參數資料
型號: 5962-9753701QHA
廠商: TEXAS INSTRUMENTS INC
元件分類: 運算放大器
英文描述: DUAL OP-AMP, 100 uV OFFSET-MAX, 4.7 MHz BAND WIDTH, CDFP10
封裝: CERAMIC, DFP-10
文件頁數: 13/38頁
文件大小: 867K
代理商: 5962-9753701QHA
TLC4501, TLC4501A, TLC4502, TLC4502A
FAMILY OF SELF-CALIBRATING (Self-Cal
)
PRECISION CMOS RAIL-TO-RAIL OUTPUT OPERATIONAL AMPLIFIERS
SLOS221B – MAY 1998 – REVISED APRIL 2001
20
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
D The TLC4502 is designed to operate with only a single 5-V power supply, have true differential inputs, and
remain in the linear mode with an input common-mode voltage of 0.
D The TLC4502 has a standard dual-amplifier pinout, allowing for easy design upgrades.
D Large differential input voltages can be easily accommodated and, as input differential-voltage protection
diodes are not needed, no large input currents result from large differential input voltage. Protection should
be provided to prevent the input voltages from going negative more than – 0.3 V at 25
°C. An input clamp
diode with a resistor to the device input terminal can be used for this purpose.
D For ac applications, where the load is capacitively coupled to the output of the amplifier, a resistor can be
used from the output of the amplifier to ground. This increases the class-A bias current and prevents
crossover distortion. Where the load is directly coupled, for example in dc applications, there is no crossover
distortion.
D Capacitive loads, which are applied directly to the output of the amplifier, reduce the loop stability margin.
Values of 500 pF can be accommodated using the worst-case noninverting unity-gain connection. Resistive
isolation should be considered when larger load capacitance must be driven by the amplifier.
The following typical application circuits emphasize operation on only a single power supply. When
complementary power supplies are available, the TLC4502 can be used in all of the standard operational
amplifier circuits. In general, introducing a pseudo-ground (a bias voltage of VI/2 like that generated by the
TLE2426) allows operation above and below this value in a single-supply system. Many application circuits
shown take advantage of the wide common-mode input-voltage range of the TLC4502, which includes ground.
In most cases, input biasing is not required and input voltages that range to ground can easily be
accommodated.
description of calibration procedure
To achieve high dc gain, large bandwidth, high CMRR and PSRR, as well as good output drive capability, the
TLC4502 is built around a 3-stage topology: two gain stages, one rail-to-rail, and a class-AB output stage. A
nested Miller topology is used for frequency compensation.
During the calibration procedure, the operational amplifier is removed from the signal path and both inputs are
tied to GND. Figure 35 shows a block diagram of the amplifier during calibration mode.
相關PDF資料
PDF描述
5962-9753701QPA DUAL OP-AMP, 100 uV OFFSET-MAX, 4.7 MHz BAND WIDTH, CDIP8
5962-9753702Q2A DUAL OP-AMP, 50 uV OFFSET-MAX, 4.7 MHz BAND WIDTH, CQCC20
5962-9753702QHA DUAL OP-AMP, 50 uV OFFSET-MAX, 4.7 MHz BAND WIDTH, CDFP10
5962-9753702QPA DUAL OP-AMP, 50 uV OFFSET-MAX, 4.7 MHz BAND WIDTH, CDIP8
5962-9755701HPX ISOLATION AMPLIFIER, 100 kHz BAND WIDTH, CDIP8
相關代理商/技術參數
參數描述
5962-9753701QPA 制造商:Texas Instruments 功能描述:OP Amp Dual GP R-R O/P ±3V/6V 8-Pin CDIP Tube
5962-9753702QHA 制造商:Texas Instruments 功能描述:OP Amp Dual GP R-R O/P ±3V/6V 10-Pin CFPAK Tube 制造商:Texas Instruments 功能描述:OP AMP DUAL GP R-R O/P 3V/6V 10CFPAK - Rail/Tube
5962-9754101QCA 制造商:Rochester Electronics LLC 功能描述: 制造商:Texas Instruments 功能描述:5962-9754101QCA, QUAD 2-IN POS-NAND BUFF - Rail/Tube
5962-9754101QDA 制造商:Texas Instruments 功能描述:NAND Gate 4-Element 2-IN Bipolar 14-Pin CFPAK Tube
5962-9754201Q2A 制造商:Texas Instruments 功能描述:Buffer/Line Driver 8-CH Non-Inverting 3-ST CMOS 20-Pin LCCC Tube 制造商:Rochester Electronics LLC 功能描述:- Bulk