參數資料
型號: 3EZ8.2D5RR1
廠商: ON SEMICONDUCTOR
元件分類: 參考電壓二極管
英文描述: 8.2 V, 1 W, SILICON, UNIDIRECTIONAL VOLTAGE REGULATOR DIODE, DO-41
封裝: PLASTIC, CASE 59-10, 2 PIN
文件頁數: 5/7頁
文件大小: 130K
代理商: 3EZ8.2D5RR1
3EZ4.3D5 Series
http://onsemi.com
5
APPLICATION NOTE
Since the actual voltage available from a given zener
diode is temperature dependent, it is necessary to determine
junction temperature under any set of operating conditions
in order to calculate its value. The following procedure is
recommended:
Lead Temperature, T
L
, should be determined from:
T
L
=
LA
P
D
+ T
A
LA
is the lead-to-ambient thermal resistance (
°
C/W) and
P
D
is the power dissipation. The value for
LA
will vary and
depends on the device mounting method.
LA
is generally
30
40
°
C/W for the various clips and tie points in common
use and for printed circuit board wiring.
The temperature of the lead can also be measured using a
thermocouple placed on the lead as close as possible to the
tie point. The thermal mass connected to the tie point is
normally large enough so that it will not significantly
respond to heat surges generated in the diode as a result of
pulsed operation once steady-state conditions are achieved.
Using the measured value of T
L
, the junction temperature
may be determined by:
T
J
= T
L
+ T
JL
T
JL
is the increase in junction temperature above the lead
temperature and may be found from Figure 2 for a train of
power pulses (L = 3/8 inch) or from Figure 10 for dc power.
T
JL
=
JL
P
D
For worst-case design, using expected limits of I
Z
, limits
of P
D
and the extremes of T
J
( T
J
) may be estimated.
Changes in voltage, V
Z
, can then be found from:
V =
VZ
T
J
VZ
, the zener voltage temperature coefficient, is found
from Figures 5 and 6.
Under high power-pulse operation, the zener voltage will
vary with time and may also be affected significantly by the
zener resistance. For best regulation, keep current
excursions as low as possible.
Data of Figure 2 should not be used to compute surge
capability. Surge limitations are given in Figure 3. They are
lower than would be expected by considering only junction
temperature, as current crowding effects cause temperatures
to be extremely high in small spots resulting in device
degradation should the limits of Figure 3 be exceeded.
相關PDF資料
PDF描述
3KASMC36A-E3/57T 3000 W, UNIDIRECTIONAL, SILICON, TVS DIODE, DO-214AB
3KASMC10-E3/9AT 3000 W, UNIDIRECTIONAL, SILICON, TVS DIODE, DO-214AB
3KASMC10A-E3/57T 3000 W, UNIDIRECTIONAL, SILICON, TVS DIODE, DO-214AB
3KASMC12-E3/57T 3000 W, UNIDIRECTIONAL, SILICON, TVS DIODE, DO-214AB
3KASMC14A-E3/57T 3000 W, UNIDIRECTIONAL, SILICON, TVS DIODE, DO-214AB
相關代理商/技術參數
參數描述
3EZ82DE3/TR12 制造商:Microsemi Corporation 功能描述:DIODE ZENER 3W 82V 20% DO-41
3EZ82DE3/TR8 制造商:Microsemi Corporation 功能描述:3.0W, VZ = 82V, ? 20% - Tape and Reel 制造商:Microsemi Corporation 功能描述:DIODE ZENER 3W 82V 20% DO-41
3EZ87 制造商:PANJIT 制造商全稱:Pan Jit International Inc. 功能描述:GLASS PASSIVATED JUNCTION SILICON ZENER DIODES
3EZ9.1 制造商:DIOTEC 制造商全稱:Diotec Semiconductor 功能描述:Silicon-Power-Z-Diodes (non-planar technology)
3EZ9.1D/TR12 制造商:Microsemi Corporation 功能描述:3.0W, VZ = 9.1V, ? 20% - Tape and Reel 制造商:Microsemi Corporation 功能描述:DIODE ZENER 3W 9.1V 20% DO-41