參數資料
型號： 68HC705J5A
廠商： Motorola, Inc.
英文描述： 8-Bit Microcontroller Units (MCU).(8位微控制器)
中文描述： 8位微控制器單元（MCU）。（8位微控制器）
文件頁數： 36/106頁
文件大?。?/td> 1069K
代理商： 68HC705J5A
GENERAL RELEASE SPECIFICATION
July 16, 1999
MOTOROLA
5-2
RESETS
MC68HC05J5A
REV 2.1
5.1
EXTERNAL RESET (RESET)
The RESET pin is the only external source of a reset. This pin is connected to a
Schmitt trigger input gate to provide an upper and lower threshold voltage sepa-
rated by a minimum amount of hysteresis. This external reset occurs whenever
the RESET pin is pulled below the lower threshold and remains in reset until the
RESET pin rises above the upper threshold. This active low input will generate the
RST signal and reset the CPU and peripherals. This pin is also an output pin
whenever the LVR triggers an internal reset. Termination of the external RESET
input or the internal COP Watchdog reset or LVR are the only reset sources that
can alter the operating mode of the MCU.
NOTE
Activation of the RST signal is generally referred to as reset of the device, unless
otherwise specified.
5.2
INTERNAL RESETS
The four internally generated resets are the initial power-on reset function, the
COP Watchdog Timer reset, the illegal address detector reset and the low voltage
reset (LVR). Termination of the external RESET input or the internal COP Watch-
dog Timer or LVR are the only reset sources that can alter the operating mode of
the MCU. The other internal resets will not have any effect on the mode of opera-
tion when their reset state ends.
5.2.1 POWER-ON RESET (POR)
The internal POR is generated on power-up to allow the clock oscillator to stabi-
lize. The POR is strictly for power turn-on conditions and is not able to detect a
drop in the power supply voltage (brown-out). There is an oscillator stabilizing
delay after the oscillator becomes active. The delay time could be 224 or 4064 of
internal processor bus clock cycles (PH2) which is a mask option.
The POR will generate the RST signal which will reset the CPU. If any other reset
function is active at the end of this delay time, the RST signal will remain in the
reset condition until the other reset condition(s) end.
5.2.2 COMPUTER OPERATING PROPERLY RESET (COPR)
The internal COPR reset is generated automatically (if the COP is enabled) by a
time-out of the COP Watchdog Timer. This time-out occurs if the counter in the
COP Watchdog Timer is not reset (cleared) within a specific time by a software
reset sequence. The COP Watchdog Timer can be disabled by a mask option.
Refer to
Section 8.2
for more information on this time-out feature. COP reset also
forces the RESET pin low
相關PDF資料
PDF描述
68HRC05J5A 8-Bit Microcontroller Units (MCU).(8位微控制器)
68HRC705J5A 8-Bit Microcontroller Units (MCU).(8位微控制器)
68HC05K0 8-Bit Microcontroller Units (MCU).(8位微控制器)
68HC05PL4 8-Bit Microcontroller Units (MCU).(8位微控制器)
68HC05PL4B 8-Bit Microcontroller Units (MCU).(8位微控制器)
相關代理商/技術參數
參數描述
68HC705JB3 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:8-bit microcontroller units (MCUs)
68HC705JB4 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:68HC05JB4
68HC705JJ7 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification
68HC705JJ7_1 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification
68HC705JP7 制造商:FREESCALE 制造商全稱:Freescale Semiconductor, Inc 功能描述:General Release Specification
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*