 N
actuating torque
measured at the key or lever of the keylock- or selector switch: 2.5-
5.5 Ncm, depending on the number of switching elements
actuating travel
illuminated pushbutton :3 mm
switch actuator with 2 positions:
1 x ca. 42° deflection momentary action
1 x ca. 90° deflection maintained action
ambient air temperature
-25°C to +55°C
for indicators and illuminated pushbuttons mounted as a block ,
make sure the heat can escape freely
(as per DIN IEC 68-)
connection method
The universalterminalspermitthese unitsto be mountedon printed
circuit boards (PCB). These terminals can also be used as solder-
ing or plug-in terminals.
For these terminals we can also supply a plug-in base which, when
soldered on to the board, enables the switch to be plugged in.
soldering terminal:
max. wire diameter: 2 wires of 1 mm
max. wire cross-section of stranded cable: 2 x 0.75 mm
2
plug-in terminal: 2.0 x 0.5 mm
degree of protection
front as per IEC 529: IP 67
mechanical life
momentary action 5 mio. cycles of operation
maintained action 1 mio. cycles of operation
rebound time
Typ. < 100
μ
s
resistance to shock
(single impacts, semi-sinusoidal)
15 g for 11 ms as per IEC 512-4-3, IEC 68-2-27
actuator with Low Level switching element
storage temperature
-40°C to + 85°C
(as per DIN IEC 68-)
electrical characteristics
electric strength
2500 VAC, 50 Hz, 1 min. between all terminals and earth, as per IC
512-2-11.
electrostatic breakdown value
<= 15 KV (keylock switch)
protection class
II
switch rating
10
μ
A/100
μ
V to 100 mA at 42 VAC/VDC
volume resistance
starting value (initial) <= 50 m
buzzer system
system
Piezo disc
material
alarm buzzer case
polyamide
front cap
plastic: polyamide
metal: nickel-plated brass
sea-water proof
mechanical characteristics
ambient air temperature
-25°C to + 50°C
(as per DIN IEC 68-)
connection method
plug-in terminal 2.8 x 0.5 mm
degree of protection
IP 65 as per IEC 529
storage temperature
-25°C to + 50°C
(as per DIN IEC 68-)
electrical characteristics
frequency (tone)
ca.2.8 kHz continuous tone only
operation voltage/current
operation voltage:
operation current:
24 VDC ± 10%
<= 25 mA
sound pressure
95 db (A) ± 8 at a distance of 0.1 m
buzzer